اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMetal-chalcogen bond-length induced electronic phase transition from semiconductor to topological semimetal in ZrX$_2$ (X = Se and Te)
106
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Using angle resolved photoemission spectroscopy (ARPES) and density functional theory (DFT) calculations we studied the low-energy electronic structure of bulk ZrTe$_2$. ARPES studies on ZrTe$_2$ demonstrate free charge carriers at the Fermi level, which is further confirmed by the DFT calculations. An equal number of hole and electron carrier density estimated from the ARPES data, points ZrTe$_2$ to a semimetal. The DFT calculations further suggest a band inversion between Te $p$ and Zr $d$ states at the $Gamma$ point, hinting at the non-trivial band topology in ZrTe$_2$. Thus, our studies for the first time unambiguously demonstrate that ZrTe$_2$ is a topological semimetal. Also, a comparative band structure study is done on ZrSe$_2$ which shows a semiconducting nature of the electronic structure with an indirect band gap of 0.9 eV between $Gamma (A) $ and $M (L)$ high symmetry points. In the below we show that the metal-chalcogen bond-length plays a critical role in the electronic phase transition from semiconductor to a topological semimetal ingoing from ZrSe$_2$ to ZrTe$_2$.
قيم البحث
اقرأ أيضاً
Charge density wave (CDW) is a collective quantum phenomenon in metals and features a wave-like modulation of the conduction electron density. A microscopic understanding and experimental control of this many-body electronic state in atomically thin
materials remain hot topics in condensed matter physics. Here we report an interface and/or Zr intercalation induced semiconductor-metal phase transition, as well as a concomitant (2 $times$ 2) CDW order in 1T-ZrX$_2$ (X = Se, Te) thin films prepared on graphitized SiC(0001) substrates. Also observed has been a sizable CDW energy gap up to 22 meV opened at the Fermi level. Fourier-transformed scanning tunneling microscopy reveals a rather simple Fermi surface, consisting only of Zr 4d-derived conduction band at the corners of the Brillouin zone. Our finding that such a simple electronic structure is compatible with the CDW phase proves intriguing and challenges several prevailing scenarios for the formation of CDW in transition metal dichalcogenides.
Most of the 2D transition metal dichalcogenides (TMDC) are nonmagnetic in pristine form. However, 2D pristine VX2 (X=S, Se, Te) materials are found to be ferromagnetic. Using spin polarized density functional theory (DFT) calculations, we have studie
d the electronic, magnetic and surface properties of this class of materials in both trigonal prismatic 2H- and octahedral 1T-phase. Our calculations reveal that they exhibit materially different properties in those two polymorphs. Most importantly, detailed investigation of electronic structure explored the quantum size effect in 2H-phase of these materials thereby leading to metal to semimetal (2H-VS2) or semiconductor (2H-VSe2, 2H-VTe2) transition when downsizing from bilayer to corresponding monolayer.
Very recently, it has been shown that vanadium dichalcogenides (VX$_2$, X=S, Se and Te) monolayers show intrinsic ferromagnetism, and their critical temperatures are nearly to or beyond room temperature. Hence, they would have wide potential applicat
ions in next-generation nanoelectronic and spintronic devices. In this work, being inspired by a recent study we systematically perform Monte Carlo simulations based on single-site update Metropolis algorithm to investigate the hysteresis features of VX$_2$ monolayers for a wide range of temperatures up to 600 K. Our simulation results indicate that, both remanence and coercivity values tend to decrease with increasing temperature. Furthermore, it is found that hysteresis curves start to evolve from rectangular at the lower temperature regions to nearly S-shaped with increasing temperature.
By means of the first-principles calculations combined with the tight-binding approximation, the strain-induced semiconductor-semimetal transition in graphdiyne is discovered. It is shown that the band gap of graphdiyne increases from 0.47 eV to 1.39
eV with increasing the biaxial tensile strain, while the band gap decreases from 0.47 eV to nearly zero with increasing the uniaxial tensile strain, and Dirac cone-like electronic structures are observed. The uniaxial strain-induced changes of the electronic structures of graphdiyne come from the breaking of geometrical symmetry that lifts the degeneracy of energy bands. The properties of graphdiyne under strains are disclosed different remarkably from that of graphene.
We performed X-ray diffraction and electrical resistivity measurement up to pressures of 5 GPa and the first-principles calculations utilizing experimental structural parameters to investigate the pressure-induced topological phase transition in BiTe
Br having a noncentrosymmetric layered structure (space group P3m1). The P3m1 structure remains stable up to pressures of 5 GPa; the ratio of lattice constants, c/a, has a minimum at pressures of 2.5 - 3 GPa. In the same range, the temperature dependence of resistivity changes from metallic to semiconducting at 3 GPa and has a plateau region between 50 and 150 K in the semiconducting state. Meanwhile, the pressure variation of band structure shows that the bulk band-gap energy closes at 2.9 GPa and re-opens at higher pressures. Furthermore, according to the Wilson loop analysis, the topological nature of electronic states in noncentrosymmetric BiTeBr at 0 and 5 GPa are explicitly revealed to be trivial and non-trivial, respectively. These results strongly suggest that pressure-induced topological phase transition in BiTeBr occurs at the pressures of 2.9 GPa.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
