اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSingle Crystalline Silver Films for Plasmonics: From Monolayer to Optically Thick Film
100
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Epitaxial growth of single crystalline noble metals on dielectric substrates has received tremendous attention recently due to their technological potentials as low loss plasmonic materials. Currently there are two different growth approaches, each with its strengths and weaknesses. One adopts a sophisticated molecular beam epitaxial procedure to grow atomically smooth epitaxial Ag films. However, the procedure is rather slow and becomes impractical to grow films with thickness > 50 nm. Another approach adopts a growth process using rapid e-beam deposition which is capable of growing single crystalline Ag films in the thick regime (> 300 nm). However, the rapid growth procedure makes it difficult to control film thickness precisely, i.e., the method is not applicable to growing thin epitaxial films. Here we report a universal approach to grow atomically smooth epitaxial Ag films with precise thickness control from a few monolayers to the optically thick regime, overcoming the limitations of the two aforementioned methods. In addition, we develop an in-situ growth of aluminum oxide as the capping layer which exhibits excellent properties protecting the epitaxial Ag films. The performance of the epitaxial Ag films as a function of the film thickness is investigated by directly measuring the propagation length of the surface plasmon polaritons (SPPs) as well as their device performance to support a waveguide plasmonic nanolaser in infrared incorporating an InGaAsP quantum well as the gain media.
قيم البحث
اقرأ أيضاً
Light-matter interaction at the atomic scale rules fundamental phenomena such as photoemission and lasing, while enabling basic everyday technologies, including photovoltaics and optical communications. In this context, plasmons --the collective elec
tron oscillations in conducting materials-- are important because they allow manipulating optical fields at the nanoscale. The advent of graphene and other two-dimensional crystals has pushed plasmons down to genuinely atomic dimensions, displaying appealing properties such as a large electrical tunability. However, plasmons in these materials are either too broad or lying at low frequencies, well below the technologically relevant near-infrared regime. Here we demonstrate sharp near-infrared plasmons in lithographically-patterned wafer-scale atomically-thin silver crystalline films. Our measured optical spectra reveal narrow plasmons (quality factor $sim4$), further supported by a low sheet resistance comparable to bulk metal in few-atomic-layer silver films down to seven Ag(111) monolayers. Good crystal quality and plasmon narrowness are obtained despite the addition of a thin passivating dielectric, which renders our samples resilient to ambient conditions. The observation of spectrally sharp and strongly confined plasmons in atomically thin silver holds great potential for electro-optical modulation and optical sensing applications.
We report herein fabrication and characterization of a thin-film transistor (TFT) using single-crystalline, epitaxial SrTiO3 film, which was grown by a pulsed laser deposition technique followed by the thermal annealing treatment in an oxygen atmosph
ere. Although TFTs on the polycrystalline epitaxial SrTiO3 films (as-deposited) exhibited poor transistor characteristics, the annealed single-crystalline SrTiO3 TFT exhibits transistor characteristics comparable with those of bulk single-crystal SrTiO3 FET: an on/off current ratio >10^5, sub-threshold swing ~2.1 V/decade, and field-effect mobility ~0.8 cm^2/Vs. This demonstrates the effectiveness of the appropriate thermal annealing treatment of epitaxial SrTiO3 films.
Two-dimensional (2D) transition metal dichalcogenides MX2 (M = Mo, W, X = S, Se, Te) attracts enormous research interests in recent years. Its 2H phase possesses an indirect to direct bandgap transition in 2D limit, and thus shows great application p
otentials in optoelectronic devices [1]. The 1T crystalline phase transition can drive the monolayer MX2 to be a 2D topological insulator. Here we realized the molecular beam epitaxial (MBE) growth of both the 1T and 2H phase monolayer WSe2 on bilayer graphene (BLG) substrate. The crystalline structures of these two phases were characterized using scanning tunneling microscopy. The monolayer 1T-WSe2 was found to be metastable, and can transform into 2H phase under post-annealing procedure. The phase transition temperature of 1T-WSe2 grown on BLG is lower than that of 1T phase grown on 2H-WSe2 layers. This thermo-driven crystalline phase transition makes the monolayer WSe2 to be an ideal platform for the controlling of topological phase transitions in 2D materials family.
In a rather contradictory situation regarding magnetic data on Co-doped ZnO, we have succeeded in fabricating high-quality single crystalline Zn1-xCoxO (x=0.003-0.07) thin films. This gives us the possibility, for the first time, to examine the it in
trinsic magnetic properties of ZnO:Co at a quantitative level and therefore to address several unsolved problems, the major one being the nature of the Co-Co interaction in the ZnO structure.
Plasmonics has established itself as a branch of physics which promises to revolutionize data processing, improve photovoltaics, increase sensitivity of bio-detection. A widespread use of plasmonic devices is notably hindered (in addition to high los
ses) by the absence of stable and inexpensive metal films suitable for plasmonic applications. This may seem surprising given the number of metal compounds to choose from. Unfortunately, most of them either exhibit a strong damping of surface plasmons or easily oxidize and corrode. To this end, there has been continuous search for alternative plasmonic materials that are, unlike gold, the current metal of choice in plasmonics, compatible with complementary metal oxide semiconductor technology. Here we show that copper and silver protected by graphene are viable candidates. Copper films covered with one to a few graphene layers show excellent plasmonics characteristics surpassing those of gold films. They can be used to fabricate plasmonic devices and survive for at least a year, even in wet and corroding conditions. As a proof of concept, we use the graphene-protected copper to demonstrate dielectric loaded plasmonic waveguides and test sensitivity of surface plasmon resonances. Our results are likely to initiate a wide use of graphene-protected plasmonics.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
