اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA Simple Nonlinearity-Tailored Probabilistic Shaping Distribution for Square QAM
59
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A new probabilistic shaping distribution that outperforms Maxwell-Boltzmann is studied for the nonlinear fiber channel. Additional gains of 0.1 bit/symbol MI or 0.2 dB SNR for both DP-256QAM and DP-1024QAM are reported after 200 km nonlinear fiber transmission.
قيم البحث
اقرأ أيضاً
Achievable information rates (AIRs) of wideband optical communication systems using ~40 nm (~5 THz) EDFA and ~100 nm (~12.5 THz) distributed Raman amplification are estimated based on a first-order perturbation analysis. The AIRs of each individual c
hannel have been evaluated for DP-64QAM, DP-256QAM, and DP-1024QAM modulation formats. The impact of full-field nonlinear compensation (FF-NLC) and probabilistically shaped constellations using a Maxwell-Boltzmann distribution were studied and compared to electronic dispersion compensation. It is found that a probabilistically shaped DP-1024QAM constellation combined with FF-NLC yields AIRs of ~75 Tbit/s for the EDFA scheme and ~223 Tbit/s for the Raman amplification scheme over 2000 km standard single mode fibre transmission.
In this paper, probabilistic shaping is numerically and experimentally investigated for increasing the transmission reach of wavelength division multiplexed (WDM) optical communication system employing quadrature amplitude modulation (QAM). An optimi
zed probability mass function (PMF) of the QAM symbols is first found from a modified Blahut-Arimoto algorithm for the optical channel. A turbo coded bit interleaved coded modulation system is then applied, which relies on many-to-one labeling to achieve the desired PMF, thereby achieving shaping gain. Pilot symbols at rate at most 2% are used for synchronization and equalization, making it possible to receive input constellations as large as 1024QAM. The system is evaluated experimentally on a 10 GBaud, 5 channels WDM setup. The maximum system reach is increased w.r.t. standard 1024QAM by 20% at input data rate of 4.65 bits/symbol and up to 75% at 5.46 bits/symbol. It is shown that rate adaptation does not require changing of the modulation format. The performance of the proposed 1024QAM shaped system is validated on all 5 channels of the WDM signal for selected distances and rates. Finally, it was shown via EXIT charts and BER analysis that iterative demapping, while generally beneficial to the system, is not a requirement for achieving the shaping gain.
We propose multi-dimensional short blocklength probabilistic shaping to increase the nonlinear tolerance gain in digital subcarrier multiplexing transmission systems and demonstrate an improvement in performance compared to lower dimensional formats.
In optical communication systems, short blocklength probabilistic enumerative sphere shaping (ESS) provides both linear shaping gain and nonlinear tolerance. In this work, we investigate the performance and complexity of ESS in comparison with fiber
nonlinearity compensation via digital back propagation (DBP) with different steps per span. We evaluate the impact of the shaping blocklength in terms of nonlinear tolerance and also consider the case of ESS with a Volterra-based nonlinear equalizer (VNLE), which provides lower complexity than DBP. In single-channel transmission, ESS with VNLE achieves similar performance in terms of finite length bit-metric decoding rate to uniform signaling with one step per span DBP. In the context of a dense wavelength-division multiplexing (WDM) transmission system, we show that ESS outperforms uniform signaling with DBP for different step sizes.
Probabilistic amplitude shaping (PAS) can flexibly vary the spectral efficiency (SE) of fiber-optic systems. In this paper, we demonstrate the application of PAS to bit-wise hard decision decoding (HDD) of product codes (PCs) by finding the necessary
conditions to select the PC component codes. We show that PAS with PCs and HDD yields gains up to $2.7$ dB and SE improvement up to approximately $1$ bit/channel use compared to using PCs with uniform signaling and HDD. Furthermore, we employ the recently introduced iterative bounded distance decoding with combined reliability of PCs to improve performance of PAS with PCs and HDD.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
