اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBifrequency 3D Ghost Imaging with Haar Wavelet Transform
161
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Recently, ghost imaging has been attracting attentions because its mechanism would lead to many applications inaccessible to conventional imaging methods. However, it is challenging for high contrast and high resolution imaging, due to its low signal-to-noise ratio (SNR) and the demand of high sampling rate in detection. To circumvent these challenges, we here propose a ghost imaging scheme that exploits Haar wavelets as illuminating patterns with a bi-frequency light projecting system and frequency-selecting single-pixel detectors. This method provides a theoretically 100% image contrast and high detection SNR, which reduces the requirement of high dynamic range of detectors, enabling high resolution ghost imaging. Moreover, it can highly reduce the sampling rate (far below Nyquist limit) for a sparse object by adaptively abandoning unnecessary patterns during the measurement. These characteristics are experimentally verified with a resolution of 512 times 512 and a sampling rate lower than 5%. A high-resolution (1000 times 1000 times 1000) 3D reconstruction of an object is also achieved from multi-angle images.
قيم البحث
اقرأ أيضاً
A new focal-plane three-dimensional (3D) imaging method based on temporal ghost imaging is proposed and demonstrated. By exploiting the advantages of temporal ghost imaging, this method enables slow integrating cameras have an ability of 3D surface i
maging in the framework of sequential flood-illumination and focal-plane detection. The depth information of 3D objects is easily lost when imaging with traditional cameras, but it can be reconstructed with high-resolution by temporal correlation between received signals and reference signals. Combining with a two-dimensional (2D) projection image obtained by one single shot, a 3D image of the object can be achieved. The feasibility and performance of this focal-plane 3D imaging method have been verified through theoretical analysis and numerical experiments in this paper.
Knowledge gained through X-ray crystallography fostered structural determination of materials and greatly facilitated the development of modern science and technology in the past century. Atomic details of sample structures is achievable by X-ray cry
stallography, however, it is only applied to crystalline structures. Imaging techniques based on X-ray coherent diffraction or zone plates are capable of resolving the internal structure of non-crystalline materials at nanoscales, but it is still a challenge to achieve atomic resolution. Here we demonstrate a novel lensless Fourier-transform ghost imaging method with pseudo-thermal hard X-rays by measuring the second-order intensity correlation function of the light. We show that high resolution Fourier-transform diffraction pattern of a complex amplitude sample can be achieved at Fresnel region and the amplitude and phase distributions of a sample in spatial domain can be retrieved successfully. The method of lensless X-ray Fourier-transform ghost imaging extends X-ray crystallography to non-crystalline samples, and its spatial resolution is limited only by the wavelength of the X-ray, thus atomic resolution should be routinely obtainable. Since highly coherent X-ray source is not required, comparing to conventional X-ray coherent diffraction imaging, the method can be implemented with laboratory X-ray sources, and it also provides a potential solution for lensless diffraction imaging with fermions, such as neutron and electron where the intensive coherent source usually is not available.
In this paper, we propose an advanced framework of ghost edge imaging, named compressed ghost edge imaging (CGEI). In the scheme, a set of structured speckle patterns with pixel shifting are illuminated on an unknown object, and the output is collect
ed by a bucket detector without any spatial resolution. By using compressed sensing algorithm, we obtain the horizontal and vertical edge information of the unknown object with the bucket detector detection results and the known structured speckle patterns. The edge is finally constructed by the two-dimentional edge information. The experimental and numerical simulations results show that the proposed scheme has a higher quality and reduces the number of measurements, in comparison with the existed edge detection schemes based on ghost imaging.
Computational ghost imaging is an imaging technique in which an object is imaged from light collected using a single-pixel detector with no spatial resolution. Recently, ghost cytometry has been proposed for a high-speed cell-classification method th
at involves ghost imaging and machine learning in flow cytometry. Ghost cytometry skips the reconstruction of cell images from signals and directly used signals for cell-classification because this reconstruction is what creates the bottleneck in the high-speed analysis. In this paper, we provide theoretical analysis for learning from ghost imaging without imaging.
Ghost imaging is usually based on optoelectronic process and eletronic computing. We here propose a new ghost imaging scheme, which avoids any optoelectronic or electronic process. Instead, the proposed scheme exploits all-optical correlation via the
light-light interaction and the vision persistence effect to generate images observed by naked eyes. To realize high contrast naked-eye ghost imaging, a special pattern-scanning architecture on a low-speed light-modulation disk is designed, which also enables high-resolution imaging with lower-order Hadamard vectors and boosts the imaging speed. With this approach, we realize high-contrast real-time ghost imaging for moving colored objects.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
