اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDefect-Fluorite Gd2Zr2O7 Ceramics under Helium Irradiation: Amorphization, Cell Volume Expansion, and Multi-stage Bubble Formation
100
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Here, we report a study on the radiation resistance enhancement of Gd2Zr2O7 nanograin ceramics, in which amorphization, cell volume expansion and multi-stage helium (He) bubble formation are investigated and discussed. Gd2Zr2O7 ceramics with a series of grain sizes (55-221 nm) were synthesized and irradiated by 190 keV He ion beam up to a fluence of 5x10^17 ions/cm2. Both the degree of post irradiation cell volume expansion and the amorphization fraction appear to be size dependent. As the average grain size evolves from 55 to 221 nm, the degree of post irradiation cell volume expansion increases from 0.56 to 1.02 %, and the amorphization fraction increases from 6.8 to 11.1 %. Additionally, the threshold He concentrations (at. %) of bubbles at different formation stages and locations, including (1) bubbles at grain boundary, (2) bubble-chains and (3) ribbon-like bubbles within the grain, are all found to be much higher in the nanograin ceramic (55 nm) compared with that of the submicron sample (221 nm). We conclude that grain boundary plays a critical role in minimizing the structural defects, and inhibiting the multi-stage He bubble formation process.
قيم البحث
اقرأ أيضاً
Fast and reversible phase transitions in chalcogenide phase-change materials (PCMs), in particular, Ge-Sb-Te compounds, are not only of fundamental interests, but also make PCMs based random access memory (PRAM) a leading candidate for non-volatile m
emory and neuromorphic computing devices. To RESET the memory cell, crystalline Ge-Sb-Te has to undergo phase transitions firstly to a liquid state and then to an amorphous state, corresponding to an abrupt change in electrical resistance. In this work, we demonstrate a progressive amorphization process in GeSb2Te4 thin films under electron beam irradiation on transmission electron microscope (TEM). Melting is shown to be completely absent by the in situ TEM experiments. The progressive amorphization process resembles closely the cumulative crystallization process that accompanies a continuous change in electrical resistance. Our work suggests that if displacement forces can be implemented properly, it should be possible to emulate symmetric neuronal dynamics by using PCMs.
We have investigated the variation in the magnetization of highly ordered pyrolytic graphite (HOPG) after neutron irradiation, which introduces defects in the bulk sample and consequently gives rise to a large magnetic signal. We observe strong param
agnetism in HOPG, increasing with the neutron fluence. We correlate the induced paramagnetism with structural defects by comparison with density-functional theory calculations. In addition to the in-plane vacancies, the trans-planar defects also contribute to the magnetization. The lack of any magnetic order between the local moments is possibly due to the absence of hydrogen/nitrogen chemisorption, or the magnetic order cannot be established at all in the bulk form.
We discuss the roles of continuum linear elasticity and atomistic calculations in determining the formation volume and the strain energy of formation of a point defect in a crystal. Our considerations bear special relevance to defect formation under
stress. The elasticity treatment is based on the Greens function solution for a center of contraction or expansion in an anisotropic solid. It makes possible the precise definition of a formation volume tensor and leads to an extension of Eshelbys result for the work done by an external stress during the transformation of a continuum inclusion (Proc. Roy. Soc. Lond. Ser. A, 241 (1226) 376, 1957). Parameters necessary for a complete continuum calculation of elastic fields around a point defect are obtained by comparing with an atomistic solution in the far field. However, an elasticity result makes it possible to test the validity of the formation volume that is obtained via atomistic calculations under various boundary conditions. It also yields the correction term for formation volume calculated under these boundary conditions. Using two types of boundary conditions commonly employed in atomistic calculations, a comparison is also made of the strain energies of formation predicted by continuum elasticity and atomistic calculations. The limitations of the continuum linear elastic treatment are revealed by comparing with atomistic calculations of the formation volume and strain energies of small crystals enclosing point defects.
The formation of nano-sized, coherent, solute-rich clusters (NSRC) is known to be an important factor degrading the macroscopic properties of steels under irradiation. The mechanisms driving their formation are still debated. This work focuses on low
-Cu reactor pressure vessel (RPV) steels, where solute species are generally not expected to precipitate. We rationalize the processes taking place at the nanometre scale under irradiation, relying on the latest theoretical and experimental evidence on atomic-level diffusion and transport processes. These are compiled in a new model, based on the object kinetic Monte Carlo (OKMC) technique. We evaluate the relevance of the underlying physical assumptions by applying the model to a large variety of irradiation experiments. Our model predictions are compared with new experimental data obtained with atom probe tomography and small angle neutron scattering, complemented with information from the literature. The results of this study reveal that the role of immobilized self-interstitial atoms (SIA) loops dominates the nucleation process of NSRC.
Understanding the response of ceramics operating in extreme environments is of interest for a variety of applications. Ab initio molecular dynamic simulations have been used to investigate the effect of structure and $B$-site (=Ti, Zr) cation composi
tion of lanthanum-based oxides (La$_2$$B_2$O$_7$) on electronic-excitation-induced amorphization. We find that the amorphous transition in monoclinic layered perovskite La$_2$Ti$_2$O$_7$ occurs for a lower degree of electronic excitation than for cubic pyrochlore La$_2$Zr$_2$O$_7$. While in each case the formation of O$_2$-like molecules drives the structure to an amorphous state, an analysis of the polyhedral connection network reveals that the rotation of TiO$_6$ octahedra in the monoclinic phase can promote such molecule formation, while such octahedral rotation is not possible in the cubic phase. However, once the symmetry of the cubic structure is broken by substituting Ti for Zr, it becomes less resistant to amorphization. A compound made of 50% Ti and 50% Zr (La$_2$TiZrO$_7$) is found to be more resistant in the monoclinic than in the cubic phase, which may be related to the lower bandgap of the cubic phase. These results illustrate the complex interplay of structure and composition that give rise to the radiation resistance of these important functional materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
