اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHighly efficient spin current generation by the spin Hall effect in Au$_{1-x}$Pt$_x$
180
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report very efficient spin current generation by the spin Hall effect in the alloy Au0.25Pt0.75, which, as determined by two different direct spin-orbit torque measurements, exhibits a giant internal spin Hall ratio of > 0.58 (anti-damping spin-orbit torque efficiency of ~ 0.35 in bilayers with Co), a relatively low resistivity of ~ 83 uOhm cm, an exceptionally large spin Hall conductivity of > 7.0x10^5 ohm^-1 m^-1, and a spin diffusion length of 1.7 nm. This work establishes Au0.25Pt0.75 as a milestone spin current generator that provides greater energy efficiency than that yet obtained with other heavy metals or with the topological insulators Bi2Se3 and (Bi,Se)2Te3. Our findings should advance spin-orbit torque-based fundamental research and benefit the development of new fast, efficient spin-orbit torque-driven magnetic memories, skyrmion and chiral domain wall devices, and microwave and terahertz emitters.
قيم البحث
اقرأ أيضاً
Efficient generation of spin-orbit torques (SOTs) is central for the exciting field of spin-orbitronics. Platinum, the archetypal spin Hall material, has the potential to be an outstanding provider for spin-orbit torques due to its giant spin Hall co
nductivity, low resistivity, high stabilities, and the ability to be compatible with CMOS circuits. However, pure clean-limit Pt with low resistivity still provides a low damping-like spin-orbit torque efficiency, which limits its practical applications. The efficiency of spin-orbit torque in Pt-based magnetic heterostructures can be improved considerably by increasing the spin Hall ratio of Pt and spin transmissivity of the interfaces. Here we reviews recent advances in understanding the physics of spin current generation, interfacial spin transport, and the metrology of spin-orbit torques, and summarize progress towards the goal of Pt-based spin-orbit torque memories and logic that are fast, efficient, reliable, scalable, and non-volatile.
The dependence of the spin-pumping effect on the yttrium iron garnet (Y3Fe5O12, YIG) thickness detected by the inverse spin Hall effect (ISHE) has been investigated quantitatively. Due to the spin-pumping effect driven by the magnetization precession
in the ferrimagnetic insulator YIG film a spin-polarized electron current is injected into the Pt layer. This spin current is transformed into electrical charge current by means of the ISHE. An increase of the ISHE-voltage with increasing film thickness is observed and compared to the theoretically expected behavior. The effective damping parameter of the YIG/Pt samples is found to be enhanced with decreasing YIG film thickness. The investigated samples exhibit a spin mixing conductance of g=(7.43 pm 0.36) times 10^{18} m^{-2} and a spin Hall angle of theta_{ISHE} = 0.009 pm 0.0008. Furthermore, the influence of nonlinear effects on the generated voltage and on the Gilbert damping parameter at high excitation powers are revealed. It is shown that for small YIG film thicknesses a broadening of the linewidth due to nonlinear effects at high excitation powers is suppressed because of a lack of nonlinear multi-magnon scattering channels. We have found that the variation of the spin-pumping efficiency for thick YIG samples exhibiting pronounced nonlinear effects is much smaller than the nonlinear enhancement of the damping.
We report on investigation of spin Hall magnetoresistance sensor based on NiFe/AuxPt1-x bilayers. Compared to NiFe/Pt, the NiFe/AuxPt1-x sensor exhibits a much lower power consumption (reduced by about 57%), due to 80% enhancement of spin-orbit torqu
e efficiency of AuxPt1-x at an optimum composition of x = 0.19 as compared to pure Pt. The enhanced spin-orbit torque efficiency allows to increase the thickness of NiFe from 1.8 nm to 2.5 nm without significantly increasing the power consumption. We show that, by increasing the NiFe thickness, we were able to improve the working field range (0.86 Oe), operation temperature range (150 degree C) and detectivity (0.71 nT/sqrt(Hz) at 1 Hz) of the sensor, which is important for practical applications.
We have studied the spin Hall magnetoresistance (SMR), the magnetoresistance within the plane transverse to the current flow, of Pt/Co bilayers. We find that the SMR increases with increasing Co thickness: the effective spin Hall angle for bilayers w
ith thick Co exceeds the reported values of Pt when a conventional drift-diffusion model is used. An extended model including spin transport within the Co layer cannot account for the large SMR. To identify its origin, contributions from other sources are studied. For most bilayers, the SMR increases with decreasing temperature and increasing magnetic field, indicating that magnon-related effects in the Co layer play little role. Without the Pt layer, we do not observe the large SMR found for the Pt/Co bilayers with thick Co. Implementing the effect of the so-called interface magnetoresistance and the textured induced anisotropic scattering cannot account for the Co thickness dependent SMR. Since the large SMR is present for W/Co but its magnitude reduces in W/CoFeB, we infer its origin is associated with a particular property of Co.
We have studied the spin orbit torque (SOT) in Pt/Co/Ir multilayers with 3 repeats of the unit structure. As the system exhibits oscillatory interlayer exchange coupling (IEC) with varying Ir layer thickness, we compare the SOT of films when the Co l
ayers are coupled ferromagnetically and antiferromagnetically. SOT is evaluated using current induced shift of the anomalous Hall resistance hysteresis loops. A relatively thick Pt layer, serving as a seed layer to the multilayer, is used to generate spin current via the spin Hall effect. In the absence of antiferromagnetic coupling, the SOT is constant against the applied current density and the corresponding spin torque efficiency (i.e. the effective spin Hall angle) is $sim$0.09, in agreement with previous reports. In contrast, for films with antiferromagnetic coupling, the SOT increases with the applied current density and eventually saturates. The SOT at saturation is a factor of $sim$15 larger than that without the antiferromagnetic coupling. The spin torque efficiency is $sim$5 times larger if we assume the net total magnetization is reduced by a factor of 3 due to the antiferromagnetic coupling. Model calculations based on the Landau Lifshitz Gilbert equation show that the presence of antiferromagnetic coupling can increase the SOT but the degree of enhancement is limited, in this case, to a factor of 1.2-1.4. We thus consider there are other sources of SOT, possibly at the interfaces, which may account for the highly efficient SOT in the uncompensated synthetic anti-ferromagnet (SAF) multilayers.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
