اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAn extreme ultraviolet wave generating upward secondary waves in a streamer-like solar structure
111
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Extreme ultraviolet (EUV) waves, spectacular horizontally propagating disturbances in the low solar corona, always trigger horizontal secondary waves (SWs) when they encounter ambient coronal structure. We present a first example of upward SWs in a streamer-like structure after the passing of an EUV wave. The event occurred on 2017 June 1. The EUV wave happened during a typical solar eruption including a filament eruption, a CME, a C6.6 flare. The EUV wave was associated with quasi-periodic fast propagating (QFP) wave trains and a type II radio burst that represented the existence of a coronal shock. The EUV wave had a fast initial velocity of $sim$1000 km s$^{-1}$, comparable to high speeds of the shock and the QFP wave trains. Intriguingly, upward SWs rose slowly ($sim$80 km s$^{-1}$) in the streamer-like structure after the sweeping of the EUV wave. The upward SWs seemed to originate from limb brightenings that were caused by the EUV wave. All the results show the EUV wave is a fast-mode magnetohydrodynamic shock wave, likely triggered by the flare impulses. We suggest that part of the EUV wave was probably trapped in the closed magnetic fields of streamer-like structure, and upward SWs possibly resulted from the release of trapped waves in the form of slow-mode. It is believed that an interplay of the strong compression of the coronal shock and the configuration of the streamer-like structure is crucial for the formation of upward SWs.
قيم البحث
اقرأ أيضاً
Extreme ultraviolet (EUV) waves are impressive coronal propagating disturbances. They are closely associated with various eruptions, and can used for the global coronal seismology and the acceleration of solar energetic particles. Hence, the study of
EUV waves plays an important role in solar eruptions and Space Weather. Here we present an EUV wave associated with a filament activation that did not evolve into any eruption. Due to the continuous magnetic flux emergence and cancellation around its one end, the filament rose with untwisting motion, and the filament mass flowed towards another end along the rising fields. Intriguingly, following the filament activation, an EUV wave formed with a fast constant speed ($sim$500 km s$^{-1}$) ahead of the mass flow, and the overlying coronal loops expanded both in lateral and radial directions. Excluding the possibility of a remote flare and an absent coronal mass ejection, we suggest that the EUV wave was only closely associated with the filament activation. Furthermore, their intimate spacial and temporal relationship indicates that the EUV wave was likely directly triggered by the lateral expansion of overlying loops. We propose that the EUV wave can be interpreted as linear fast-mode wave, and the most vital key for the successful generation of the EUV wave is the impulsive early-phase lateral expansion of overlying loops that was driven by the activated filament mass flow without any eruption.
So far most studies on the structure of coronal mass ejections (CMEs) are conducted through white-light coronagraphs, which demonstrate about one third of CMEs exhibit the typical three-part structure in the high corona (e.g., beyond 2 Rs), i.e., the
bright front, the dark cavity and the bright core. In this paper, we address the CME structure in the low corona (e.g., below 1.3 Rs) through extreme-ultraviolet (EUV) passbands and find that the three-part CMEs in the white-light images can possess a similar three-part appearance in the EUV images, i.e., a leading edge, a low-density zone, and a filament or hot channel. The analyses identify that the leading edge and the filament or hot channel in the EUV passbands evolve into the front and the core later within several solar radii in the white-light passbands, respectively. Whats more, we find that the CMEs without obvious cavity in the white-light images can also exhibit the clear three-part appearance in the EUV images, which means that the low-density zone in the EUV images (observed as the cavity in white-light images) can be compressed and/or transformed gradually by the expansion of the bright core and/or the reconnection of magnetic field surrounding the core during the CME propagation outward. Our study suggests that more CMEs can possess the clear three-part structure in their early eruption stage. The nature of the low-density zone between the leading edge and the filament or hot channel is discussed.
Magnetic reconnection, a change of magnetic field connectivity, is a fundamental physical process in which magnetic energy is released explosively. It is responsible for various eruptive phenomena in the universe. However, this process is difficult t
o observe directly. Here, the magnetic topology associated with a solar reconnection event is studied in three dimensions (3D) using the combined perspectives of two spacecraft. The sequence of extreme ultraviolet (EUV) images clearly shows that two groups of oppositely directed and non-coplanar magnetic loops gradually approach each other, forming a separator or quasi-separator and then reconnecting. The plasma near the reconnection site is subsequently heated from $sim$1 to $ge$5 MK. Shortly afterwards, warm flare loops ($sim$3 MK) appear underneath the hot plasma. Other observational signatures of reconnection, including plasma inflows and downflows, are unambiguously revealed and quantitatively measured. These observations provide direct evidence of magnetic reconnection in a 3D configuration and reveal its origin.
Recent observations in extreme-ultraviolet (EUV) wavelengths reveal a new late phase in some solar flares, which is seen as a second peak in warm coronal emissions ($sim3$ MK) several tens of minutes to a few hours after the soft X-ray (SXR) peak. Th
e origin of the EUV late phase (ELP) is explained by either a long-lasting cooling process in the long ELP loops, or a delayed energy ejection into the ELP loops well after the main flare heating. Using the observations with the emph{Solar Dynamics Observatory} (emph{SDO}), we investigate the production of the ELP in six homologous flares (F1--F6) originating from a complex active region (AR) NOAA 11283, with an emphasis on the emission characteristics of the flares. It is found that the main production mechanism of the ELP changes from additional heating in flare F1 to long-lasting cooling in flares F3--F6, with both mechanisms playing a role in flare F2. The transition is evidenced by an abrupt decrease of the time lag of the ELP peak, and the long-lasting cooling process in the majority of the flares is validated by a positive correlation between the flare ribbon fluence and the ELP peak intensity. We attribute the change in ELP production mechanism to an enhancement of the envelope magnetic field above the AR, which facilitates a more prompt and energetic heating of the ELP loops. In addition, the last and the only confined flare F6 exhibits an extremely large ELP. The different emission pattern revealed in this flare may reflect a different energy partitioning inside the ELP loops, which is due to a different magnetic reconnection process.
The slow solar wind exhibits strong variability on timescales from minutes to days, likely related to magnetic reconnection processes in the extended solar corona. Higginson2017b presented a numerical magnetohydrodynamic simulation which showed inter
change magnetic reconnection is ubiquitous and most likely responsible for releasing much of the slow solar wind, in particular along topological features known as the Separatrix-Web (S-Web). Here, we continue our analysis, focusing on two specific aspects of structured slow solar wind variability. The first type is present in the slow solar wind found near the heliospheric current sheet, and the second we predict should be present everywhere S-Web slow solar wind is observed. For the first type, we examine the evolution of three-dimensional magnetic flux ropes formed at the top of the helmet streamer belt by reconnection in the heliospheric current sheet (HCS). For the second, we examine the simulated remote and in situ signatures of the large-scale torsional Alfven wave (TAW) which propagates along an S-Web arc to high latitudes. We describe the similarities and differences between the reconnection-generated flux ropes in the HCS, which resemble the well-known streamer blob observations, and the similarly structured TAW. We discuss the implications of our results for the complexity of the HCS and surrounding plasma sheet, and the potential for particle acceleration, as well as the interchange reconnection scenarios which may generate TAWs in the solar corona. We discuss predictions from our simulation results for the dynamic slow solar wind in the extended corona and inner heliosphere.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
