اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدVerniered Optical Phased Arrays for Grating Lobe Suppression and Extended FOV
238
0
0.0
(
0
)
تأليف
Nathan Dostart
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Optical phased arrays (OPAs) which beam-steer in 2D have so far been unable to pack emitting elements at $lambda/2$ spacing, leading to grating lobes which limit the field-of-view, introduce signal ambiguity, and reduce optical efficiency. Vernier schemes, which use paired transmitter and receiver phased arrays with different periodicity, deliberately misalign the transmission and receive patterns so that only a single pairing of transmit/receive lobes permit a signal to be detected. A pair of OPAs designed to exploit this effect thereby effectively suppress the effects of grating lobes and recover the systems field-of-view, avoid potential ambiguities, and reduce excess noise. Here we analytically evaluate Vernier schemes with arbitrary phase control to find optimal configurations, as well as elucidate the manner in which a Vernier scheme can recover the full field-of-view. We present the first experimental implementation of a Vernier scheme and demonstrate grating lobe suppression using a pair of 2D wavelength-steered OPAs. These results present a route forward for addressing the pervasive issue of grating lobes, significantly alleviating the need for dense emitter pitches.
قيم البحث
اقرأ أيضاً
Compressive sensing has been used to demonstrate scene reconstruction and source localization in a wide variety of devices. To date, optical compressive sensors have not been able to achieve significant volume reduction relative to conventional optic
s of equivalent angular resolution. Here, we adapt silicon-photonic optical phased array technology to demonstrate, to our knowledge, the first application of compressive imaging in a photonic-integrated device. Our novel sensor consists of an $8times 8$ grid of grating couplers with a spacing of $100~mu$m. Path-matched waveguides route to a single multimode interferometer (MMI), which mixes and randomizes the signals into 64 outputs to be used for compressed sensing. Our device is fully passive, having no need for phase shifters, as measurement matrix calibration makes the measurements robust to phase errors. For testing, we use an Amplified Spontaneous Emission (ASE) source with a bandwidth of 40 nm, centered at 1545 nm. We demonstrate simultaneous multi-point (2 sources demonstrated in this work) brightness recovery and localization with better than 10 arcsecond precision in a sub-millimeter thick form-factor. We achieve a single source recovery rate higher than 99.9% using 10 of the 64 outputs, and a 90% recovery rate with only 6 outputs, 10 times fewer than the 64 needed for conventional imaging. This planar optical phased array compressive sensor is well-suited for imaging sparse scenes in applications constrained by form factor, volume, or high-cost detectors, with the potential to revolutionize endoscopy, beam locators, and LIDAR.
The modular design of planar phased arrays arranged on orthogonal polygon-shaped apertures is addressed and a new method is proposed to synthesize domino-tiled arrays fitting multiple, generally conflicting, requirements. Starting from an analytic pr
ocedure to check the domino-tileability of the aperture, two multi-objective optimization techniques are derived to efficiently and effectively deal with small and medium/large arrays depending on the values of the bounds for the cardinality of the solution space of the admissible clustered solutions. A set of representative numerical examples is reported to assess the effectiveness of the proposed synthesis approach also through full-wave simulations when considering non-ideal models for the radiating elements of the array.
We present a gradient-based algorithm to design general 1D grating couplers without any human input from start to finish, including a choice of initial condition. We show that we can reliably design efficient couplers to have multiple functionalities
in different geometries, including conventional couplers for single-polarization and single-wavelength operation, polarization-insensitive couplers, and wavelength-demultiplexing couplers. In particular, we design a fiber-to-chip blazed grating with under 0.2 dB insertion loss that requires a single etch to fabricate and no back-reflector.
Optical phased arrays (OPAs) implemented in integrated photonic circuits could enable a variety of 3D sensing, imaging, illumination, and ranging applications, and their convergence in new LIDAR technology. However, current integrated OPA approaches
do not scale - in control complexity, power consumption, and optical efficiency - to the large aperture sizes needed to support medium to long range LIDAR. We present the serpentine optical phased array (SOPA), a new OPA concept that addresses these fundamental challenges and enables architectures that scale up to large apertures. The SOPA is based on a serially interconnected array of low-loss grating waveguides and supports fully passive, two-dimensional (2D) wavelength-controlled beam steering. A fundamentally space-efficient design that folds the feed network into the aperture also enables scalable tiling of SOPAs into large apertures with a high fill-factor. We experimentally demonstrate the first SOPA, using a 1450 - 1650 nm wavelength sweep to produce 16,500 addressable spots in a 27x610 array. We also demonstrate, for the first time, far-field interference of beams from two separate OPAs on a single silicon photonic chip, as an initial step towards long-range computational imaging LIDAR based on novel active aperture synthesis schemes.
We demonstrate the fabrication of large-scale arrays of single photon emitters (SPEs) in hexagonal boron nitride (hBN). Bottom-up growth of hBN onto nanoscale arrays of dielectric pillars yields corresponding arrays of hBN emitters at the pillar site
s. Statistical analysis shows that the pillar diameter is critical for isolating single defects, and diameters of ~250 nm produce a near-unity yield of a single emitter at each pillar site. Our results constitute a promising route towards spatially-controlled generation of hBN SPEs and provide an effective and efficient method to create large scale SPE arrays. The results pave the way to scalability and high throughput fabrication of SPEs for advanced quantum photonic applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
