ترغب بنشر مسار تعليمي؟ اضغط هنا

Coherent Detection for Short-Packet Physical-Layer Network Coding with FSK Modulation

91   0   0.0 ( 0 )
 نشر من قبل Zhaorui Wang
 تاريخ النشر 2019
  مجال البحث الهندسة المعلوماتية
والبحث باللغة English




اسأل ChatGPT حول البحث

This paper investigates coherent detection for physical-layer network coding (PNC) with short packet transmissions in a two-way relay channel (TWRC). PNC turns superimposed EM waves into network-coded messages to improve throughput in a relay system. To achieve this, accurate channel information at the relay is a necessity. Much prior work applies preambles to estimate the channel. For long packets, the preamble overhead is low because of the large data payload. For short packets, that is not the case. To avoid excessive overhead, we consider a set-up in which short packets do not have preambles. A key challenge is how the relay can estimate the channel and detect the network-coded messages jointly based on the received signals from the two end users. We design a coherent detector that makes use of a belief propagation (BP) algorithm to do so. For concreteness, we focus on frequency-shift-keying (FSK) modulation. We show how the BP algorithm can be simplified and made practical with Gaussian-mixture passing. In addition, we demonstrate that prior knowledge on the channel distribution is not needed with our framework. Benchmarked against the detector with prior knowledge of the channel distribution, numerical results show that our detector can have nearly the same performance without such prior knowledge.



قيم البحث

اقرأ أيضاً

This paper investigates noncoherent detection in a two-way relay channel operated with physical layer network coding (PNC), assuming FSK modulation and short-packet transmissions. For noncoherent detection, the detector has access to the magnitude bu t not the phase of the received signal. For conventional communication in which a receiver receives the signal from a transmitter only, the phase does not affect the magnitude, hence the performance of the noncoherent detector is independent of the phase. PNC, however, is a multiuser system in which a receiver receives signals from multiple transmitters simultaneously. The relative phase of the signals from different transmitters affects the received signal magnitude through constructive-destructive interference. In particular, for good performance, the noncoherent detector in PNC must take into account the influence of the relative phase on the signal magnitude. Building on this observation, this paper delves into the fundamentals of PNC noncoherent detector design. To avoid excessive overhead, we do away from preambles. We show how the relative phase can be deduced directly from the magnitudes of the received data symbols. Numerical results show that our detector performs nearly as well as a fictitious optimal detector that has perfect knowledge of the channel gains and relative phase.
Leveraging recent progress in physical-layer network coding we propose a new approach to random access: When packets collide, it is possible to recover a linear combination of the packets at the receiver. Over many rounds of transmission, the receive r can thus obtain many linear combinations and eventually recover all original packets. This is by contrast to slotted ALOHA where packet collisions lead to complete erasures. The throughput of the proposed strategy is derived and shown to be significantly superior to the best known strategies, including multipacket reception.
127 - Jie Hou , Gerhard Kramer 2013
Short message noisy network coding (SNNC) differs from long message noisy network coding (LNNC) in that one transmits many short messages in blocks rather than using one long message with repetitive encoding. Several properties of SNNC are developed. First, SNNC with backward decoding achieves the same rates as SNNC with offset encoding and sliding window decoding for memoryless networks where each node transmits a multicast message. The rates are the same as LNNC with joint decoding. Second, SNNC enables early decoding if the channel quality happens to be good. This leads to mixed strategies that unify the advantages of decode-forward and noisy network coding. Third, the best decoders sometimes treat other nodes signals as noise and an iterative method is given to find the set of nodes that a given node should treat as noise sources.
We analyze a cooperative wireless communication system with finite block length and finite battery energy, under quasi-static Rayleigh fading. Source and relay nodes are powered by a wireless energy transfer (WET) process, while using the harvested e nergy to feed their circuits, send pilot signals to estimate channels at receivers, and for wireless information transmission (WIT). Other power consumption sources beyond data transmission power are considered. The error probability is investigated under perfect/imperfect channel state information (CSI), while reaching accurate closed-form approximations in ideal direct communication system setups. We consider ultra-reliable communication (URC) scenarios under discussion for the next fifth-generation (5G) of wireless systems. The numerical results show the existence of an optimum pilot transmit power for channel estimation, which increases with the harvested energy. We also show the importance of cooperation, even taking into account the multiplexing loss, in order to meet the error and latency constraints of the URC systems.
This paper investigates the application of physical-layer network coding (PNC) to Industrial Internet-of-Things (IIoT) where a controller and a robot are out of each others transmission range, and they exchange messages with the assistance of a relay . We particularly focus on a scenario where the controller has more transmitted information, and the channel of the controller is stronger than that of the robot. To reduce the communication latency, we propose an asymmetric transmission scheme where the controller and robot transmit different amount of information in the uplink of PNC simultaneously. To achieve this, the controller chooses a higher order modulation. In addition, the both users apply channel codes to guarantee the reliability. A problem is a superimposed symbol at the relay contains different amount of source information from the two end users. It is thus hard for the relay to deduce meaningful network-coded messages by applying the current PNC decoding techniques which require the end users to transmit the same amount of information. To solve this problem, we propose a lattice-based scheme where the two users encode-and-modulate their information in lattices with different lattice construction levels. Our design is versatile on that the two end users can freely choose their modulation orders based on their channel power, and the design is applicable for arbitrary channel codes.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا