اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPhotoluminescence of focused ion beam implanted Er$^{3+}$:Y$_{2}$SiO$_{5}$ crystals
107
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Erbium doped low symmetry Y$_2$SiO$_5$ crystals attract a lot of attention in perspective of quantum information applications. However, only doping of the samples during growth is available up to now, which yields a quite homogeneous doping density. In the present work, we deposit Er$^{3+}$-ions by the focused ion beam technique at Yttrium sites with several fluences in one sample. With a photoluminescence study of these locally doped Er$^{3+}$:Y$_2$SiO$_5$ crystals, we are able to evaluate the efficiency of the implantation process and develop it for the highest efficiency possible. We observe the dependence of the ion activation after the post-implantation annealing on the fluence value.
قيم البحث
اقرأ أيضاً
Er-doped aluminum nitride films, containing different Er concentrations, were obtained at room temperature by reactive radio frequency magnetron sputtering. The prepared samples show a nano-columnar microstructure and the size of the columns is depen
dent on the magnetron power. The Er-related photoluminescence (PL) was studied in relation with the temperature, the Er content and the microstructure. Steady-state PL, PL excitation spectroscopy and time-resolved PL were performed. Both visible and near infrared PL were obtained at room temperature for the as-deposited samples. It is demonstrated that the PL intensity reaches a maximum for an Er concentration equal to 1 at. % and that the PL efficiency is an increasing function of the magnetron power. Decay time measurements show the important role of defect related non radiative recombination, assumed to be correlated to the presence of grain boundaries. Moreover PL excitation results demonstrate that an indirect excitation of Er 3+ ions occurs for excitation wavelengths lower than 600 nm. It is also suggested that Er ions occupy at least two different sites in the AlN host matrix.
A focused ion beam is used to mill side holes in air-silica structured fibres. By way of example, side holes are introduced in two types of air-structured fibres (1) a photonic crystal four-ring fibre and (2) a 6-hole single ring step index structured fibre.
The effect of magnetron power on the room temperature 1.54 $mu$m infra-red photoluminescence intensity of erbium doped AlN films grown by r. f. magnetron sputtering, has been studied. The AlN:Er thin films were deposited on (001) Silicon substrates.
The study presents relative photoluminescence intensities of nanocrystallized samples prepared with identical sputtering parameters for two erbium doping levels (0.5 and 1.5 atomic %). The structural evolution of the crystallites as a function of the power is followed by transmission electron microscopy. Copyright line will be provided by the publisher 1 Introduction For some time now, rare-earth (RE)-doped semiconductors represent significant potential applications in the field of opto-electronic technology. Part of this technological interest relies on the shielded 4f levels of the RE ions as they give rise to sharp and strong luminescence peaks [1-5]. Among the RE elements, Er is preferred to its counterparts since the Er ions can produce both visible light at 558 nm (green, one of the primary colours) and IR light at 1.54 $mu$m whose spectrum region coincides with the main low-loss region in the absorption spectrum of silica-based optical fibres, combining so potential applications towards photonic devices and towards optical communication devices operating in the infrared domain. These interesting emissions can however only be exploited when placed into host matrixes. On one side, the shielding of the intra 4f levels prevents the shifting of the RE 3+ energy levels and ensures the frequency emission stability. Moreover the intra 4f transitions are parity forbidden for the isolated ions. Matrixes can render the Er 3+ ions optically active, via a relaxation of selection rules due to crystal field effects. As silicon based materials were tested in the 1960s to the 90s with no clear industrial success it was found that the
Recent advances in focused ion beam technology have enabled high-resolution, direct-write nanofabrication using light ions. Studies with light ions to date have, however, focused on milling of materials where sub-surface ion beam damage does not inhi
bit device performance. Here we report on direct-write milling of single crystal diamond using a focused beam of oxygen ions. Material quality is assessed by Raman and luminescence analysis, and reveals that the damage layer generated by oxygen ions can be removed by nonintrusive post-processing methods such as localised electron beam induced chemical etching.
Interfacing photonic and solid-state qubits within a hybrid quantum architecture offers a promising route towards large scale distributed quantum computing. In that respect, hybrid quantum systems combining circuit QED with ions doped into solids are
an attractive platform. There, the ions serve as coherent memory elements and reversible conversion elements of microwave to optical qubits. Among many possible spin-doped solids, erbium ions offer the unique opportunity of a coherent conversion of microwave photons into the telecom C-band at $1.54,mu$m employed for long distance communication. In our work, we perform a time-resolved electron spin resonance study of an Er$^{3+}$:Y$_2$SiO$_5$ spin ensemble at milli-Kelvin temperatures and demonstrate multimode storage and retrieval of up to 16 coherent microwave pulses. The memory efficiency is measured to be 10$^{-4}$ at the coherence time of $T_2=5.6,mu$s.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
