ترغب بنشر مسار تعليمي؟ اضغط هنا

Characterization of the optical properties of the buried contact of the JWST MIRI Si:As infrared blocked impurity band detectors

103   0   0.0 ( 0 )
 نشر من قبل Ioannis Argyriou
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English
 تأليف Ioannis Argyriou




اسأل ChatGPT حول البحث

The Mid-Infrared Instrument MIRI on-board the James Webb Space Telescope uses three Si:As impurity band conduction detector arrays. MIRI medium resolution spectroscopic measurements (R$sim$3500-1500) in the 5~$mu m$ to 28~$mu m$ wavelength range show a 10-30% modulation of the spectral baseline; coherent reflections of infrared light within the Si:As detector arrays result in fringing. We quantify the shape and impact of fringes on spectra of optical sources observed with MIRI during ground testing and develop an optical model to simulate the observed modulation. We use our optical model in conjunction with the MIRI spectroscopic data to show that the properties of the buried contact inside the MIRI Si:As detector have a significant effect on the fringing behavior.



قيم البحث

اقرأ أيضاً

The Mid Infra Red Instrument (MIRI) is one of the four instruments onboard the James Webb Space Telescope (JWST), providing imaging, coronagraphy and spectroscopy over the 5-28 microns band. To verify the optical performance of the instrument, extens ive tests were performed at CEA on the flight model (FM) of the Mid-InfraRed IMager (MIRIM) at cryogenic temperatures and in the infrared. This paper reports on the point spread function (PSF) measurements at 5.6 microns, the shortest operating wavelength for imaging. At 5.6 microns the PSF is not Nyquist-sampled, so we use am original technique that combines a microscanning measurement strategy with a deconvolution algorithm to obtain an over-resolved MIRIM PSF. The microscanning consists in a sub-pixel scan of a point source on the focal plane. A data inversion method is used to reconstruct PSF images that are over-resolved by a factor of 7 compared to the native resolution of MIRI. We show that the FWHM of the high-resolution PSFs were 5-10% wider than that obtained with Zemax simulations. The main cause was identified as an out-of-specification tilt of the M4 mirror. After correction, two additional test campaigns were carried out, and we show that the shape of the PSF is conform to expectations. The FWHM of the PSFs are 0.18-0.20 arcsec, in agreement with simulations. 56.1-59.2% of the total encircled energy (normalized to a 5 arcsec radius) is contained within the first dark Airy ring, over the whole field of view. At longer wavelengths (7.7-25.5 microns), this percentage is 57-68%. MIRIM is thus compliant with the optical quality requirements. This characterization of the MIRIM PSF, as well as the deconvolution method presented here, are of particular importance, not only for the verification of the optical quality and the MIRI calibration, but also for scientific applications.
Arsenic doped back illuminated blocked impurity band (BIBIB) silicon detectors have advanced near and mid-IR astronomy for over thirty years; they have high quantum efficiency (QE), especially at wavelengths longer than 10 $mu$m, and a large spectral range. Their radiation hardness is also an asset for space based instruments. Three examples of Si:As BIBIB arrays are used in the Mid-InfraRed Instrument (MIRI) of the James Webb Space Telescope (JWST), observing between 5 and 28 $mu$m. In this paper, we analyze the parameters leading to high quantum efficiency (up to $sim$ 60%) for the MIRI devices between 5 and 10 $mu$m. We also model the cross-shaped artifact that was first noticed in the 5.7 and 7.8 $mu$m Spitzer/IRAC images and has since also been imaged at shorter wavelength ($le 10~mu$m) laboratory tests of the MIRI detectors. The artifact is a result of internal reflective diffraction off the pixel-defining metallic contacts to the readout detector circuit. The low absorption in the arrays at the shorter wavelengths enables photons diffracted to wide angles to cross the detectors and substrates multiple times. This is related to similar behavior in other back illuminated solid-state detectors with poor absorption, such as conventional CCDs operating near 1 $mu$m. We investigate the properties of the artifact and its dependence on the detector architecture with a quantum-electrodynamic (QED) model of the probabilities of various photon paths. Knowledge of the artifact properties will be especially important for observations with the MIRI LRS and MRS spectroscopic modes.
The Mid-Infrared instrument (MIRI) on board the James Webb Space Telescope will perform the first ever characterization of young giant exoplanets observed by direct imaging in the 5-28 microns spectral range. This wavelength range is key for both det ermining the bolometric luminosity of the cool known exoplanets and for accessing the strongest ammonia bands. In conjunction with shorter wavelength observations, MIRI will enable a more accurate characterization of the exoplanetary atmospheric properties. Here we consider a subsample of the currently known exoplanets detected by direct imaging and we discuss their detectability with MIRI, either using the coronagraphic or the spectroscopic modes. By using the Exo-REM atmosphere model we calculate the mid-infrared emission spectra of fourteen exoplanets, and we simulate MIRI coronagraphic or spectroscopic observations. Specifically we analyze four coronagraphic observational setups, which depend on (i) the target-star and reference-star offset (0, 3, 14 mas), (ii) the wave-front-error (130, 204 nm rms), (iii) the telescope jitter amplitude (1.6, 7 mas). We then determine the signal-to-noise and integration time values for the coronagraphic targets whose planet-to-star contrasts range from 3.9 to 10.1 mag. We conclude that all the MIRI targets should be observable with different degrees of difficulty, which depends on the final in-flight instrument performances. Furthermore, we test for detection of ammonia in the atmosphere of the coolest targets. Finally, we present the case of HR 8799 b to discuss what MIRI observations can bring to the knowledge of a planetary atmosphere, either alone or in combination with shorter wavelength observations.
The Mid-Infrared Instrument (MIRI) on-board JWST will provide imaging, coronagraphy, low-resolution spectroscopy and medium-resolution spectroscopy at unprecedented sensitivity levels in the mid-infrared wavelength range. The Medium-Resolution Spectr ometer (MRS) of MIRI is an integral field spectrograph that provides diffraction-limited spectroscopy between 4.9 and 28.3 um, within a FOV varying from 13 to 56 square. From ground testing, we calculate the physical parameters essential to general observers and calibrating the wavelength solution and resolving power of the MRS is critical for maximising the scientific performance of the instrument. We have used ground-based observations of discrete spectral features in combination with Fabry-Perot etalon spectra to characterize the wavelength solution and spectral resolving power of the MRS. We present the methodology used to derive the MRS spectral characterisation, which includes the precise wavelength coverage of each MRS sub-band, computation of the resolving power as a function of wavelength, and measuring slice-dependent spectral distortions. The resolving power varies from R3500 in channel 1 to R1500 in channel 4. Based on the ground test data, the wavelength calibration accuracy is estimated to be below one tenth of a pixel, with small systematic shifts due to the target position within a slice for unresolved sources, that have a maximum amplitude of about 0.25 spectral resolution elements. Based on ground test data, the MRS complies with the spectral requirements for both the R and wavelength accuracy for which it was designed. We also present the commissioning strategies and targets that will be followed to update the spectral characterisation of the MRS.
The James Webb Space Telescope will provide deep imaging and spectroscopy for sources at redshifts above 6, covering the Epoch of Reionization (EoR, 6 < z < 10). The Mid-IR instrument (MIRI) integral field spectrograph (MRS) will be the only instrume nt on board JWST able to observe the brightest optical emission lines H$alpha$ and [OIII]0.5007$mu$m at redshifts above 7 and 9, respectively. This paper presents a study of the H$alpha$ fluxes predicted by FIRSTLIGHT cosmological simulations for galaxies at redshifts of 6.5 to 10.5, and its detectability with MIRI. Deep (40 ks) spectroscopic integrations with MRS will be able to detect (S/N > 5) EoR sources at redshifts above 7 with intrinsic star formation rates of more than 2 M$_{odot}$ yr$^{-1}$, and stellar masses above 4-9 $times$ 10$^7$ M$_{odot}$. In addition, the paper presents realistic MRS simulated observations of the expected (rest-frame) optical and near-infrared spectra for some spectroscopically confirmed EoR sources detected by ALMA as [OIII]88$mu$m emitters. The MRS simulated spectra cover a wide range of low metallicities from about 0.2 to 0.02Z$_{odot}$, and different [OIII]88$mu$m/[OIII]0.5007$mu$m line ratios. The simulated 10ks MRS spectra show S/N in the range of 5 to 90 for H$beta$, [OIII]0.4959,0.5007$mu$m, H$alpha$ and HeI1.083$mu$m emission lines of MACS1149-JD1 at z = 9.11, independent of metallicity. In addition, deep 40 ks simulated spectra of the luminous merger candidate B14-65666 at z=7.15 shows the MRS capabilities of detecting, or putting strong upper limits, on the [NII]0.6584$mu$m, [SII]0.6717,0.6731$mu$m, and [SIII]0.9069,0.9532$mu$m emission lines. In summary, MRS will enable the detailed study of key physical properties like internal extinction, instantaneous star formation, hardness of the ionising continuum, and metallicity, in bright (intrinsic or lensed) EoR sources.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا