اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFinite-size effect in shot noise in hopping conduction
83
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study a current shot noise in a macroscopic insulator based on a two-dimensional electron system in GaAs in a variable range hopping (VRH) regime. At low temperature and in a sufficiently depleted sample a shot noise close to a full Poissonian value is measured. This suggests an observation of a finite-size effect in shot noise in the VRH conduction and demonstrates a possibility of accurate quasiparticle charge measurements in the insulating regime.
قيم البحث
اقرأ أيضاً
We have observed shot noise in the hopping conduction of two dimensional carriers confined in a p-type SiGe quantum well at a temperature of 4K. Moreover, shot noise is suppressed relative to its ``classical value 2eI by an amount that depends on the
length of the sample and carrier density, which was controlled by a gate voltage. We have found a suppression factor to the classical value of about one half for a 2 $mu$m long sample, and of one fifth for a 5 $mu$m sample. In each case, the factor decreased slightly as the density increased toward the insulator-metal transition. We explain these results in terms of the characteristic length ($simeq 1mu$m in our case) of the inherent inhomogeneity of hopping transport.
The temperature dependence of the electrical transport of a individual tin oxide nanobelt was measured, in darkness, from 400 to 5K. We found four intrinsic electrical transport mechanisms through the nanobelt. It starts with Thermal-Activation Condu
ction between 400 and 314K, Nearest-Neighbor Hopping conduction between 268 and 115K, and Variable Range Hopping conduction below 58K, with a crossover from the 3D-Mott to the 3D-Efros-Shklovskii regime at 16K. We claim that this sequence reveal the three-dimensional nature of the electrical transport in the SnO2 nanobelts, even they are expected to behave as one-dimensional systems.
As is well known, the fluctuations from a stable stationary nonequilibrium state are described by a linearized nonhomogeneous Boltzmann-Langevin equation. The stationary state itself may be described by a nonlinear Boltzmann equation. The ways of its
linearization sometimes seem to be not unique. We argue that there is actually a unique way to obtain a linear equation for the fluctuations. In the present paper we treat as an example an analytical theory of nonequilibrium shot noise in a diffusive conductor under the space charge limited regime. Our approach is compared with that of Schomerus, Mishchenko and Beenakker [Phys. Rev. B 60, 5839 (1999)]. We find some difference between the present theory and the approach of their paper and discuss a possible origin of the difference. We believe that it is related to the fundamentals of the theory of fluctuation phenomena in a nonequilibrium electron gas.
We study the low temperature magneto-transport properties of several highly disordered amorphous Indium oxide(a:InO) samples. Simultaneously fabricated devices comprising a 2-dimensional (2D) film and 10 $mu$m long wires of different widths were meas
ured to investigate the effect of size as we approach the 1D limit, which is around 4 times the correlation length, and happens to be around 100 nm for a:InO. The film and the wires showed magnetic field ({it B}) induced superconductor to insulator transition (SIT). In the superconducting side, the resistance increased with decrease in wire width, whereas, an opposite trend is observed in the insulating side. We find that this effect can be explained in light of charge-vortex duality picture of the SIT. Resistance of the 2D film follows an activated behavior over the temperature ($T$), whereas, the wires show a crossover from the high-$T$ activated to a $T$-independent behavior. At high temperature regime the wires resistance follow the films until they deviate and became independent of $T$. We find that temperature at which this deviation occurs evolve with magnetic field and the width of the wire, which show the effect of finite size on the transport.
We report measurements of current noise in single- and multi-layer graphene devices. In four single-layer devices, including a p-n junction, the Fano factor remains constant to within +/-10% upon varying carrier type and density, and averages between
0.35 and 0.38. The Fano factor in a multi-layer device is found to decrease from a maximal value of 0.33 at the charge-neutrality point to 0.25 at high carrier density. These results are compared to theoretical predictions for shot noise in ballistic and disordered graphene.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
