اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn the surface physics affecting solar oscillation frequencies
62
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Adiabatic oscillation frequencies of stellar models, computed with the standard mixing-length formulation for convection, increasingly deviate with radial order from observations in solar-like stars. Standard solar models overestimate adiabatic frequencies by as much as ~ 20 {mu}Hz. In this letter, we address the physical processes of turbulent convection that are predominantly responsible for the frequency differences between standard models and observations, also called `surface effects. We compare measured solar frequencies from the MDI instrument on the SOHO spacecraft with frequency calculations that include three-dimensional (3D) hydrodynamical simulation results in the equilibrium model, nonadiabatic effects, and a consistent treatment of the turbulent pressure in both the equilibrium and stability computations. With the consistent inclusion of the above physics in our model computation we are able to reproduce the observed solar frequencies to < 3 {mu}Hz without the need of any additional ad-hoc functional corrections.
قيم البحث
اقرأ أيضاً
The CoRoT and Kepler missions have provided high-quality measurements of the frequency spectra of solar-like pulsators, enabling us to probe stellar interiors with a very high degree of accuracy by comparing the observed and modeled frequencies. Howe
ver, the frequencies computed with 1D models suffer from systematic errors related to the poor modeling of the uppermost layers of stars. These biases are what is commonly named the near surface effect. The dominant effect is related to the turbulent pressure that modifies the hydrostatic equilibrium and thus the frequencies. This has already been investigated using grids of 3D RMHD simulations, which also were used to constrain the parameters of the empirical correction models. However, the effect of metallicity has not been considered so far. We study the impact of metallicity on the surface effect across the HR diagram, and provide a method for accounting for it when using the empirical correction models. We computed a grid of patched 1D stellar models with the stellar evolution code CESTAM in which poorly modeled surface layers have been replaced by averaged stratification computed with the 3D RMHD code CO5BOLD. We found that metallicity has a strong impact on the surface effect: keeping T_eff and log g constant, the frequency residuals can vary by up to a factor two. Therefore, the influence of metallicity cannot be neglected. We found that a correct way of accounting for it is to consider the surface Rosseland mean opacity. It allowed us to give a physically-grounded justification as well as a scaling relation for the frequency differences at nu_max as a function of T_eff, log g and kappa. Finally, we provide prescriptions for the fitting parameters of the correction functions. We show that the impact of metallicity through the Rosseland mean opacity must be taken into account when studying and correcting the surface effect.
Accurate modelling of solar-like oscillators requires that modelled mode frequencies are corrected for the systematic shift caused by improper modelling of the near-surface layers, known as the surface effect. ... We investigate how much additional u
ncertainty is introduced to stellar model parameters by our uncertainty about the functional form of the surface effect. At the same time, we test whether any of the parametrizations is significantly better or worse at modelling observed subgiants and low-luminosity red giants. We model six stars observed by Kepler that show clear mixed modes. We fix the input physics of the stellar models and vary the choice of surface correction ... Models using a solar-calibrated power law correction consistently fit the observations more poorly than the other four corrections. Models with the remaining four corrections generally fit ... about equally well, with the combined surface correction by Ball & Gizon perhaps being marginally superior. The fits broadly agree on the model parameters within about the $2sigma$ uncertainties, with discrepancies between the modified Lorentzian and free power law corrections occasionally exceeding the $3sigma$ level. Relative to the best-fitting values, the total uncertainties on the masses, radii and ages of the stars are all less than 2, 1 and 6 per cent, respectively. A solar-calibrated power law ... appears unsuitable for use with more evolved solar-like oscillators. Among the remaining surface corrections, the uncertainty in the model parameters introduced by the surface effects is about twice as large as the uncertainty in the individual fits for these six stars. Though the fits are thus somewhat less certain because of our uncertainty of how to manage the surface effect, these results also demonstrate that it is feasible to model the individual mode frequencies of subgiants and low-luminosity red giants. ...
For the very best and brightest asteroseismic solar-type targets observed by Kepler, the frequency precision is sufficient to determine the acoustic depths of the surface convective layer and the helium ionization zone. Such sharp features inside the
acoustic cavity of the star, which we call acoustic glitches, create small oscillatory deviations from the uniform spacing of frequencies in a sequence of oscillation modes with the same spherical harmonic degree. We use these oscillatory signals to determine the acoustic locations of such features in 19 solar-type stars observed by the Kepler mission. Four independent groups of researchers utilized the oscillation frequencies themselves, the second differences of the frequencies and the ratio of the small and large separation to locate the base of the convection zone and the second helium ionization zone. Despite the significantly different methods of analysis, good agreement was found between the results of these four groups, barring a few cases. These results also agree reasonably well with the locations of these layers in representative models of the stars. These results firmly establish the presence of the oscillatory signals in the asteroseismic data and the viability of several techniques to determine the location of acoustic glitches inside stars.
Los Alamos National Laboratory has calculated a new generation of radiative opacities (OPLIB data using the ATOMIC code) for elements with atomic number Z=1-30 with improved physics input, updated atomic data, and finer temperature grid to replace th
e Los Alamos LEDCOP opacities released in the year 2000. We calculate the evolution of standard solar models including these new opacities, and compare with models evolved using the Lawrence Livermore National Laboratory OPAL (Iglesias and Rogers 1996) opacities. We use the solar abundance mixture of Asplund et al. (2009). The new Los Alamos ATOMIC opacities have steeper opacity derivatives than those of OPAL for temperatures and densities of the solar interior radiative zone. We compare the calculated nonadiabatic solar oscillation frequencies and solar interior sound speed to observed frequencies and helioseismic inferences. The calculated sound-speed profiles are similar for models evolved using either the updated Iben evolution code (see cite{Guzik2010}), or the MESA evolution code (Paxton et al., 2015). The LANL ATOMIC opacities partially mitigate the solar abundance problem.
This review article summarizes the advancement in the studies of Earth-affecting solar transients in the last decade that encompasses most of solar cycle 24. The Sun Earth is an integrated physical system in which the space environment of the Earth s
ustains continuous influence from mass, magnetic field and radiation energy output of the Sun in varying time scales from minutes to millennium. This article addresses short time scale events, from minutes to days that directly cause transient disturbances in the Earth space environment and generate intense adverse effects on advanced technological systems of human society. Such transient events largely fall into the following four types: (1) solar flares, (2) coronal mass ejections (CMEs) including their interplanetary counterparts ICMEs, (3) solar energetic particle (SEP) events, and (4) stream interaction regions (SIRs) including corotating interaction regions (CIRs). In the last decade, the unprecedented multi viewpoint observations of the Sun from space, enabled by STEREO Ahead/Behind spacecraft in combination with a suite of observatories along the Sun-Earth lines, have provided much more accurate and global measurements of the size, speed, propagation direction and morphology of CMEs in both 3-D and over a large volume in the heliosphere. Several advanced MHD models have been developed to simulate realistic CME events from the initiation on the Sun until their arrival at 1 AU. Much progress has been made on detailed kinematic and dynamic behaviors of CMEs, including non-radial motion, rotation and deformation of CMEs, CME-CME interaction, and stealth CMEs and problematic ICMEs. The knowledge about SEPs has also been significantly improved.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
