اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA study of decays to strange final states with GlueX in Hall D using components of the BaBar DIRC
203
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We propose to enhance the kaon identification capabilities of the GlueX detector by constructing an FDIRC (Focusing Detection of Internally Reflected Cherenkov) detector utilizing the decommissioned BaBar DIRC components. The GlueX FDIRC would significantly enhance the GlueX physics program by allowing one to search for and study hybrid mesons decaying into kaon final states. Such systematic studies of kaon final states are essential for inferring the quark flavor content of hybrid and conventional mesons. The GlueX FDIRC would reuse one-third of the synthetic fused silica bars that were utilized in the BaBar DIRC. A new focussing photon camera, read out with large area photodetectors, would be developed. We propose operating the enhanced GlueX detector in Hall D for a total of 220 days at an average intensity of 5x10^7 {gamma}/s, a program that was conditionally approved by PAC39
قيم البحث
اقرأ أيضاً
The primary motivation of the GlueX experiment is to search for and ultimately study the pattern of gluonic excitations in the meson spectrum produced in gamma p collisions. Recent lattice QCD calculations predict a rich spectrum of hybrid mesons tha
t have both exotic and non-exotic JPC, corresponding to q q-bar (q=u, d, or s) states coupled with a gluonic field. A thorough study of the hybrid spectrum, including the identification of the isovector triplet, with charges 0 and +-1, and both isoscalar members, |s s-bar> and |u u-bar> + |d d-bar>, for each predicted hybrid combination of JPC, may only be achieved by conducting a systematic amplitude analysis of many different hadronic final states. We propose the development of a kaon identification system, supplementing the existing GlueX forward time-of-flight detector, in order to cleanly select meson and baryon decay channels that include kaons. Once this detector has been installed and commissioned, we plan to collect a total of 200 days of physics analysis data at an average intensity of 5 x 10^7 tagged photons on target per second. This data sample will provide an order of magnitude statistical improvement over the initial GlueX data set and, with the developed kaon identification system, a significant increase in the potential for GlueX to make key experimental advances in our knowledge of hybrid mesons and Cascade baryons.
The GlueX experiment is located in experimental Hall D at Jefferson Lab (JLab) and provides a unique capability to search for hybrid mesons in high-energy photoproduction, utilizing a ~9 GeV linearly polarized photon beam. The initial, low-intensity
phase of GlueX was recently completed and a high-intensity phase has begun in 2020 which includes an upgraded kaon identification system, known as the DIRC (Detection of Internally Reflected Cherenkov light), utilizing components from the decommissioned BaBar DIRC. The identification of kaon final states will significantly enhance the GlueX physics program, to aid in inferring the quark flavor content of conventional (and potentially hybrid) mesons. In these proceedings we describe the installation of the GlueX DIRC and the analysis of initial commissioning data
The GlueX experiment takes place in experimental Hall D at Jefferson Lab (JLab). With a linearly polarized photon beam of up to 12 GeV energy, GlueX is a dedicated experiment to search for hybrid mesons via photoproduction reactions. The low-intensit
y (Phase I) of GlueX was recently completed; the high-intensity (Phase II) started in 2020 including an upgraded particle identification system, known as the DIRC (Detection of Internally Reflected Cherenkov light), utilizing components from the decommissioned BaBar experiment. The identification and separation of the kaon final states will significantly enhance the GlueX physics program, by adding the capability of accessing the strange quark flavor content of conventional (and potentially hybrid) mesons. In these proceedings, we report that the installation and commissioning of the DIRC detector has been successfully completed.
A study of $D^+KS$ and $D^0K^+$ final states is performed in a sample of 1.0/fb of $pp$ collision data collected at a centre-of-mass energy of $sqrt{s}=7$ TeV with the lhcb detector. We confirm the existence of the $D_{s1}^*(2700)^+$ and $D_{sJ}^*(28
60)^+$ excited states and measure their masses and widths to be {eqnarray} m(D_{s1}^*(2700)^+) &=& 2709.2 pm 1.9({stat})pm,,,4.5({syst}) {MeV}/c^2,cr Gamma(D_{s1}^*(2700)^+) &=& ,,,115.8 pm 7.3({stat}) pm12.1({syst}) {MeV}/c^2,cr m(D_{sJ}^*(2860)^+) &=& 2866.1 pm 1.0({stat}) pm,,,6.3({syst}) {MeV}/c^2,cr Gamma(D_{sJ}^*(2860)^+) &=& ,,,,,,69.9 pm 3.2({stat}) pm,,,6.6({syst}) {MeV}/c^2.cr {eqnarray}
We present the final results from a novel Cherenkov imaging detector called the Focusing DIRC (FDIRC). This detector was designed as a full-scale prototype of the particle identification system for the SuperB experiment [1], and comprises 1/12 of the
SuperB barrel azimuthal coverage, with partial photodetector and electronics implementation. The prototype was tested in the SLAC Cosmic Ray Telescope which provided 3-D tracking of cosmic muons with an angular resolution of ~1.5 mrad, a position resolution of 4-5 mm, a start time resolution of 70 ps, and muon tracks above ~2 GeV tagged using an iron range stack. The fused silica focusing photon camera was coupled to a full-size BaBar DIRC bar box and was read out, over part of the full coverage, by 12 Hamamatsu H8500 multi-anode photomultipliers (MaPMTs) providing 768 pixels. We used waveform digitizing electronics to read out the MaPMTs. We give a detailed description of our data analysis methods and point out limitations on the present performance. We present results that demonstrate some basic performance characteristics of this design, including: (a) single photon Cherenkov angle resolutions with and without chromatic corrections, (b) signal-to-noise (S/N) ratio between the Cherenkov peak and background, which primarily consists of ambiguities of the possible photon paths from emission along the track to a given pixel, (c) dTOP = TOP_measured - TOP_expected resolutions (with TOP being the photon Time-of-Propagation in fused silica), and (d) performance of the detector in the presence of high-rate backgrounds.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
