اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTowards an optical FPGA - Programmable silicon photonic circuits
92
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A novel technique is presented for realising programmable silicon photonic circuits. Once the proposed photonic circuit is programmed, its routing is retained without the need for additional power consumption. This technology enables a uniform multi-purpose design of photonic chips for a range of different applications and performance requirements, as it can be programmed for each specific application after chip fabrication. Therefore the cost per chip can be dramatically reduced because of the increase in production volume, and rapid prototyping of new photonic circuits is enabled. Essential building blocks for programmable circuits, erasable directional couplers (DCs) were designed and fabricated, utilising ion implanted waveguides. We demonstrate permanent switching between the drop port and through port of the DCs using a localised post-fabrication laser annealing process. Proof-of-principle demonstrators in the form of generic 1X4 and 2X2 programmable switching circuits were then fabricated and subsequently programmed, to define their function.
قيم البحث
اقرأ أيضاً
We experimentally demonstrate an all-optical programmable thresholder on a silicon photonic circuit. By exploiting the nonlinearities in a resonator-enhanced Mach-Zehnder interferometer (MZI), the proposed optical thresholder can discriminate two opt
ical signals with very similar amplitudes. We experimentally achieve a signal contrast enhancement of 40, which leads to a bit error rate (BER) improvement by 5 orders of magnitude and a receiver sensitivity improvement of 11 dB. We present the thresholding function of our device and validate the function with experimental data. Furthermore, we investigate potential device speed improvement by reducing the carrier lifetime.
In integrated photonics, specific wavelengths are preferred such as 1550 nm due to low-loss transmission and the availability of optical gain in this spectral region. For chip-based photodetectors, layered two-dimensional (2D) materials bear scientif
ic and technologically-relevant properties leading to strong light-matter-interaction devices due to effects such as reduced coulomb screening or excitonic states. However, no efficient photodetector in the telecommunication C-band using 2D materials has been realized yet. Here, we demonstrate a MoTe2-based photodetector featuring strong photoresponse (responsivity = 0.5 A/W) operating at 1550nm on silicon photonic waveguide enabled by engineering the strain (4%) inside the photo-absorbing transition-metal-dichalcogenide film. We show that an induced tensile strain of ~4% reduces the bandgap of MoTe2 by about 0.2 eV by microscopically measuring the work-function across the device. Unlike Graphene-based photodetectors relying on a gapless band structure, this semiconductor-2D material detector shows a ~100X improved dark current enabling an efficient noise-equivalent power of just 90 pW/Hz^0.5. Such strain-engineered integrated photodetector provides new opportunities for integrated optoelectronic systems.
Low-loss photonic integrated circuits (PIC) and microresonators have enabled novel applications ranging from narrow-linewidth lasers, microwave photonics, to chip-scale optical frequency combs and quantum frequency conversion. To translate these resu
lts into a widespread technology, attaining ultralow optical losses with established foundry manufacturing is critical. Recent advances in fabrication of integrated Si3N4 photonics have shown that ultralow-loss, dispersion-engineered microresonators can be attained at die-level throughput. For emerging nonlinear applications such as integrated travelling-wave parametric amplifiers and mode-locked lasers, PICs of length scales of up to a meter are required, placing stringent demands on yield and performance that have not been met with current fabrication techniques. Here we overcome these challenges and demonstrate a fabrication technology which meets all these requirements on wafer-level yield, performance and length scale. Photonic microresonators with a mean Q factor exceeding 30 million, corresponding to a linear propagation loss of 1.0 dB/m, are obtained over full 4-inch wafers, as determined from a statistical analysis of tens of thousands of optical resonances and cavity ringdown with 19 ns photon storage time. The process operates over large areas with high yield, enabling 1-meter-long spiral waveguides with 2.4 dB/m loss in dies of only 5x5 mm size. Using a modulation response measurement self-calibrated via the Kerr nonlinearity, we reveal that, strikingly, the intrinsic absorption-limited Q factor of our Si3N4 microresonators exceeds a billion. Transferring the present Si3N4 photonics technology to standard commercial foundries, and merging it with silicon photonics using heterogeneous integration technology, will significantly expand the scope of todays integrated photonics and seed new applications.
We review some of the basic principles, fundamentals, technologies, architectures and recent advances leading to thefor the implementation of Field Programmable Photonic Field Arrays (FPPGAs).
A multitude of large-scale silicon photonic systems based on ring resonators have been envisioned for applications ranging from biomedical sensing to quantum computing and machine learning. Yet, due to the lack of a scalable solution for controlling
ring resonators, practical demonstrations have been limited to systems with only a few rings. Here, we demonstrate that large systems can be controlled only by using doped waveguide elements inside their rings whilst preserving their area and cost. We measure the large photoconductive changes of the waveguides for monitoring rings resonance conditions across high-dynamic ranges and leverage their thermo-optic effects for tuning. This allows us to control ring resonators without requiring additional components, complex tuning algorithms, or additional electrical I/Os. We demonstrate automatic resonance alignment of 31 rings of a 16x16 switch and of a 14-ring coupled resonator optical waveguide (CROW), making them the largest, yet most compact, automatically controlled silicon ring resonator circuits to date.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
