اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA Single-Crystalline, Epitaxial SrTiO3 Thin-Film Transistor
226
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report herein fabrication and characterization of a thin-film transistor (TFT) using single-crystalline, epitaxial SrTiO3 film, which was grown by a pulsed laser deposition technique followed by the thermal annealing treatment in an oxygen atmosphere. Although TFTs on the polycrystalline epitaxial SrTiO3 films (as-deposited) exhibited poor transistor characteristics, the annealed single-crystalline SrTiO3 TFT exhibits transistor characteristics comparable with those of bulk single-crystal SrTiO3 FET: an on/off current ratio >10^5, sub-threshold swing ~2.1 V/decade, and field-effect mobility ~0.8 cm^2/Vs. This demonstrates the effectiveness of the appropriate thermal annealing treatment of epitaxial SrTiO3 films.
قيم البحث
اقرأ أيضاً
The surface termination of (100)-oriented LaAlO3 (LAO) single crystals was examined by atomic force microscopy and optimized to produce a single-terminated atomically flat surface by annealing. Then the atomically flat STO film was achieved on a sing
le-terminated LAO substrate, which is expected to be similar to the n-type interface of two-dimensional electron gas (2DEG), i.e., (LaO)-(TiO2). Particularly, that can serve as a mirror structure for the typical 2DEG heterostructure to further clarify the origin of 2DEG. This newly developed interface was determined to be highly insulating. Additionally, this study demonstrates an approach to achieve atomically flat film growth based on LAO substrates.
Thin films of perovskite Ruthenates of the general formula ARuO3 (A = Ca and Sr) are versatile electrical conductors for viable oxide electronics. They are also scientifically intriguing, as they exhibit non-trivial electromagnetic ground states depe
nding on the A-site element. Among them, realization of the cubic perovskite (3C) BaRuO3 thin film has been a challenge so far, because the 3C phase is metastable with the largest formation energy among the various polymorph phases of BaRuO3. In this study, we successfully prepared 3C BaRuO3 thin films employing epitaxial stabilization. The 3C BaRuO3 thin films show itinerant ferromagnetism with a transition temperature of ~48 K and a non-Fermi liquid phase. The epitaxial stabilization of the 3C BaRuO3 further enabled us to make a standard comparison of perovskite Ruthenates thin films, thereby establishing the importance of the Ru-O orbital hybridization in understanding the itinerant magnetic system.
TbMnO$_{3}$ films have been grown under compressive strain on (001)-oriented SrTiO$_{3}$ crystals. They have an orthorhombic structure and display the (001) orientation. With increasing thickness, the structure evolves from a more symmetric (tetragon
al) to a less symmetric (bulk-like orthorhombic) structure, while keeping constant the in-plane compression thereby leaving the out-of-plane lattice spacing unchanged. The domain microstructure of the films is also revealed, showing an increasing number of orthorhombic domains as the thickness is decreased: we directly observe ferroelastic domains as narrow as 4nm. The high density of domain walls may explain the induced ferromagnetism observed in the films, while both the decreased anisotropy and the small size of the domains could account for the absence of a ferroelectric spin spiral phase.
Growth of perovskite oxide thin films on Si in crystalline form has long been a critical obstacle for the integration of multifunctional oxides into Si-based technologies. In this study, we propose pulsed laser deposition of a crystalline SrTiO3 thin
film on a Si using graphene substrate. The SrTiO3 thin film on graphene has a highly (00l)-oriented crystalline structure which results from the partial epitaxy. Moreover, graphene promotes a sharp interface by highly suppressing the chemical intermixing. The important role of graphene as a 2D substrate and diffusion barrier allows expansion of device applications based on functional complex oxides.
Strain engineering vanadium dioxide thin films is one way to alter this materials characteristic first order transition from semiconductor to metal. In this study we extend the exploitable strain regime by utilizing the very large lattice mismatch of
8.78 % occurring in the VO$_2$/RuO$_2$ system along the c axis of the rutile structure. We have grown VO$_2$ thin films on single domain RuO$_2$ islands of two distinct surface orientations by atomic oxygen-supported reactive MBE. These films were examined by spatially resolved photoelectron and x-ray absorption spectroscopy, confirming the correct stoichiometry. Low energy electron diffraction then reveals the VO$_2$ films to grow indeed fully strained on RuO$_2$(110), exhibiting a previously unreported ($2times2$) reconstruction. On TiO$_2$(110) substrates, we reproduce this reconstruction and attribute it to an oxygen-rich termination caused by the high oxygen chemical potential. On RuO$_2$(100) on the other hand, the films grow fully relaxed. Hence, the presented growth method allows for simultaneous access to a remarkable strain window ranging from bulk-like structures to massively strained regions.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
