اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدReaching 5E-13 short term frequency stability of the integrating sphere cold atom clock
59
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present an improvement of short term frequency stability of the integrating sphere cold atom clock after increasing the intensities of clock signals and optimizing the feedback loop of the clock. A short term frequency stability of $5.0times10^{-13}tau^{-1/2}$ has been achieved and the limiting factors have been analyzed.
قيم البحث
اقرأ أيضاً
Clocks based on cold atoms offer unbeatable accuracy and long-term stability, but their use in portable quantum technologies is hampered by a large physical footprint. Here, we use the compact optical layout of a grating magneto-optical trap (gMOT) f
or a precise frequency reference. The gMOT collects $10^7$ $^{87}$Rb atoms, which are subsequently cooled to $20,mu$K in optical molasses. We optically probe the microwave atomic ground-state splitting using lin$perp$lin polarised coherent population trapping and a Raman-Ramsey sequence. With ballistic drop distances of only $0.5,$mm, the measured short-term fractional frequency stability is $2 times 10 ^{-11} /sqrt{tau}$.
In this paper, we present an experiment to measure the spatial distribution of cold atoms in a ceramic integrating sphere. An quadrupole field is applied after the atoms are cooled by diffuse light produced in the ceramic integrating sphere, thus the
shift of atomic magnetic sub-levels are position-dependent. We move the anti-Helmholtz coil horizontally while keeping the probe laser beam resonant with the cold atoms at the zero magnetic field. The absorption of the probe beam gives the number of cold atoms at different position. The results show that at the center of the integrating sphere, less atoms exist due to the leakage of diffuse light into the hole connecting to the vacuum pump. The method we developed in this paper is useful to detect cold atoms in a region where imaging is not possible.
Atomic clocks based on optical transitions are the most stable, and therefore precise, timekeepers available. These clocks operate by alternating intervals of atomic interrogation with dead time required for quantum state preparation and readout. Thi
s non-continuous interrogation of the atom system results in the Dick effect, an aliasing of frequency noise of the laser interrogating the atomic transition. Despite recent advances in optical clock stability achieved by improving laser coherence, the Dick effect has continually limited optical clock performance. Here we implement a robust solution to overcome this limitation: a zero-dead-time optical clock based on the interleaved interrogation of two cold-atom ensembles. This clock exhibits vanishingly small Dick noise, thereby achieving an unprecedented fractional frequency instability of $6 times 10^{-17} / sqrt{tau}$ for an averaging time $tau$ in seconds. We also consider alternate dual-atom-ensemble schemes to extend laser coherence and reduce the standard quantum limit of clock stability, achieving a spectroscopy line quality factor $Q> 4 times 10^{15}$.
Optical frequency combs provide the clockwork to relate optical frequencies to radio frequencies. Hence, combs allow to measure optical frequencies with respect to a radio frequency where the accuracy is limited only by the reference signal. In order
to provide a stable link between the radio and optical frequencies, the two parameters of the frequency comb must be fixed: the carrier envelope offset frequency $f_{rm ceo}$ and the pulse repetition-rate $f_{rm rep}$. We have developed the first optical frequency comb based on difference frequency generation (DFG) that eliminates $f_{rm ceo}$ by design - specifically tailored for applications in cold atom physics. An $f_{rm ceo}$-free spectrum at 1550 nm is generated from a super continuum spanning more than an optical octave. Established amplification and frequency conversion techniques based on reliable telecom fiber technology allow generation of multiple wavelength outputs. In this paper we discuss the frequency comb design, characterization, and optical frequency measurement of Sr Rydberg states. The DFG technique allows for a compact and robust, passively $f_{rm ceo}$ stable frequency comb significantly improving reliability in practical applications.
Vapor cell atomic clocks exhibit reduced frequency stability for averaging time between about one hundred and a few thousand seconds. Here we report a study on the impact of the main parameters on the mid-to-long term instability of a buffer-gas vapo
r cell Cs clock, based on coherent population trapping (CPT). The CPT signal is observed on the Cs D1 line transmission, using a double $Lambda$ scheme and a Ramsey interrogation technique. The effects on the clock frequency of the magnetic field, the cell temperature, and the laser intensities are reported. We show in particular that the laser intensity shift is temperature dependent. Along with the laser intensity ratio and laser polarization properties, this is one of the most important parameters.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
