اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدObservations of Low Frequency Solar Radio Bursts from the Rosse Solar-Terrestrial Observatory
486
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The Rosse Solar-Terrestrial Observatory (RSTO; www.rosseobservatory.ie) was established at Birr Castle, Co. Offaly, Ireland (53 0538.9, 7 5512.7) in 2010 to study solar radio bursts and the response of the Earths ionosphere and geomagnetic field. To date, three Compound Astronomical Low-cost Low-frequency Instrument for Spectroscopy and Transportable Observatory (CALLISTO) spectrometers have been installed, with the capability of observing in the frequency range 10-870 MHz. The receivers are fed simultaneously by biconical and log-periodic antennas. Nominally, frequency spectra in the range 10-400 MHz are obtained with 4 sweeps per second over 600 channels. Here, we describe the RSTO solar radio spectrometer set-up, and present dynamic spectra of a sample of Type II, III and IV radio bursts. In particular, we describe fine-scale structure observed in Type II bursts, including band splitting and rapidly varying herringbone features.
قيم البحث
اقرأ أيضاً
New measurements using radio and plasma-wave instruments in interplanetary space have shown that nanometer-scale dust, or nanodust, is a significant contributor to the total mass in interplanetary space. Better measurements of nanodust will allow us
to determine where it comes from and the extent to which it interacts with the solar wind. When one of these nanodust grains impacts a spacecraft, it creates an expanding plasma cloud, which perturbs the photoelectron currents. This leads to a voltage pulse between the spacecraft body and the antenna. Nanodust has a high charge/mass ratio, and therefore can be accelerated by the interplanetary magnetic field to speeds up to the speed of the solar wind: significantly faster than the Keplerian orbital speeds of heavier dust. The amplitude of the signal induced by a dust grain grows much more strongly with speed than with mass of the dust particle. As a result, nanodust can produce a strong signal, despite their low mass. The WAVES instruments on the twin Solar TErrestrial RElations Observatory spacecraft have observed interplanetary nanodust particles since shortly after their launch in 2006. After describing a new and improved analysis of the last five years of STEREO/WAVES Low Frequency Receiver data, a statistical survey of the nanodust characteristics, namely the rise time of the pulse voltage and the flux of nanodust, is presented. Agreement with previous measurements and interplanetary dust models is shown. The temporal variations of the nanodust flux are also discussed.
We report low frequency observations of the quasi-periodic, circularly polarized, harmonic type III radio bursts whose associated sunspot active regions were located close to the solar limb. The measured periodicity of the bursts at 80 MHz was $appro
x$ 5.2 s and their average degree of circular polarization ($dcp$) was $approx 0.12$. We calculated the associated magnetic field $B$ : (1) using the empirical relationship between the $dcp$ and $B$ for the harmonic type III emission, and (2) from the observed quasi-periodicity of the bursts. Both the methods result in $B approx$ 4.2 G at the location of the 80 MHz plasma level (radial distance $r approx 1.3~rm R_{odot}$) in the active region corona.
We have performed a statistical study of $152$ Type III radio bursts observed by Solar TErrestrial RElations Observatory (STEREO)/Waves between May 2007 and February 2013. We have investigated the flux density between $125$kHz and $16$MHz. Both high-
and low-frequency cutoffs have been observed in $60,%$ of events suggesting an important role of propagation. As already reported by previous authors, we observed that the maximum flux density occurs at $1$MHz on both spacecraft. We have developed a simplified analytical model of the flux density as a function of radial distance and compared it to the STEREO/Waves data.
We provide a large image parameter dataset extracted from the Solar Dynamics Observatory (SDO) missions AIA instrument, for the period of January 2011 through the current date, with the cadence of six minutes, for nine wavelength channels. The volume
of the dataset for each year is just short of 1 TiB. Towards achieving better results in the region classification of active regions and coronal holes, we improve upon the performance of a set of ten image parameters, through an in depth evaluation of various assumptions that are necessary for calculation of these image parameters. Then, where possible, a method for finding an appropriate settings for the parameter calculations was devised, as well as a validation task to show our improved results. In addition, we include comparisons of JP2 and FITS image formats using supervised classification models, by tuning the parameters specific to the format of the images from which they are extracted, and specific to each wavelength. The results of these comparisons show that utilizing JP2 images, which are significantly smaller files, is not detrimental to the region classification task that these parameters were originally intended for. Finally, we compute the tuned parameters on the AIA images and provide a public API (http://dmlab.cs.gsu.edu/dmlabapi) to access the dataset. This dataset can be used in a range of studies on AIA images, such as content-based image retrieval or tracking of solar events, where dimensionality reduction on the images is necessary for feasibility of the tasks.
Context. Systematic observations of magnetic field strength and polarity in sunspots began at Mount Wilson Observatory (MWO), USA in early 1917. Except for a few brief interruptions, this historical dataset continues till present. Aims. The sunspot f
ield strength and polarity observations are critical in our project of reconstructing the solar magnetic field over the last hundred years. Here we provide a detailed description of the newly digitized dataset of drawings of sunspot magnetic field observations. Methods. The digitization of MWO drawings is based on a software package develope d by us. It includes a semi-automatic selection of solar limbs and other features of the drawing, and a manual entry of the time of observations, the measured field strength and other notes hand-written on each drawing. The data are preserved in a MySQL database. Results. We provide a brief history of the project and describe the results from digitizing this historical dataset. We also provide a summary of the final dataset, and describe its known limitations. Finally, we compare the sunspot magnetic field measurements with other instruments, and demonstrate that, if needed, the dataset could be continued using modern observations such as, for example, Vector Stokes Magnetograph (VSM) on Synoptic Optical Long-term Investigations of the Sun (SOLIS) platform.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
