اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectrical stimulation of single-photon emission from nitrogen-vacancy centers in diamond with sub-superficial graphitic electrodes
186
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Focused MeV ion beams with micrometric resolution are suitable tools for the direct writing of conductive graphitic channels buried in an insulating diamond bulk. Their effectiveness has been shown for the fabrication of multi-electrode ionizing radiation detectors and cellular biosensors. In this work we investigate such fabrication method for the electrical excitation of color centers in diamond. Differently from optically-stimulated light emission from color centers in diamond, electroluminescence (EL) requires a high current flowing in the diamond subgap states between the electrodes. With this purpose, buried graphitic electrode pairs with a spacing of 10 $mu$m were fabricated in the bulk of a single-crystal diamond sample using a 6 MeV C microbeam. The electrical characterization of the structure showed a significant current above an effective voltage threshold of 150V, which was interpreted according to the theory of Space Charge Limited Current. The EL imaging allowed to identify the electroluminescent regions and the residual vacancy distribution associated with the fabrication technique. Measurements evidenced bright electroluminescent emission from native neutrally-charged nitrogen-vacancy centers ($NV^0$); the acquired spectra highlighted the absence of EL associated with radiation damage.
قيم البحث
اقرأ أيضاً
We report on the fabrication and characterization of a single-crystal diamond device for the electrical stimula- tion of light emission from nitrogen-vacancy (NV0) and other defect-related centers. Pairs of sub-superficial graphitic micro-electrodes
embedded in insulating diamond were fabricated by a 6 MeV C3+ micro-beam irra- diation followed by thermal annealing. A photoluminescence (PL) characterization evidenced a low radiation damage concentration in the inter-electrode gap region, which did not significantly affect the PL features domi- nated by NV centers. The operation of the device in electroluminescence (EL) regime was investigated by ap- plying a bias voltage at the graphitic electrodes, resulting in the injection of a high excitation current above a threshold voltage (~300V), which effectively stimulated an intense EL emission from NV0 centers. In addition, we report on the new observation of two additional sharp EL emission lines (at 563 nm and 580 nm) related to interstitial defects formed during MeV ion beam fabrication.
The control of the charge state of nitrogen-vacancy (NV) centers in diamond is of primary importance for the stabilization of their quantum-optical properties, in applications ranging from quantum sensing to quantum computing. To this purpose, in thi
s work current-injecting micro-electrodes were fabricated in bulk diamond for NV charge state control. Buried (i.e. 3 {mu}m in depth) graphitic micro-electrodes with spacing of 9 {mu}m were created in single-crystal diamond substrates by means of a 6 MeV C scanning micro-beam. The high breakdown field of diamond was exploited to electrically control the variation in the relative population of the negative (NV-) and neutral (NV0) charge states of sub-superficial NV centers located in the inter- electrode gap regions, without incurring into current discharges. Photoluminescence spectra acquired from the biased electrodes exhibited an electrically induced increase up to 40% in the NV- population at the expense of the NV0 charge state. The variation in the relative charge state populations showed a linear dependence from the injected current at applied biases smaller than 250 V, and was interpreted as the result of electron trapping at NV sites, consistently with the Space Charge Limited Current interpretation of the abrupt current increase observed at 300 V bias voltage. In correspondence of such trap-filling-induced transition to a high-current regime, a strong electroluminescent emission from the NV0 centers was observed. In the high-current-injection regime, a decrease in the NV- population was observed, in contrast with the results obtained at lower bias voltages. These results disclose new possibilities in the electrical control of the charge state of NV centers located in the diamond bulk, which are characterized by longer spin coherence times.
Nanodiamond crystals containing single color centers have been grown by chemical vapor deposition (CVD). The fluorescence from individual crystallites was directly correlated with crystallite size using a combined atomic force and scanning confocal f
luorescence microscope. Under the conditions employed, the optimal size for single optically active nitrogen-vacancy (NV) center incorporation was measured to be 60 to 70 nm. The findings highlight a strong dependence of NV incorporation on crystal size, particularly with crystals less than 50 nm in size.
We show a marked reduction in the emission from nitrogen-vacancy (NV) color centers in single crystal diamond due to exposure of the diamond to hydrogen plasmas ranging from 700{deg}C to 1000{deg}C. Significant fluorescence reduction was observed ben
eath the exposed surface to at least 80mm depth after ~10 minutes, and did not recover after post-annealing in vacuum for seven hours at 1100{deg}C. We attribute the fluorescence reduction to the formation of NVH centers by the plasma induced diffusion of hydrogen. These results have important implications for the formation of nitrogen-vacancy centers for quantum applications, and inform our understanding of the conversion of nitrogen-vacancy to NVH, whilst also providing the first experimental evidence of long range hydrogen diffusion through intrinsic high-purity diamond material.
We report on the structural modifications induced by a lambda = 532 nm ns-pulsed high-power laser on sub-superficial graphitic layers in single-crystal diamond realized by means of MeV ion implantation. A systematic characterization of the structures
obtained under different laser irradiation conditions (power density, number of pulses) and subsequent thermal annealing was performed by different electron microscopy techniques. The main feature observed after laser irradiation is the thickening of the pre-existing graphitic layer. Cross sectional SEM imaging was performed to directly measure the thickness of the modified layers, and subsequent selective etching of the buried layers was employed to both assess their graphitic nature and enhance the SEM imaging contrast. In particular, it was found that for optimal irradiation parameters the laser processing induces a six-fold increase the thickness of sub superficial graphitic layers without inducing mechanical failures in the surrounding crystal. TEM microscopy and EELS spectroscopy allowed a detailed analysis of the internal structure of the laser irradiated layers, highlighting the presence of different nano graphitic and amorphous layers. The obtained results demonstrate the effectiveness and versatility of high-power laser irradiation for an accurate tuning of the geometrical and structural features of graphitic structures embedded in single crystal diamond, and open new opportunities in diamond fabrication.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
