اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدXPS studies on AlN thin films grown by ion beam sputtering in reactive assistance of N+/N2+ ions: Substrate temperature induced compositional variations
61
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report on an XPS study of AlN thin films grown on Si(100) substrates by ion beam sputter deposition (IBSD) in reactive assistance of N+/N2+ ions to unravel the compositional variation of their surface when deposited at different substrate temperatures. The temperature of the substrate was varied as room temperature (RT), 100oC and 500oC. The binding energy of Al-2p, N-1s and O-1s core electrons indicate the formation of 2H polytypoid of AlN. The increase in concentration of AlN with substrate temperature during deposition is elucidated through detailed analysis with calculated elemental atomic concentrations (at. %) of all possible phases at the film surface. Our results show that predominate formation of AlN as high as 74 at. % is achievable using substrate temperature as the only process parameter. This high fraction of AlN in thin film surface composition is remarkable when compared to other growth techniques. Also, the formation of other phases is established based on their elemental concentrations.
قيم البحث
اقرأ أيضاً
AlN thin films have been grown on Si (100) substrates by reactive ion beam sputter deposition (IBSD) at different substrate temperatures varying from room temperature (RT) to 500oC. Substrate temperature induced microstructural transition from amorph
ous at RT, nanocrystalline at 300oC to microcrystalline at 400oC has been observed by Transmission Electron Microscopy (TEM). Average surface roughness (Ra) and morphology has been explored by using Atomic Force Microscopy (AFM). UV-VIS spectrophotometry has been employed to probe the substrate temperature induced changes in optical band-gap (Eg) of grown thin films in reflectance mode. It was found that Eg was increased from 5.08 to 5.21 eV as substrate temperature was increased from RT to 500oC. Urbach energy tail (Eu) along with weak absorption tail (WAT) energy (Et) have been estimated to account for the optical disorder which was found to decrease with associated increase in Eg.
We discuss four important aspects of 1.5 MeV Au2+ ion-induced flux dependent sputtering from gold nanostrcutures (of an average size 7.6 nm and height 6.9 nm) that are deposited on silicon substrates: (a) Au sputtering yield at the ion flux of 6.3x10
^12 ions cm-2 s-1 is found to be 312 atoms/ion which is about five times the sputtering yield reported earlier under identical irradiation conditions at a lower beam flux of 10^9 ions cm-2 s-1, (b) the sputtered yield increases with increasing flux at lower fluence and reduces at higher fluence (1.0x10^15 ions cm-2) for nanostructured thin films while the sputtering yield increases with increasing flux and fluence for thick films (27.5 nm Au deposited on Si) (c) Size distribution of sputtered particles has been found to vary with the incident beam flux showing a bimodal distribution at higher flux and (d) the decay exponent obtained from the size distributions of sputtered particles showed an inverse power law dependence ranging from 1.5 to 2.5 as a function of incident beam flux. The exponent values have been compared with existing theoretical models to understand the underlying mechanism. The role of wafer temperature associated with the beam flux has been invoked for a qualitative understanding of the sputtering results in both the nanostructured thin films and thick films.
Er-doped aluminum nitride films, containing different Er concentrations, were obtained at room temperature by reactive radio frequency magnetron sputtering. The prepared samples show a nano-columnar microstructure and the size of the columns is depen
dent on the magnetron power. The Er-related photoluminescence (PL) was studied in relation with the temperature, the Er content and the microstructure. Steady-state PL, PL excitation spectroscopy and time-resolved PL were performed. Both visible and near infrared PL were obtained at room temperature for the as-deposited samples. It is demonstrated that the PL intensity reaches a maximum for an Er concentration equal to 1 at. % and that the PL efficiency is an increasing function of the magnetron power. Decay time measurements show the important role of defect related non radiative recombination, assumed to be correlated to the presence of grain boundaries. Moreover PL excitation results demonstrate that an indirect excitation of Er 3+ ions occurs for excitation wavelengths lower than 600 nm. It is also suggested that Er ions occupy at least two different sites in the AlN host matrix.
The correlation between magnetic and structural properties of Co_{2} FeAl (CFA) thin films of different thickness (10 nm<d< 100 nm) grown at room temperature on MgO-buffered Si/SiO2 substrates and annealed at 600lyxmathsym{textdegree}C has been studi
ed. XRD measurements revealed an (011) out-of-plane texture growth of the films. The deduced lattice parameter increases with the film thickness. Moreover, pole figures showed no in-plane preferential growth orientation. The magneto-optical Kerr effect hysteresis loops showed the presence of a weak in-plane uniaxial anisotropy with a random easy axis direction. The coercive field measured with an applied field along the easy axis direction and the uniaxial anisotropy field increase linearly with the inverse of the CFA thickness. The microstrip line ferromagnetic resonance measurements for in-plane and perpendicular applied magnetic fields revealed that the effective magnetization and the uniaxial in-palne anisotropy field follow a linear variation versus the inverse CFA thickness. This allows deriving a perpendicular surface anisotropy coefficient of -1.86 erg/cm2
A range of high quality Ga1-xMnxN layers have been grown by molecular beam epitaxy with manganese concentration 0.2 < x < 10%, having the x value tuned by changing the growth temperature (Tg) between 700 and 590 {deg}C, respectively. We present a sys
tematic structural and microstructure characterization by atomic force microscopy, secondary ion mass spectrometry, transmission electron microscopy, powder-like and high resolution X-ray diffraction, which do not reveal any crystallographic phase separation, clusters or nanocrystals, even at the lowest Tg. Our synchrotron based X-ray absorption near-edge spectroscopy supported by density functional theory modelling and superconducting quantum interference device magnetometry results point to the predominantly +3 configuration of Mn in GaN and thus the ferromagnetic phase has been observed in layers with x > 5% at 3 < T < 10 K. The main detrimental effect of Tg reduced to 590 {deg}C is formation of flat hillocks, which increase the surface root-mean-square roughness, but only to mere 3.3 nm. Fine substrates surface temperature mapping has shown that the magnitudes of both x and Curie temperature (Tc) correlate with local Tg. It has been found that a typical 10 {deg}C variation of Tg across 1 inch substrate can lead to 40% dispersion of Tc. The established here strong sensitivity of Tc on Tg turns magnetic measurements into a very efficient tool providing additional information on local Tg, an indispensable piece of information for growth mastering of ternary compounds in which metal species differ in almost every aspect of their growth related parameters determining the kinetics of the growth. We also show that the precise determination of Tc by two different methods, each sensitive to different moments of Tc distribution, may serve as a tool for quantification of spin homogeneity within the material.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
