اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSimple sampling clock synchronisation scheme for reduced-guard-interval coherent optical OFDM systems
185
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A simple data-aided scheme for sampling clock synchronisation in reduced-guard-interval coherent optical orthogonal frequency division multiplexing (RGI-CO-OFDM) systems is proposed. In the proposed scheme, the sampling clock offset (SCO) is estimated by using the training symbols reserved for channel estimation, thus avoiding extra training overhead. The SCO is then compensated by resampling, using a time-domain interpolation filter. The feasibility of the proposed scheme is demonstrated by means of numerical simulations in a 32-Gbaud 16-QAM dual-polarisation RGI-CO-OFDM system.
قيم البحث
اقرأ أيضاً
A novel joint symbol timing and carrier frequency offset (CFO) estimation algorithm is proposed for reduced-guard-interval coherent optical orthogonal frequency-division multiplexing (RGI-CO-OFDM) systems. The proposed algorithm is based on a constan
t amplitude zero autocorrelation (CAZAC) sequence weighted by a pseudo-random noise (PN) sequence. The symbol timing is accomplished by using only one training symbol of two identical halves, with the weighting applied to the second half. The special structure of the training symbol is also utilized in estimating the CFO. The performance of the proposed algorithm is demonstrated by means of numerical simulations in a 115.8-Gb/s 16-QAM RGI-CO-OFDM system.
In this paper, we propose a linear polarization coding scheme (LPC) combined with the phase conjugated twin signals (PCTS) technique, referred to as LPC-PCTS, for fiber nonlinearity mitigation in coherent optical orthogonal frequency division multipl
exing (CO-OFDM) systems. The LPC linearly combines the data symbols on the adjacent subcarriers of the OFDM symbol, one at full amplitude and the other at half amplitude. The linearly coded data is then transmitted as phase conjugate pairs on the same subcarriers of the two OFDM symbols on the two orthogonal polarizations. The nonlinear distortions added to these subcarriers are essentially anti-correlated, since they carry phase conjugate pairs of data. At the receiver, the coherent superposition of the information symbols received on these pairs of subcarriers eventually leads to the cancellation of the nonlinear distortions. We conducted numerical simulation of a single channel 200 Gb/s CO-OFDM system employing the LPCPCTS technique. The results show that a Q-factor improvement of 2.3 dB and 1.7 dB with and without the dispersion symmetry, respectively, when compared to the recently proposed phase conjugated subcarrier coding (PCSC) technique, at an average launch power of 3 dBm. In addition, our proposed LPCPCTS technique shows a significant performance improvement when compared to the 16-quadrature amplitude modulation (QAM) with phase conjugated twin waves (PCTW) scheme, at the same spectral efficiency, for an uncompensated transmission distance of 2800 km.
A joint frame and carrier frequency synchronization algorithm for coherent optical systems, based on the digital computation of the fractional Fourier transform (FRFT), is proposed. The algorithm utilizes the characteristics of energy centralization
of chirp signals in the FRFT domain, together with the time and phase shift properties of the FRFT. Chirp signals are used to construct a training sequence (TS), and fractional cross-correlation is employed to define a detection metric for the TS, from which a set of equations can be obtained. Estimates of both the timing offset and carrier frequency offset (CFO) are obtained by solving these equations. This TS is later employed in a phase-dependent decision-directed least-mean square algorithm for adaptive equalization. Simulation results of a 32-Gbaud coherent polarization division multiplexed Nyquist system show that the proposed scheme has a wide CFO estimation range and accurate synchronization performance even in poor optical signal-to-noise ratio conditions.
In this work, we address the important question of adaptability of artificial neural networks (NNs) used for impairment mitigation in optical transmission systems. We demonstrate that by using well-developed techniques based on the concept of transfe
r learning, we can efficaciously retrain NN-based equalizers to adapt changes in the transmission system using just a fraction of the initial training data and epochs. We evaluate the potential of transfer learning to adapt the NN to changes in the launch powers, modulation formats, symbol rates, or even fiber plants (different fiber types and lengths). The numerical examples utilize the recently introduced NN equalizer consisting of a convolutional layer coupled with bi-directional long-short term memory (biLSTM) recurrent NN element. Our analysis focuses on long-haul coherent optical transmission systems for two types of fibers: the standard single-mode fiber (SSMF) and the TrueWave Classic (TWC) fiber. We underline the specific peculiarities that occur when transferring the learning in coherent optical communication systems and draw the limits for the transfer learning efficiency. Our results demonstrate the effectiveness of transfer learning for the fast adaptation of NN architectures to different transmission regimes and scenarios, paving the way for engineering flexible and universal solutions for nonlinearity mitigation.
Reconfigurable intelligent surface (RIS) based reflection modulation has been considered as a promising information delivery mechanism, and has the potential to realize passive information transfer of a RIS without consuming any additional radio freq
uency chain and time/frequency/energy resources. The existing on-off reflection modulation (ORM) schemes are based on manipulating the ``on/off states of RIS elements, which may lead to the degradation of RIS reflection efficiency. This paper proposes a frequency reflection modulation (FRM) method for RIS-aided OFDM systems. The FRM-OFDM scheme modulates the frequency of the incident electromagnetic waves, and the RIS information is embedded in the frequency-hoping states of RIS elements. Unlike the ORM-OFDM scheme, the FRM-OFDM scheme can achieve higher reflection efficiency, since the latter does not turn off any reflection element in reflection modulation. We propose a block coordinate descent (BCD) algorithm to maximize the user achievable rate for the FRM-OFDM system by jointly optimizing the phase shift of the RIS and the power allocation at the transmitter. Further, we design a bilinear message passing (BMP) algorithm for the bilinear recovery of both the user symbols and the RIS data. Numerical simulations have verified the efficiency of the designed BCD algorithm for system optimization and the BMP algorithm for signal detection, as well as the superiority of the proposed FRM-OFDM scheme over the ORM-OFDM scheme.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
