اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectronic and optical properties of doped TiO2 by many-body perturbation theory
300
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Doping is one of the most common strategies for improving the photocatalytic and solar energy conversion properties of TiO$_2$, hence an accurate theoretical description of the electronic and optical properties of doped TiO$_2$ is of both scientific and practical interest. In this work we use many-body perturbation theory techniques to investigate two typical n-type dopants, Niobium and Hydrogen, in TiO$_2$ rutile. Using the GW approximation to determine band edges and defect energy levels, and the Bethe Salpeter equation for the calculation of the absorption spectra, we find that the defect energy levels form non-dispersive bands %associated with localized states lying $simeq 2.2 eV$ above the top of the corresponding valence bands ($simeq 0.9 eV$ below the conduction bands of the {it pristine} material). The defect states are also responsible for the appearance of low energy absorption peaks that enhance the solar spectrum absorption of rutile. The spatial distributions of the excitonic wavefunctions associated with these low energy excitations are very different for the two dopants, suggesting a larger mobility of photoexcited electrons in Nb-TiO$_2$.
قيم البحث
اقرأ أيضاً
Cyclometalled Ir(III) compounds are the preferred choice as organic emitters in Organic Light Emitting Diodes. In practice, the presence of the transition metals surrounded by carefully designed ligands allows the fine tuning of the emission frequenc
y as well as a good efficiency of the device. To support the development of new compounds the experimental measurements are generally compared with ab-initio calculation of the absorption and emission spectra. The standard approach for these calculations is TDDFT with hybrid exchange and correlation functional like the B3LYP. Due to the size of these compounds the application of more complex quantum chemistry approaches can be challenging. In this work we used Many Body Perturbation Theory approaches (in particular the GW approximation with the Bethe-Salpeter equation) implemented in gaussian basis sets, to calculate the quasiparticle properties and the adsorption spectra of six cyclometalled Ir(III) complexes going behind TDDFT. In the presented results we compared standard TDDFT simulation with BSE calculations performed on top on perturbative G 0 W 0 and accounting for eigenvalue self consistency. Moreover, in order to investigate in detail the effect of the DFT starting point, we concentrate on Ir(ppy) 3 performing GW-BSE simulations starting from different DFT exchange and correlation potentials.
The bandstructure of gold is calculated using many-body perturbation theory (MBPT). Different approximations within the GW approach are considered. Standard single shot G0W0 corrections shift the unoccupied bands up by ~0.2 eV and the first sp-like o
ccupied band down by ~0.4 eV, while leaving unchanged the 5d occupied bands. Beyond G0W0, quasiparticle self-consistency on the wavefunctions lowers the occupied 5d bands by 0.35 eV. Globally, many-body effects achieve an opening of the interband gap (5d-6sp gap) of 0.35 to 0.75 eV approaching the experimental results. Finally, the quasiparticle bandstructure is compared to the one obtained by the widely used HSE (Heyd, Scuseria, and Ernzerhof) hybrid functional.
The formation energies and electronic structure of europium doped zinc oxide has been determined using DFT and many-body $GW$ methods. In the absence of intrisic defects we find that the europium-$f$ states are located in the ZnO band gap with europi
um possessing a formal charge of 2+. On the other hand, the presence of intrinsic defects in ZnO allows intraband $f-f$ transitions otherwise forbidden in atomic europium. This result coorroborates with recently observed photoluminescence in the visible red region [1].
We present many-body textit{ab initio} calculations of the electronic and optical properties of semiconducting zigzag carbon nanotubes under uniaxial strain. The GW approach is utilized to obtain the quasiparticle bandgaps and is combined with the Be
the-Salpeter equation to obtain the optical absorption spectrum. We find that the dependence of the electronic bandgaps on strain is more complex than previously predicted based on tight-binding models or density-functional theory. In addition, we show that the exciton energy and exciton binding energy depend significantly on strain, with variations of tens of meVs per percent strain, but that despite these strong changes the absorbance is found to be nearly independent of strain. Our results provide new guidance for the understanding and design of optomechanical systems based on carbon nanotubes.
The conductance of single molecule junctions is calculated using a Landauer approach combined to many-body perturbation theory MBPT) to account for electron correlation. The mere correction of the density-functional theory eigenvalues, which is the s
tandard procedure for quasiparticle calculations within MBPT, is found not to affect noticeably the zero-bias conductance. To reduce it and so improve the agreement with the experiments, the wavefunctions also need to be updated by including the non-diagonal elements of the self-energy operator.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
