اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHot electron attenuation of direct and scattered carriers across an epitaxial Schottky interface
178
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Hot electron transport of direct and scattered carriers across an epitaxial NiSi_2/n-Si(111) interface, for different NiSi_2 thickness, is studied using Ballistic Electron Emission Microscopy (BEEM). We find the BEEM transmission for the scattered hot electrons in NiSi_2 to be significantly lower than that for the direct hot electrons, for all thicknesses. Interestingly, the attenuation length of the scattered hot electrons is found to be twice larger than that of the direct hot electrons. The lower BEEM transmission for the scattered hot electrons is due to inelastic scattering of the injected hot holes while the larger attenuation length of the scattered hot electrons is a consequence of the differences in the energy distribution of the injected and scattered hot electrons and the increasing attenuation length, at lower energies, of the direct hot electrons in NiSi_2.
قيم البحث
اقرأ أيضاً
SrRuO3 (SRO), a conducting transition metal oxide, is commonly used for engineering domains in BiFeO3. New oxide devices can be envisioned by integrating SRO with an oxide semiconductor as Nb doped SrTiO3 (Nb:STO). Using a three-terminal device confi
guration, we study vertical transport in a SRO/Nb:STO device at the nanoscale and find local differences in transport, that originate due to the high selectivity of SRO growth on the underlying surface terminations in Nb:STO. This causes a change in the interface energy band characteristics and is explained by the differences in the spatial distribution of the interface-dipoles at the local Schottky interface.
The hot-electron attenuation length in Ni is measured as a function of energy across two different Schottky interfaces viz. a polycrystalline Si(111)/Au and an epitaxial Si(111)/NiSi_2 interface using ballistic electron emission microscopy (BEEM). Fo
r similarly prepared Si(111) substrates and identical Ni thickness, the BEEM transmission is found to be lower for the polycrystalline interface than for the epitaxial interface. However, in both cases, the hot-electron attenuation length in Ni is found to be the same. This is elucidated by the temperature-independent inelastic scattering, transmission probabilities across the Schottky interface, and scattering at dissimilar interfaces.
La0.9Ba0.1MnO3 is a ferromagnetic insulator in its bulk form, but exhibits metallicity in thin film form. It has a wide potential in a range of spintronic-related applications, and hence it is critical to understand thickness-dependent electronic str
ucture in thin films as well as substrate/film interface effects. Here, using electrical and in-situ photoemission spectroscopy measurements, we report the electronic structure and interface band profile of high-quality layer-by-layer-grown La0.9Ba0.1MnO3 on single crystal Nb:SrTiO3 substrates. A transition from insulating-to-conducting was observed with increasing La0.9Ba0.1MnO3 thickness, which was explained by the determined interface band diagram of La0.9Ba0.1MnO3/Nb: SrTiO3, where a type II heterojunction was formed.
Using a metal-oxide-semiconductor field effect transistor (MOSFET) structure with a high-quality CoFe/n^+Si contact, we systematically study spin injection and spin accumulation in a nondegenerated Si channel with a doping density of ~ 4.5*10^15cm^-3
at room temperature. By applying the gate voltage (V_G) to the channel, we obtain sufficient bias currents (I_Bias) for creating spin accumulation in the channel and observe clear spin-accumulation signals even at room temperature. Whereas the magnitude of the spin signals is enhanced by increasing I_Bias, it is reduced by increasing V_G interestingly. These features can be understood within the framework of the conventional spin diffusion model. As a result, a room-temperature spin injection technique for the nondegenerated Si channel without using insulating tunnel barriers is established, which indicates a technological progress for Si-based spintronic applications with gate electrodes.
Understanding the structure and chemical composition at the liquid-nanoparticle (NP) interface is crucial for a wide range of physical, chemical and biological processes. In this study, direct imaging of the liquid-NP interface by atom probe tomograp
hy (APT) is reported for the first time, which reveals the distributions and the interactions of key atoms and molecules in this critical domain. The APT specimen is prepared by controlled graphene encapsulation of the solution containing nanoparticles on a metal tip, with an end radius in the range of 50 nm to allow field ionization and evaporation. Using Au nanoparticles (AuNPs) in suspension as an example, analysis of the mass spectrum and three-dimensional (3D) chemical maps from APT provides a detailed image of the water-gold interface with near-atomic resolution. At the water-gold interface, the formation of an electrical double layer (EDL) rich in water (H2O) molecules has been observed, which results from the charge from the binding between the trisodium-citrate layer and the AuNP. In the bulk water region, the density of reconstructed H2O has been shown to be consistent, reflecting a highly packed density of H2O molecules after graphene encapsulation. This study is the first demonstration of direct imaging of liquid-NP interface using APT with results providing an atom-by-atom 3D dissection of the liquid-NP interface.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
