اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRealization of Carrier Tunneling from InAlAs Quantum Dots to AlAs
146
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
With the aim of improving solar cell efficiency, a structure for realizing electron tunneling from In0.6Al0.4As quantum dots (QDs) through an Al0.4Ga0.6As barrier to AlAs has been grown using molecular beam epitaxy. The photoluminescence decay time decreased from 1.1 ns to 390 ps as the barrier thickness decreased from 4 to 2 nm, which indicates that the photo-excited carriers tunneled from the QDs to the AlAs X energy level for a barrier thickness 2 nm in 0.6 ns, which is significantly longer than the tunneling time of GaAs and InAlAs quantum wells. We expect that this structure will assist in developing high-efficiency QD sensitized solar cells.
قيم البحث
اقرأ أيضاً
Molecular beam epitaxy is employed to manufacture self-assembled InAs/AlAs quantum-dot resonant tunneling diodes. Resonant tunneling current is superimposed on the thermal current, and they make up the total electron transport in devices. Steps in cu
rrent-voltage characteristics and peaks in capacitance-voltage characteristics are explained as electron resonant tunneling via quantum dots at 77K or 300K, and this is the first time that resonant tunneling is observed at room temperature in III-V quantum-dot materials. Hysteresis loops in the curves are attributed to hot electron injection/emission process of quantum dots, which indicates the concomitant charging/discharging effect.
Molecular beam epitaxy is employed to manufacture self-assembled InAs/GaAs quantum dot Schottky resonant tunneling diodes. By virtue of a thin AlAs insertion barrier, the thermal current is effectively reduced and electron resonant tunneling through
quantum dots under both forward and reverse biased conditions is observed at relatively high temperature of 77K. The ground states of quantum dots are found to be at ~0.19eV below the conduction band of GaAs matrix. The theoretical computations are in conformity with experimental data.
By using different widths for two AlAs quantum wells comprising a bilayer system, we force the X-point conduction-band electrons in the two layers to occupy valleys with different Fermi contours, electron effective masses, and g-factors. Since the oc
cupied valleys are at different X-points of the Brillouin zone, the interlayer tunneling is negligibly small despite the close electron layer spacing. We demonstrate the realization of this system via magneto-transport measurements and the observation of a phase-coherent, bilayer $ u$=1 quantum Hall state flanked by a reentrant insulating phase.
Spatially indirect Type-II band alignment in magnetically-doped quantum dot (QD) structures provides unexplored opportunities to control the magnetic interaction between carrier wavefunction in the QD and magnetic impurities. Unlike the extensively s
tudied, spatially direct, QDs with Type-I band alignment where both electrons and holes are confined in the QD, in ZnTe QDs embedded in a (Zn,Mn)Se matrix only the holes are confined in the QDs. Photoexcitation with photon energy 3.06 eV (2.54 eV) generates electron-hole pairs predominantly in the (Zn,Mn)Se matrix (ZnTe QDs). The photoluminescence (PL) at 7 K in the presence of an external magnetic field exhibits an up to three-fold increase in the saturation red shift with the 2.54 eV excitation compared to the shift observed with 3.06 eV excitation. This unexpected result is attributed to multiple hole occupancy of the QD and the resulting increased penetration of the hole wavefunction tail further into the (Zn,Mn)Se matrix. The proposed model is supported by microscopic calculations which accurately include the role of hole-hole Coulomb interactions as well as the hole-Mn spin exchange interactions.
Reliable detection of single electron tunneling in quantum dots (QD) is paramount to use this category of device for quantum information processing. Here, we report charge sensing in a degenerately phosphorus-doped silicon QD by means of a capacitive
ly coupled single-electron tunneling device made of the same material. Besides accurate counting of tunneling events in the QD, we demonstrate that this architecture can be operated to reveal asymmetries in the transport characteristic of the QD. Indeed, the observation of gate voltage shifts in the detectors response as the QD bias is changed is an indication of variable tunneling rates.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
