ترغب بنشر مسار تعليمي؟ اضغط هنا

A two-dimensional electron gas at the (001) surface of ferromagnetic EuTiO$_{3}$(001)

93   0   0.0 ( 0 )
 نشر من قبل Roberto Di Capua
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Studies on oxide quasi-two dimensional electron gas (q2DEG) have been a playground for the discovery of novel and sometimes unexpected phenomena, like the reported magnetism at the surface and at the interface between LaAlO$_{3}$ and SrTiO$_{3}$ non-magnetic materials. However, magnetism in this system is weak and there are evidences of a not intrinsic origin. Here, by using in-situ high-resolution angle resolved photoemission we demonstrate that ferromagnetic EuTiO$_{3}$, the magnetic counterpart of SrTiO$_{3}$ in the bulk, hosts a q2DEG at its (001) surface. This is confirmed by density functional theory calculations with Hubbard U terms in the presence of oxygen divacancies in various configurations, all of them leading to a spin-polarized q2DEG related to the ferromagnetic order of Eu-4f magnetic moments. The results suggest EuTiO$_{3}$(001) as a new material platform for oxide q2DEGs, characterized by broken inversion and time reversal symmetries.

قيم البحث

اقرأ أيضاً

Recently a metallic state was discovered at the interface between insulating oxides, most notably LaAlO3 and SrTiO3. Properties of this two-dimensional electron gas (2DEG) have attracted significant interest due to its potential applications in nanoe lectronics. Control over this carrier density and mobility of the 2DEG is essential for applications of these novel systems, and may be achieved by epitaxial strain. However, despite the rich nature of strain effects on oxide materials properties, such as ferroelectricity, magnetism, and superconductivity, the relationship between the strain and electrical properties of the 2DEG at the LaAlO3/SrTiO3 heterointerface remains largely unexplored. Here, we use different lattice constant single crystal substrates to produce LaAlO3/SrTiO3 interfaces with controlled levels of biaxial epitaxial strain. We have found that tensile strained SrTiO3 destroys the conducting 2DEG, while compressively strained SrTiO3 retains the 2DEG, but with a carrier concentration reduced in comparison to the unstrained LaAlO3/SrTiO3 interface. We have also found that the critical LaAlO3 overlayer thickness for 2DEG formation increases with SrTiO3 compressive strain. Our first-principles calculations suggest that a strain-induced electric polarization in the SrTiO3 layer is responsible for this behavior. It is directed away from the interface and hence creates a negative polarization charge opposing that of the polar LaAlO3 layer. This both increases the critical thickness of the LaAlO3 layer, and reduces carrier concentration above the critical thickness, in agreement with our experimental results. Our findings suggest that epitaxial strain can be used to tailor 2DEGs properties of the LaAlO3/SrTiO3 heterointerface.
We report the existence of metallic two-dimensional electron gases (2DEGs) at the (001) and (101) surfaces of bulk-insulating TiO2 anatase due to local chemical doping by oxygen vacancies in the near-surface region. Using angle-resolved photoemission spectroscopy, we find that the electronic structure at both surfaces is composed of two occupied subbands of d_xy orbital character. While the Fermi surface observed at the (001) termination is isotropic, the 2DEG at the (101) termination is anisotropic and shows a charge carrier density three times larger than at the (001) surface. Moreover, we demonstrate that intense UV synchrotron radiation can alter the electronic structure and stoichiometry of the surface up to the complete disappearance of the 2DEG. These results open a route for the nano-engineering of confined electronic states, the control of their metallic or insulating nature, and the tailoring of their microscopic symmetry, using UV illumination at different surfaces of anatase.
We present the structure of the fully relaxed (001) surface of the half-metallic manganite La0.7Sr0.3MnO3, calculated using density functional theory within the generalized gradient approximation (GGA). Two relevant ferroelastic order parameters are identified and characterized: The tilting of the oxygen octahedra, which is present in the bulk phase, oscillates and decreases towards the surface, and an additional ferrodistortive Mn off-centering, triggered by the surface, decays monotonically into the bulk. The narrow d-like energy band that is characteristic of unrelaxed manganite surfaces is shifted down in energy by these structural distortions, retaining its uppermost layer localization. The magnitude of the zero-temperature magnetization is unchanged from its bulk value, but the effective spin-spin interactions are reduced at the surface.
Similar to silicon that is the basis of conventional electronics, strontium titanate (SrTiO3) is the bedrock of the emerging field of oxide electronics. SrTiO3 is the preferred template to create exotic two-dimensional (2D) phases of electron matter at oxide interfaces, exhibiting metal-insulator transitions, superconductivity, or large negative magnetoresistance. However, the physical nature of the electronic structure underlying these 2D electron gases (2DEGs) remains elusive, although its determination is crucial to understand their remarkable properties. Here we show, using angle-resolved photoemission spectroscopy (ARPES), that there is a highly metallic universal 2DEG at the vacuum-cleaved surface of SrTiO3, independent of bulk carrier densities over more than seven decades, including the undoped insulating material. This 2DEG is confined within a region of ~5 unit cells with a sheet carrier density of ~0.35 electrons per a^2 (a is the cubic lattice parameter). We unveil a remarkable electronic structure consisting on multiple subbands of heavy and light electrons. The similarity of this 2DEG with those reported in SrTiO3-based heterostructures and field-effect transistors suggests that different forms of electron confinement at the surface of SrTiO3 lead to essentially the same 2DEG. Our discovery provides a model system for the study of the electronic structure of 2DEGs in SrTiO3-based devices, and a novel route to generate 2DEGs at surfaces of transition-metal oxides.
We reinvestigate the putative giant spin splitting at the surface of SrTiO$_3$ reported by Santander-Syro $et~al.$ [Nature Mat. 13, 1085 (2014)]. Our spin- and angle-resolved photoemission experiments on (001) oriented surfaces supporting a two-dimen sional electron liquid with high carrier density show no detectable spin polarization in the photocurrent. We demonstrate that this result excludes a giant spin splitting while it is fully consistent with the unconventional Rashba-like splitting seen in band structure calculations that reproduce the experimentally observed ladder of quantum confined subbands.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا