اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSolar opacity calculations using the super-transition-array method
205
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A new opacity model based on the Super-Transition-Array (STA) method for the calculation of monochromatic opacities of local thermodynamic equilibrium plasmas, was developed. The atomic code, named STAR (STA-Revised), is described and used to calculate spectral opacities for a solar model implementing the recent AGSS09 composition. Calculations are carried throughout the solar radiative zone. The relative contributions of different chemical elements and atomic processes to the total Rosseland mean opacity are analyzed in detail. Monochromatic opacities and charge state distributions were compared with the widely used Opacity-Project (OP) code, for several elements near the radiation-convection interface. STAR Rosseland opacities for the solar mixture show a very good agreement with OP and the OPAL opacity code, throughout the radiation zone. Finally, an explicit STA calculation of the full AGSS09 photospheric mixture, including all heavy metals was performed. It was shown that due to their extremely low abundance, and despite being very good photon absorbers, the heavy elements do not affect the Rosseland opacity.
قيم البحث
اقرأ أيضاً
The calculation of line widths constitutes theoretical and computational challenges in the calculation of opacities of hot dense plasmas. Opacity models use line broadening approximations that are untested at stellar interior conditions. Moreover, ca
lculations of atomic spectra of the sun, indicate a large discrepancy in the K-shell line widths between several atomic codes and the OP. In this work, the atomic code STAR is used to study the sensitivity of solar opacities to line-broadening. Variations in the solar opacity profile, due to an increase of the Stark widths resulting from discrepancies with OP, are compared, in light of the solar opacity problem, with the required opacity variations of the present day sun, as imposed by helioseismic and neutrino observations. The resulting variation profile, is much larger than the discrepancy between different atomic codes, agrees qualitatively with the missing opacity profile, recovers about half of the missing opacity nearby the convection boundary and has a little effect in the internal regions. Since it is hard to estimate quantitatively the uncertainty in the Stark widths, we show that an increase of all line widths by a factor of about 100 recovers quantitatively the missing opacity. These results emphasize the possibility that photoexcitation processes are not modeled properly, and more specifically, highlight the need for a better theoretical characterization of the line broadening phenomena at stellar interior conditions and of the uncertainty due to the way it is implemented by atomic codes.
Intending to solve the decade old problem of solar opacity, we report substantial photoabsorption uncertainty due to the effect of ion-ion correlations. By performing detailed opacity calculations of the solar mixture, we find that taking into accoun
t the ionic structure changes the Rosseland opacity near the convection zone by about 10%. We also report about 15% difference in the Rosseland opacity for iron, which was recently measured at the Sandia Z facility, where the temperature reached that prevailing in the convection zone boundary while the density is 2.5 times lower. Finally, we propose a method to measure opacities at solar temperatures and densities that were never reached in the past via laboratory radiation flow experiments, by using plastic foams doped with permilles of dominant photon absorbers in the Sun. The method is advantageous for an experimental study of solar opacities that may lead to a resolution of the solar problem.
Coalescence of binary neutron star give rise to electromagnetic emission, kilonova, powered by radioactive decays of r-process nuclei. Observations of kilonova associated with GW170817 provided unique opportunity to study the heavy element synthesis
in the Universe. However, atomic data of r-process elements to decipher the light curves and spectral features of kilonova are not fully constructed yet. In this paper, we perform extended atomic calculations of neodymium (Nd, Z=60) to study the impact of accuracies in atomic calculations to the astrophysical opacities. By employing multiconfiguration Dirac-Hartree-Fock and relativistic configuration interaction methods, we calculate energy levels and transition data of electric dipole transitions for Nd II, Nd III, and Nd IV ions. Compared with previous calculations, our new results provide better agreement with the experimental data. The accuracy of energy levels was achieved in the present work 10 %, 3 % and 11 % for Nd II, Nd III and Nd IV, respectively, comparing with the NIST database. We confirm that the overall properties of the opacity are not significantly affected by the accuracies of the atomic calculations. The impact to the Planck mean opacity is up to a factor of 1.5, which affects the timescale of kilonova at most 20 %. However, we find that the wavelength dependent features in the opacity are affected by the accuracies of the calculations. We emphasize that accurate atomic calculations, in particular for low-lying energy levels, are important to provide predictions of kilonova light curves and spectra.
Opacity is an important ingredient of the evolution of stars. The calculation of opacity coefficients is complicated by the fact that the plasma contains partially ionized heavy ions that contribute to opacity dominated by H and He. Up to now, the as
trophysical community has greatly benefited from the work of the contributions of Los Alamos [1], Livermore [2] and the Opacity Project (OP) [3]. However unexplained differences of up to 50% in the radiative forces and Rosseland mean values for Fe have been noticed for conditions corresponding to stellar envelopes. Such uncertainty has a real impact on the understanding of pulsating stellar envelopes, on the excitation of modes, and on the identification of the mode frequencies. Temperature and density conditions equivalent to those found in stars can now be produced in laboratory experiments for various atomic species. Recently the photo-absorption spectra of nickel and iron plasmas have been measured during the LULI 2010 campaign, for temperatures between 15 and 40 eV and densities of ~3 mg/cm3. A large theoretical collaboration, the OPAC, has been formed to prepare these experiments. We present here the set of opacity calculations performed by eight different groups for conditions relevant to the LULI 2010 experiment and to astrophysical stellar envelope conditions.
Seismology of stars is strongly developing. To address this question we have formed an international collaboration OPAC to perform specific experimental measurements, compare opacity calculations and improve the opacity calculations in the stellar co
des [1]. We consider the following opacity codes: SCO, CASSANDRA, STA, OPAS, LEDCOP, OP, SCO-RCG. Their comparison has shown large differences for Fe and Ni in equivalent conditions of envelopes of type II supernova precursors, temperatures between 15 and 40 eV and densities of a few mg/cm3 [2, 3, 4]. LEDCOP, OPAS, SCO-RCG structure codes and STA give similar results and differ from OP ones for the lower temperatures and for spectral interval values [3]. In this work we discuss the role of Configuration Interaction (CI) and the influence of the number of used configurations. We present and include in the opacity code comparisons new HULLAC-v9 calculations [5, 6] that include full CI. To illustrate the importance of this effect we compare different CI approximations (modes) available in HULLAC-v9 [7]. These results are compared to previous predictions and to experimental data. Differences with OP results are discussed.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
