اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFirst-principles study, fabrication and characterization of (Zr0.25Nb0.25Ti0.25V0.25)C high-entropy ceramic
157
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The formation possibility of a new (Zr0.25Nb0.25Ti0.25V0.25)C high-entropy ceramic (ZHC-1) was first analyzed by the first-principles calculations and thermodynamical analysis and then it was successfully fabricated by hot pressing sintering technique. The first-principles calculation results showed that the mixing enthalpy of ZHC-1 was 5.526 kJ/mol and the mixing entropy of ZHC-1 was in the range of 0.693R-1.040R. The thermodynamical analysis results showed that ZHC-1 was thermodynamically stable above 959 K owing to its negative mixing Gibbs free energy. The experimental results showed that the as-prepared ZHC-1 (95.1% relative density) possessed a single rock-salt crystal structure, some interesting nanoplate-like structures and high compositional uniformity from nanoscale to microscale. By taking advantage of these unique features, compared with the initial metal carbides (ZrC, NbC, TiC and VC), it showed a relatively low thermal conductivity of 15.3 + - 0.3 W/(m.K) at room temperature, which was due to the presence of solid solution effects, nanoplates and porosity. Meanwhile, it exhibited the relatively high nanohardness of 30.3 + - 0.7 GPa and elastic modulus of 460.4 + - 19.2 GPa and the higher fracture toughness of 4.7 + - 0.5 MPa.m1/2, which were attributed to the solid solution strengthening mechanism and nanoplate pullout and microcrack deflection toughening mechanism.
قيم البحث
اقرأ أيضاً
This article reports the study of SnO by using the first-principles pseudopotential plane-wave method within the generalized gradient approximation (GGA). We have calculated the structural, elastic, electronic and optical of SnO under high pressure.
The elastic properties such as the elastic constants Cij bulk modulus, shear modulus, Young modulus, anisotropic factor, Pugh ratio, Poisson ratio are calculated and analyzed. Mechanical stability of SnO at all pressure are confirmed by using Born stability criteria in terms of elastic constants and are associated with ductile behaviour based on G/B ratios. It is also found that SnO exhibits very high anisotropy. The energy band structure and density of states are also calculated and analyzed. The results show the semiconducting and metallic properties at 0 (zero) and high pressure, respectively. Furthermore, the optical properties such as dielectric function, refractive index, photoconductivity, absorption coefficients, loss function and reflectivity are also calculated. All the results are compared with those of the SnO where available but most of the results at high pressure are not compared due to unavailability of the results.
A theoretical study proposes the atomic configuration of electron-beam irradiated C$_{60}$ thin films. We examined the electronic structure and electron-transport properties of the C$_{60}$ clusters using density-functional calculations and found tha
t a rhombohedral C$_{60}$ polymer with $sp^3$-bonded dumbbell-shaped connections at the molecule junction is a semiconductor with a narrow band gap while the polymer changes to exhibit metallic behavior by forming $sp^2$-bonded peanut-shaped connections. Conductance below the Fermi level increases and the peak of the conductance spectrum arising from the $t_{u1}$ states of a C$_{60}$ molecule becomes obscure after the connections are rearranged. The present rohmbohedral film, including the [2+2] four-membered rings and peanut-shaped connections, is a candidate to represent the structure of the metallic C$_{60}$ polymer at the initial stage of electron-beam irradiation.
Evidence of coexistence of Co3+ with Co2+ in ceramic Co3TeO6 through XANES, DC magnetization and first principal studies is provided. XANES along with linear combination fit provide relative concentrations of Co2+ and Co3+.Temperature dependent DC ma
gnetization exhibits the same antiferromagnetic behavior as observed in single crystal. The presence of both Co2+ and Co3+ suggests that if the later is in high spin state, the effective magnetic moment is similar to that observed in single crystal studies. In contrast, if Co3+ is in low spin state effective magnetic moment is similar to that observed in Co3O4. It is further shown that both Co2+ and Co3+ in high spin states constitute a favorable ground state through first principle calculations where Rietveld refined Synchrotron X-ray diffraction data are inputs.
We report first principles LDA calculations of the electronic structure and thermoelectric properties of $beta $-Zn$_{4}$Sb$_{3}$. The material is found to be a low carrier density metal with a complex Fermi surface topology and non-trivial dependenc
e of Hall concentration on band filling. The band structure is rather covalent, consistent with experimental observations of good carrier mobility. Calculations of the variation with band filling are used to extract the doping level (band filling) from the experimental Hall number. At this band filling, which actually corresponds to 0.1 electrons per 22 atom unit cell, the calculated thermopower and its temperature dependence are in good agreement with experiment. The high Seebeck coefficient in a metallic material is remarkable, and arises in part from the strong energy dependence of the Fermiology near the experimental band filling. Improved thermoelectric performance is predicted for lower doping levels which corresponds to higher Zn concentrations.
In a latest experimental advance, graphene-like and insulating BeO monolayer was successfully grown over silver surface by molecular beam epitaxy (ACS Nano 15(2021), 2497). Inspired by this accomplishment, in this work we conduct first-principles bas
ed simulations to explore the electronic, mechanical properties and thermal conductivity of graphene-like BeO, MgO and CaO monolayers. The considered nanosheets are found to show desirable thermal and dynamical stability. BeO monolayer is found to show remarkably high elastic modulus and tensile strength of 408 and 53.3 GPa, respectively. The electronic band gap of BeO, MgO and CaO monolayers are predicted to be 6.72, 4.79, and 3.80 eV, respectively, using the HSE06 functional. On the basis of iterative solutions of the Boltzmann transport equation, the room temperature lattice thermal conductivity of BeO, MgO and CaO monolayers are predicted to be 385, 64 and 15 W/mK, respectively. Our results reveal substantial decline in the electronic band gap, mechanical strength and thermal conductivity by increasing the weight of metal atoms. This work highlights outstandingly high thermal conductivity, carrier mobility and mechanical strength of insulating BeO nanosheets and suggest them as promising candidates to design strong and insulating components with high thermal conductivities.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
