اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh electrical conducting deep-ultraviolet-transparent oxide semiconductor La-doped SrSnO3 exceeding ~3000 S cm-1
75
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
La-doped SrSnO3 (LSSO) is known as one of deep-ultraviolet (DUV)-transparent conducting oxides with an energy bandgap of ~4.6 eV. Since LSSO can be grown heteroepitaxially on more wide bandgap substrates such as MgO (Eg ~7.8 eV), LSSO is considered to be a good candidate as a DUV-transparent electrode. However, the electrical conductivity of LSSO films are below 1000 S cm^-1, most likely due to the low solubility of La ion in the LSSO lattice. Here we report that high electrically conducting (>3000 S cm^-1) LSSO thin films with an energy bandgap of ~4.6 eV can be fabricated by pulsed laser deposition on MgO substrate followed by a simple annealing in vacuum. From the X-ray diffraction and the scanning transmission electron microscopy analyses, we found that lateral grain growth occurred during the annealing, which improved the activation rate of La ion, leading to a significant improvement of carrier concentration (3.26 x 10^20 cm^-3) and Hall mobility (55.8 cm^2 V^-1 s^-1). The present DUV-transparent oxide semiconductor would be useful as a transparent electrode for developing optoelectronic devices, which transmit and/or emit DUV-light.
قيم البحث
اقرأ أيضاً
Transparent oxide semiconductors (TOSs) showing both high visible transparency and high electron mobility have attracted great attention towards the realization of advanced optoelectronic devices. La-doped BaSnO3 (LBSO) is one of the most promising T
OSs because its single crystal exhibits a high electron mobility. However, in the LBSO films, it is very hard to obtain high mobility due to the threading dislocations, which are originated from the lattice mismatch between the film and the substrate. Therefore, many researchers have tried to improve the mobility by inserting a buffer layer. While the buffer layers increased the electron mobilities, this approach leaves much to be desired since it involves a two-step film fabrication process and the enhanced mobility values are still significantly lower than single crystal values. We show herein that the electron mobility of LBSO films can be improved without inserting any buffer layers if the films are grown under highly oxidative ozone (O3) atmospheres. The O3 environments relaxed the LBSO lattice and reduced the formation of Sn2+ states, which are known to suppress the electron mobility in LBSO. The resultant O3-LBSO films showed improved mobility values up to 115 cm2 V-1 s-1, which is among the highest in LBSO films on SrTiO3 substrates and comparable to LBSO films with buffer layers.
We report herein that the carrier mobility of the 2%-La-doped BaSnO3 (LBSO) films on (001) SrTiO3 and (001) MgO substrates strongly depends on the thickness whereas it is unrelated to the lattice mismatch (+5.4% for SrTiO3, -2.3% for MgO). Although w
e observed large differences in the lattice parameters, the lateral grain size (~85 nm for SrTiO3, ~20 nm for MgO), the surface morphology and the density of misfit dislocations, the mobility increased almost simultaneously with the thickness in both cases and saturated at ~100 cm2 V-1 s-1, together with the approaching to the nominal carrier concentration (=[2% La3+]), clearly indicating that the behavior of mobility depends on the film thickness. The present results would be beneficial to understand the behavior of mobility and fruitful to further enhance the mobility of LBSO films.
We investigate lanthanum (La) as an n-type dopant in the strain-stabilized tetragonal phase of SrSnO3 grown on GdScO3 (110) using a radical-based hybrid molecular beam epitaxy approach. Fully coherent, epitaxial films with atomically smooth film surf
ace were obtained irrespective of doping density. By combining secondary ion mass spectroscopy and Hall measurements, we demonstrate that each La atom contributes to one electron to the film confirming it occupies Sr-site in SrSnO3 and that it is completely activated. Carrier density exceeding 1 x 10^20 cm-3 was achieved in LSSO films, which is in excellent agreement with the dopant-solubility limit predicted by the density functional theory calculations. A record-high room-temperature mobility of 70 cm2V-1s-1 at 1 x 10^20 cm-3 was obtained in 12 nm La-doped SrSnO3 film making this the thinnest perovskite oxide semiconductor with a reasonably high electron mobility at room temperature. We discuss the structure-dopant-transport property relationships providing essential knowledge for the design of electronic devices using these materials.
SrVO3 thin films with a high figure of merit for applications as transparent conductors were crystallized from amorphous layers using solid phase epitaxy (SPE). Epitaxial SrVO3 films crystallized on SrTiO3 using SPE exhibit a room temperature resisti
vity of 2.5 x 10-5 Ohms cm, a residual resistivity ratio of 3.8, and visible light transmission above 0.5 for a 60 nm-thick film. SrVO3 layers were deposited at room temperature using radio-frequency sputtering in an amorphous form and subsequently crystallized by heating in controlled gas environment. The lattice parameters and mosaic angular width of x-ray reflections from the crystallized films are consistent with partial relaxation of the strain resulting from the epitaxial mismatch between SrVO3 and SrTiO3. A reflection high-energy electron diffraction study of the kinetics of SPE indicates that crystallization occurs via the thermally activated propagation of the crystalline/amorphous interface, similar to SPE phenomena in other perovskite oxides. Thermodynamic calculations based on density functional theory predict the temperature and oxygen partial pressure conditions required to produce the SrVO3 phase and are consistent with the experiments. The separate control of deposition and crystallization conditions in SPE presents new possibilities for the crystallization of transparent conductors in complex geometries and over large areas.
A functionally graded Al-doped ZnO structure is presented which combines conductivity, visible transparency and light scattering with mechanical flexibility. The nano and meso-architecture, constituted by a hierarchical, large surface area, mesoporou
s tree-like structure evolving in a compact layer, is synthesized at room temperature and is fully compatible with plastic substrates. Light trapping capability is demonstrated by showing up to 100% improvement of light absorption of a low bandgap polymer employed as the active layer.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
