اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUnconventional Ideas for Ionization Cooling of Muons
101
0
0.0
(
0
)
تأليف
T. L. Hart
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Small muon beams increase the luminosity of a muon collider. Reducing the momentum and position spreads of muons reduces emittance and leads to small, cool beams. Ionization cooling has been observed at the Muon Ionization Cooling Experiment. 6D emittance reduction by a factor of 100, 000 has been achieved in simulation. Another factor of 5 in cooling would meet the basic requirements of a high luminosity muon collider. In this paper we compare, for the first time, the amount of RF needed in a cooling channel to previous linacs. We also outline three methods aimed to help achieve a final factor of 5 in 6D cooling.
قيم البحث
اقرأ أيضاً
High-brightness muon beams of energy comparable to those produced by state-of-the-art electron, proton and ion accelerators have yet to be realised. Such beams have the potential to carry the search for new phenomena in lepton-antilepton collisions t
o extremely high energy and also to provide uniquely well-characterised neutrino beams. A muon beam may be created through the decay of pions produced in the interaction of a proton beam with a target. To produce a high-brightness beam from such a source requires that the phase space volume occupied by the muons be reduced (cooled). Ionization cooling is the novel technique by which it is proposed to cool the beam. The Muon Ionization Cooling Experiment collaboration has constructed a section of an ionization cooling cell and used it to provide the first demonstration of ionization cooling. We present these ground-breaking measurements.
Progress on six dimensional ionization muon cooling with relatively small rings of magnets is described. Lattices being explored include scaling sector cyclotrons with edge focusing and strong focusing, fixed field alternating gradient (FFAG) rings.
Ionization cooling is provided by high pressure hydrogen gas which removes both transverse and longitudinal momentum. Lost longitudinal momentum is replaced using radio frequency (RF) cavities, giving a net transverse emittance reduction. The longer path length in the hydrogen of higher momentum muons decreases longitudinal emittance at the expense of transverse emittance. Thus emittance exchange allows these rings to cool in all six dimensions and not just transversely. Alternatively, if the RF is located after the ring, it may be possible to cool the muons by stopping them as they spiral adiabatically into a central swarm. As momentum goes to zero, the momentum spread goes to zero. The resulting cooled muons can lead to an intense muon beam which could be a source for neutrino factories or muon colliders.
Possible application for muon experiments such as mu2e is discussed of the initial part of the ionization cooling channel originally developed for muon collider. It is shown that with the FNAL Booster as the proton driver the mu2e sensitivity can be
increased by two orders of magnitude compared to the presently considered experiment.
The helical FOFO snake six-dimensional muon ionization cooling channel design is presented which incorporates wedge absorbers in such a way that simultaneous cooling of both signs of muons is possible.
Muon storage rings have been proposed for use as a source of high-energy neutrino beams (the Neutrino Factory) and as the basis for a high-energy lepton-antilepton collider (the Muon Collider). The Neutrino Factory is widely believed to be the machin
e of choice for the search for leptonic CP violation while the Muon Collider may prove to be the most practical route to multi-TeV lepton-antilepton collisions. The baseline conceptual designs for each of these facilities requires the phase-space compression (cooling) of the muon beams prior to acceleration. The short muon lifetime makes it impossible to employ traditional techniques to cool the beam while maintaining the muon-beam intensity. Ionization cooling, a process in which the muon beam is passed through a series of liquid-hydrogen absorbers followed by accelerating RF cavities, is the technique proposed to cool the muon beam. The international Muon Ionization Cooling Experiment (MICE) collaboration will carry out a systematic study of ionization cooling. The MICE experiment, which is under construction at the Rutherford Appleton Laboratory, will begin to take data late this year. The MICE cooling channel, the instrumentation and the implementation at the Rutherford Appleton Laboratory are described together with the predicted performance of the channel and the measurements that will be made.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
