اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectronic structure of the high-mobility two-dimensional antiferromagnetic metal GdTe$_3$
62
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The new-found two-dimensional antiferromagnetic GdTe$_3$ is attractive owing to its highest carrier mobility among all known layered magnetic materials, as well as its potential application for novel magnetic twistronic and spintronic devices. Here, we have used high-resolution angle-resolved photoemission spectroscopy to investigate its Fermi surface topology and low-lying electronic band structure. The Fermi surface is partially gapped by charge density wave below the transition temperature, the residual part reconstructs making GdTe$_3$ metallic. The high carrier mobility can be attributed to the sharp and nearly linear band dispersions near the Fermi energy. We find that the scattering rate of the linear band near the Fermi energy is almost linear within a wide energy range, indicating that GdTe$_3$ is a non-Fermi liquid metal. Our results in this paper provide a fundamental understanding of this layered Van der Waals antiferromagnetic materials to guide future studies on it.
قيم البحث
اقرأ أيضاً
Magnetic van der Waals (vdW) materials have been heavily pursued for fundamental physics as well as for device design. Despite the rapid advances, so far magnetic vdW materials are mainly insulating or semiconducting, and none of them possesses a hig
h electronic mobility - a property that is rare in layered vdW materials in general. The realization of a magnetic high-mobility vdW material would open the possibility for novel magnetic twistronic or spintronic devices. Here we report very high carrier mobility in the layered vdW antiferromagnet GdTe3. The electron mobility is beyond 60,000 cm2 V-1 s-1, which is the highest among all known layered magnetic materials, to the best of our knowledge. Among all known vdW materials, the mobility of bulk GdTe3 is comparable to that of black phosphorus, and is only surpassed by graphite. By mechanical exfoliation, we further demonstrate that GdTe3 can be exfoliated to ultrathin flakes of three monolayers, and that the magnetic order and relatively high mobility is retained in approximately 20-nm-thin flakes.
We report on the electronic structure of the perovskite oxide CaCrO3 using valence-band, core-level, and Cr 2p - 3d resonant photoemission spectroscopy (PES). Despite its antiferromagnetic order, a clear Fermi edge characteristic of a metal with domi
nant Cr 3d character is observed in the valence band spectrum. The Cr 3d single particle density of states are spread over 2 eV, with the photoemission spectral weight distributed in two peaks centered at ~ 1.2 eV and 0.2 eV below EF, suggestive of the coherent and incoherent states resulting from strong electron-electron correlations. Resonant PES across the Cr 2p - 3d threshold identifies a two-hole correlation satellite and yields an on-site Coulomb energy U ~4.8 eV. The metallic DOS at EF is also reflected through the presence of a well-screened feature at low binding energy side of the Cr 2p core-level spectrum. X-ray absorption spectroscopy (XAS) at Cr L3,2 and O K edges exhibit small temperature dependent changes that point towards a small change in Cr-O hybridization. The multiplet splitting in Cr 2p core level spectrum as well as the spectral shape of the Cr XAS can be reproduced using cluster model calculations which favour a negative value for charge transfer energy between the Cr 3d and O 2p states. The overall results indicate that CaCrO3 is a strongly hybridized antiferromagnetic metal, lying in the regime intermediate to Mott-Hubbard and charge-transfer systems.
The electronic properties of $pi$-conjugated two-dimensional (2D) polymers near the Fermi level are determined by structural topology and chemical composition. Thus, tight-binding (TB) calculations of the corresponding fundamental network can be used
to explore the parameter space to find configurations with intriguing properties before designing the the atomistic 2D polymer network. The vertex-transitive textbf{fes} lattice, which is also called square-octagon lattice, is rich in interesting topological features including Dirac points and flat bands. Herein, we study its electronic and topological properties within the TB framework using representative parameters for chemical systems. Secondly, we demonstrate that the rational implementation of band structure features obtained from TB calculations into 2D polymers is feasible with a family of 2D polymers possessing textbf{fes} structure. A one-to-one band structure correspondence between fundamental network and 2D polymers is found. Moreover, changing the relative length of linkers connecting the triangulene units in the 2D polymers reflect tuning of hopping parameters in the TB model. These perturbations allow to open sizeable local band gaps at various positions in the Brillouin zone. From analysis of Berry curvature flux, none of the polymers exhibits a large topologically non-trivial band gap. However, we find a particular configuration of semimetallic characteristics with separate electron and hole pockets, which possess very low effective masses both for electrons (as small as $m^*_mathrm{e} = 0.05$) and holes (as small as $m^*_mathrm{h} = 0.01$).
We investigate the electronic and magnetic structures of two-dimensional transition metal tri-chalcogenide CrSiTe$_{3}$ and CrGeTe$_{3}$ materials by carrying out first-principles calculations. The single-layer CrSiTe$_3$ and CrGeTe$_3$ are found to
be a ferromagnetic insulator, where the presence of the strong $dpsigma$-hybridization of Cr $e_{mathrm{g}}$-Te $p$ plays a crucial role for the ferromagnetic coupling between Cr ions. We observe that the bandgaps and the interlayer magnetic order vary notably depending on the magnitude of on-site Coulomb interaction $U$ for Cr $d$ electrons. The bandgaps are formed between the Cr $e_{mathrm{g}}$ conduction bands and the Te $p$ valence bands for both CrSiTe$_3$ and CrGeTe$_3$ in the majority-spin channel. The dominant Te $p$ antibonding character in the valence bands just below the Fermi level is related to the decrease of the bandgap for the increase of $U$. We elucidate the energy band diagram, which may serve to understand the electronic and magnetic properties of the $ABX_3$-type transition metal tri-chalcogenides in general.
We have predicted a new phase of nitrogen with octagon structure in our previous study, which we referred to as octa-nitrogene (ON). In this work, we make further investigation on its electronic structure. The phonon band structure has no imaginary p
honon modes, which indicates that ON is dynamically stable. Using ab initio molecular dynamic simulations, the structure is found to stable up to 100K, and ripples that are similar to that of graphene is formed on the ON sheet. Based on DFT calculation on its band structure, single layer ON is a 2D large-gap semiconductor with a band gap of 4.7eV. Because of inter-layer interaction, stackings can decrease the band gap. Biaxial tensile strain and perpendicular electric field can greatly influence the band structure of ON, in which the gap decreases and eventually closes as the biaxial tensile strain or the perpendicular electric field increases. In other words, both biaxial tensile strain and perpendicular electric field can drive the insulator-to-metal transition, and thus can be used to engineer the band gap of ON. From our results, ON has potential applications in the electronics, semiconductors, optics and spintronics, and so on.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
