اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe quantum efficiency and diffractive image artifacts of Si:As IBC mid-IR detector arrays at 5 $-$ 10 $mu$m: Implications for the JWST/MIRI detectors
71
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Arsenic doped back illuminated blocked impurity band (BIBIB) silicon detectors have advanced near and mid-IR astronomy for over thirty years; they have high quantum efficiency (QE), especially at wavelengths longer than 10 $mu$m, and a large spectral range. Their radiation hardness is also an asset for space based instruments. Three examples of Si:As BIBIB arrays are used in the Mid-InfraRed Instrument (MIRI) of the James Webb Space Telescope (JWST), observing between 5 and 28 $mu$m. In this paper, we analyze the parameters leading to high quantum efficiency (up to $sim$ 60%) for the MIRI devices between 5 and 10 $mu$m. We also model the cross-shaped artifact that was first noticed in the 5.7 and 7.8 $mu$m Spitzer/IRAC images and has since also been imaged at shorter wavelength ($le 10~mu$m) laboratory tests of the MIRI detectors. The artifact is a result of internal reflective diffraction off the pixel-defining metallic contacts to the readout detector circuit. The low absorption in the arrays at the shorter wavelengths enables photons diffracted to wide angles to cross the detectors and substrates multiple times. This is related to similar behavior in other back illuminated solid-state detectors with poor absorption, such as conventional CCDs operating near 1 $mu$m. We investigate the properties of the artifact and its dependence on the detector architecture with a quantum-electrodynamic (QED) model of the probabilities of various photon paths. Knowledge of the artifact properties will be especially important for observations with the MIRI LRS and MRS spectroscopic modes.
قيم البحث
اقرأ أيضاً
The Mid-Infrared Instrument MIRI on-board the James Webb Space Telescope uses three Si:As impurity band conduction detector arrays. MIRI medium resolution spectroscopic measurements (R$sim$3500-1500) in the 5~$mu m$ to 28~$mu m$ wavelength range show
a 10-30% modulation of the spectral baseline; coherent reflections of infrared light within the Si:As detector arrays result in fringing. We quantify the shape and impact of fringes on spectra of optical sources observed with MIRI during ground testing and develop an optical model to simulate the observed modulation. We use our optical model in conjunction with the MIRI spectroscopic data to show that the properties of the buried contact inside the MIRI Si:As detector have a significant effect on the fringing behavior.
The Mid-Infrared Instrument (MIRI) on-board JWST will provide imaging, coronagraphy, low-resolution spectroscopy and medium-resolution spectroscopy at unprecedented sensitivity levels in the mid-infrared wavelength range. The Medium-Resolution Spectr
ometer (MRS) of MIRI is an integral field spectrograph that provides diffraction-limited spectroscopy between 4.9 and 28.3 um, within a FOV varying from 13 to 56 square. From ground testing, we calculate the physical parameters essential to general observers and calibrating the wavelength solution and resolving power of the MRS is critical for maximising the scientific performance of the instrument. We have used ground-based observations of discrete spectral features in combination with Fabry-Perot etalon spectra to characterize the wavelength solution and spectral resolving power of the MRS. We present the methodology used to derive the MRS spectral characterisation, which includes the precise wavelength coverage of each MRS sub-band, computation of the resolving power as a function of wavelength, and measuring slice-dependent spectral distortions. The resolving power varies from R3500 in channel 1 to R1500 in channel 4. Based on the ground test data, the wavelength calibration accuracy is estimated to be below one tenth of a pixel, with small systematic shifts due to the target position within a slice for unresolved sources, that have a maximum amplitude of about 0.25 spectral resolution elements. Based on ground test data, the MRS complies with the spectral requirements for both the R and wavelength accuracy for which it was designed. We also present the commissioning strategies and targets that will be followed to update the spectral characterisation of the MRS.
The Mid Infra Red Instrument (MIRI) is one of the four instruments onboard the James Webb Space Telescope (JWST), providing imaging, coronagraphy and spectroscopy over the 5-28 microns band. To verify the optical performance of the instrument, extens
ive tests were performed at CEA on the flight model (FM) of the Mid-InfraRed IMager (MIRIM) at cryogenic temperatures and in the infrared. This paper reports on the point spread function (PSF) measurements at 5.6 microns, the shortest operating wavelength for imaging. At 5.6 microns the PSF is not Nyquist-sampled, so we use am original technique that combines a microscanning measurement strategy with a deconvolution algorithm to obtain an over-resolved MIRIM PSF. The microscanning consists in a sub-pixel scan of a point source on the focal plane. A data inversion method is used to reconstruct PSF images that are over-resolved by a factor of 7 compared to the native resolution of MIRI. We show that the FWHM of the high-resolution PSFs were 5-10% wider than that obtained with Zemax simulations. The main cause was identified as an out-of-specification tilt of the M4 mirror. After correction, two additional test campaigns were carried out, and we show that the shape of the PSF is conform to expectations. The FWHM of the PSFs are 0.18-0.20 arcsec, in agreement with simulations. 56.1-59.2% of the total encircled energy (normalized to a 5 arcsec radius) is contained within the first dark Airy ring, over the whole field of view. At longer wavelengths (7.7-25.5 microns), this percentage is 57-68%. MIRIM is thus compliant with the optical quality requirements. This characterization of the MIRIM PSF, as well as the deconvolution method presented here, are of particular importance, not only for the verification of the optical quality and the MIRI calibration, but also for scientific applications.
The Mid-InfraRed Instrument (MIRI) on the James Webb Space Telescope (JWST) provides measurements over the wavelength range 5 to 28.5 microns. MIRI has, within a single package, four key scientific functions: photometric imaging, coronagraphy, single
-source low-spectral resolving power (R ~ 100) spectroscopy, and medium-resolving power (R ~ 1500 to 3500) integral field spectroscopy. An associated cooler system maintains MIRI at its operating temperature of < 6.7 K. This paper describes the driving principles behind the design of MIRI, the primary design parameters, and their realization in terms of the as-built instrument. It also describes the test program that led to delivery of the tested and calibrated Flight Model to NASA in 2012, and the confirmation after delivery of the key interface requirements.
The dielectric function of interstellar dust material is modeled using observations of extinction and polarization in the infrared, together with estimates for the mass of interstellar dust. The astrodust material is assumed to be a mix of amorphous
silicates and other materials, including hydrocarbons producing an absorption feature at 3.4$mu$m. The detailed shape of the 10$mu$m polarization profile depends on the assumed porosity and grain shape, but the 10$mu$m spectropolarimetric data are not yet good enough to clearly favor one shape over another, nor to constrain the porosity. The expected 3.4$mu$m feature polarization is consistent with existing upper limits, provided the 3.4$mu$m absorption is preferentially located in grain surface layers; a separate population of non-aligned carbonaceous grains is not required. We predict the 3.4$mu$m polarization feature to be $(Delta p)_{3.4mu{rm m}}/p(10mu{rm m})approx 0.016$, just below current upper limits. Polarization by the same grains at submm wavelengths is also calculated.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
