اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSuperlubricity of epitaxial monolayer WS2 on graphene
92
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report on the superlubric sliding of monolayer tungsten disulfide (WS2) on epitaxial graphene (EG) on silicon carbide (SiC). WS2 single-crystalline flakes with lateral size of hundreds of nanometers are obtained via chemical vapor deposition (CVD) on EG and microscopic and diffraction analyses indicate that the WS2/EG stack is predominantly aligned with zero azimuthal rotation. Our experimental findings show that the WS2 flakes are prone to slide over graphene surfaces at room temperature when perturbed by a scanning probe microscopy (SPM) tip. Atomistic force field based molecular dynamics simulations indicate that through local physical deformation of the WS2 flake, the scanning tip releases enough energy to the flake to overcome the motion activation barrier and to trigger an ultra-low friction roto-translational displacement, that is superlubric. Experimental observations indicate that after the sliding, the WS2 flakes rest with a rotation of npi/3 with respect to graphene. Atomically resolved investigations show that the interface is atomically sharp and that the WS2 lattice is strain-free. These results help to shed light on nanotribological phenomena in van der Waals (vdW) heterostacks and suggest that the applicative potential of the WS2/graphene heterostructure can be extended by novel mechanical prospects.
قيم البحث
اقرأ أيضاً
We present the electronic and structural properties of monolayer WSe$_{2}$ grown by pulsed-laser deposition on monolayer graphene (MLG) on SiC. The spin splitting in the WSe$_{2}$ valence band at $overline{mathrm{K}}$ was $Delta_mathrm{SO}=0.469pm0.0
08$ eV by angle-resolved photoemission spectroscopy (ARPES). Synchrotron-based grazing-incidence in-plane X-ray diffraction (XRD) revealed the in-plane lattice constant of monolayer WSe$_{2}$ to be $a_mathrm{WSe_2}=3.2757pm0.0008 mathrm{r{A}}$. This indicates a lattice compression of -0.19 % from bulk WSe$_{2}$. By using experimentally determined graphene lattice constant ($a_mathrm{MLG}=2.4575pm0.0007 mathrm{r{A}}$), we found that a 3$times$3 unit cell of the slightly compressed WSe$_{2}$ is perfectly commensurate with a 4$times$4 graphene lattice with a mismatch below 0.03 %, which could explain why the monolayer WSe$_{2}$ is compressed on MLG. From XRD and first-principles calculations, however, we conclude that the observed size of strain is negligibly small to account for a discrepancy in $Delta_mathrm{SO}$ found between exfoliated and epitaxial monolayers in earlier ARPES. In addition, angle-resolved, ultraviolet and X-ray photoelectron spectroscopy shed light on the band alignment between WSe$_{2}$ and MLG/SiC and indicate electron transfer from graphene to the WSe$_{2}$ monolayer. As further revealed by atomic force microscopy, the WSe$_{2}$ island size depends on the number of carbon layers on top of the SiC substrate. This suggests that the epitaxy of WSe$_{2}$ favors the weak van der Waals interactions with graphene while it is perturbed by the influence of the SiC substrate and its carbon buffer layer.
We report on preparation dependent properties observed in monolayer WS2 samples synthesized via chemical vapor deposition (CVD) on a variety of common substrates (Si/SiO2, sapphire, fused silica) as well as samples that were transferred from the grow
th substrate onto a new substrate. The as-grown CVD materials (as-WS2) exhibit distinctly different optical properties than transferred WS2 (x-WS2). In the case of CVD growth on Si/SiO2, following transfer to fresh Si/SiO2 there is a ~50 meV shift of the ground state exciton to higher emission energy in both photoluminescence emission and optical reflection. This shift is indicative of a reduction in tensile strain by ~0.25%. Additionally, the excitonic state in x-WS2 is easily modulated between neutral and charged exciton by exposure to moderate laser power, while such optical control is absent in as-WS2 for all growth substrates investigated. Finally, we observe dramatically different laser power-dependent behavior for as-grown and transferred WS2. These results demonstrate a strong sensitivity to sample preparation that is important for both a fundamental understanding of these novel materials as well as reliable reproduction of device properties.
We report our results on the adsorption of noble gases such as argon, krypton and xenon on a graphene sheet, using Grand Canonical Monte Carlo (GCMC) simulations. We calculated the two-dimensional gas-liquid critical temperature for each adsorbate, r
esulting in fair agreement with theoretical predictions and experimental values of gases on graphite. We determined the different phases of the monolayers and constructed the phase diagrams. We found two-dimensional incommensurate solid phases for krypton, argon and xenon, and a two-dimensional commensurate solid phase for krypton.
Janus single-layer transition metal dichalcogenides, in which the two chalcogen layers have a different chemical nature, push chemical composition control beyond what is usually achievable with van der Waals heterostructures. Here we report such a no
vel Janus compound, SPtSe, which is predicted to exhibit strong Rashba spin-orbit coupling. We synthetized it by conversion of a single-layer of PtSe$_2$ on Pt(111) via sulphurization under H$_2$S atmosphere. Our in situ and operando structural analysis with grazing incidence synchrotron X-ray diffraction reveals the process by which the Janus alloy forms. The crystalline long-range order of the as-grown PtSe$_2$ monolayer is first lost due to thermal annealing. A subsequent recrystallization in presence of a source of sulphur yields a highly ordered SPtSe alloy, which is iso-structural to the pristine PtSe$_2$. The chemical composition is resolved, layer-by-layer, using angle-resolved X-ray photoelectron spectroscopy, demonstrating that Se-by-S substitution occurs selectively in the topmost chalcogen layer.
An in vacuo thermal desorption process has been accomplished to form epitaxial graphene (EG) on 4H- and 6H-SiC substrates using a commercial chemical vapor deposition reactor. Correlation of growth conditions and the morphology and electrical propert
ies of EG are described. Raman spectra of EG on Si-face samples were dominated by monolayer thickness. This approach was used to grow EG on 50 mm SiC wafers that were subsequently fabricated into field effect transistors with fmax of 14 GHz.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
