اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدMechanical Flip-Chip for Ultra-High Electron Mobility Devices
50
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Electrostatic gates are of paramount importance for the physics of devices based on high-mobility two-dimensional electron gas (2DEG) since they allow depletion of electrons in selected areas. This field-effect gating enables the fabrication of a wide range of devices such as, for example, quantum point contacts (QPC), electron interferometers and quantum dots. To fabricate these gates, processing is usually performed on the 2DEG material, which is in many cases detrimental to its electron mobility. Here we propose an alternative process which does not require any processing of the 2DEG material other than for the ohmic contacts. This approach relies on processing a separate wafer that is then mechanically mounted on the 2DEG material in a flip-chip fashion. This technique proved successful to fabricate quantum point contacts on both GaAs/AlGaAs materials with both moderate and ultra-high electron mobility.
قيم البحث
اقرأ أيضاً
We report the observation of an electron gas in a SiGe/Si/SiGe quantum well with maximum mobility up to 240 m^2/Vs, which is noticeably higher than previously reported results in silicon-based structures. Using SiO, rather than Al_2O_3, as an insulat
or, we obtain strongly reduced threshold voltages close to zero. In addition to the predominantly small-angle scattering well known in the high-mobility heterostructures, the observed linear temperature dependence of the conductivity reveals the presence of a short-range random potential.
We demonstrate a flip-chip device for performing low-temperature acoustoelectric measurements on exfoliated two-dimensional materials. With this device, we study gate-tunable acoustoelectric transport in an exfoliated monolayer graphene device, measu
ring the voltage created as high-frequency surface acoustic waves dynamically drive the graphene charge carriers, the density of which we simultaneously control with a silicon back-gate. We demonstrate ambipolar dependence of the acoustoelectric signal, as expected from the sign of the graphene charge carriers. We observe a marked reduction in the magnitude of the acoustoelectric signal over a well-defined range of density in the vicinity of charge neutrality, which we attribute to a spatially heterogeneous charge-disorder landscape not directly revealed by conventional transport measurements.
We have observed the transversal vibration mode of suspended carbon nanotubes at millikelvin temperatures by measuring the single-electron tunneling current. The suspended nanotubes are actuated contact-free by the radio frequency electric field of a
nearby antenna; the mechanical resonance is detected in the time-averaged current through the nanotube. Sharp, gate-tuneable resonances due to the bending mode of the nanotube are observed, combining resonance frequencies of up to u_0 = 350 MHz with quality factors above Q = 10^5, much higher than previously reported results on suspended carbon nanotube resonators. The measured magnitude and temperature dependence of the Q-factor shows a remarkable agreement with the intrinsic damping predicted for a suspended carbon nanotube. By adjusting the RF power on the antenna, we find that the nanotube resonator can easily be driven into the non-linear regime.
We show that a cryogenic amplifier composed of a homemade GaAs high-electron-mobility transistor (HEMT) is suitable for current-noise measurements in a mesoscopic device at dilution-refrigerator temperatures. The lower noise characteristics of our ho
memade HEMT leads to a lower noise floor in the experimental setup and enables more efficient current-noise measurement than is available with a commercial HEMT. We present the dc transport properties of the HEMT and the gain and noise characteristics of the amplifier. With the amplifier employed for current-noise measurements in a quantum point contact, we demonstrate the high resolution of the measurement setup by comparing it with that of the conventional one using a commercial HEMT.
We report the development and performance of on-chip interconnects designed to suppress electromagnetic (EM) crosstalk in spin qubit device architectures with the large number of gate electrodes needed for multi- qubit operation. Our design improves
the performance of typical device interconnects via the use of minia- turised ohmic contacts and interspersed ground guards. Low temperature measurements and numerical simulation confirm that control and readout signal crosstalk can be suppressed to levels of order 1%, from dc to 1 GHz.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
