اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBroadband Reconfiguration of OptoMechanical Filters
59
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We demonstrate broad-band reconfiguration of coupled photonic crystal nanobeam cavities by using optical gradient force induced mechanical actuation. Propagating waveguide modes that exist over wide wavelength range are used to actuate the structures and in that way control the resonance of localized cavity mode. Using this all-optical approach, more than 18 linewidths of tuning range is demonstrated. Using on-chip temperature self-referencing method that we developed, we determined that 20 % of the total tuning was due to optomechanical reconfiguration and the rest due to thermo-optic effects. Independent control of mechanical and optical resonances of our structures, by means of optical stiffening, is also demonstrated.
قيم البحث
اقرأ أيضاً
Two-terminal electronic transport systems with a rectangular transmission can violate standard thermodynamic uncertainty relations. This is possible beyond the linear response regime and for parameters that are not accessible with rate equations obey
ing detailed-balance. Looser bounds originating from fluctuation theorem symmetries alone remain respected. We demonstrate that optimal finite-sized quantum dot chains can implement rectangular transmission functions with high accuracy and discuss the resulting violations of standard thermodynamic uncertainty relations as well as heat engine performance.
Generation and manipulation of many-body entangled states is of considerable interest, for applications in quantum simulation or sensing, for example. Measurement and verification of the resulting many-body state presents a formidable challenge, howe
ver, which can be simplified by multiplexed readout using shared measurement resources. In this work, we analyze and demonstrate state retrodiction for a system of optomechanical oscillators coupled to a single-mode optical cavity. Coupling to the shared cavity field facilitates simultaneous optical measurement of the oscillators transient dynamics at distinct frequencies. Optimal estimators for the oscillators initial state can be defined as a set of linear matched filters, derived from a detailed model for the detected homodyne signal. We find that the optimal state estimate for optomechanical retrodiction is obtained from high-cooperativity measurements, reaching estimate sensitivity at the Standard Quantum Limit (SQL). Simultaneous estimation of the state of multiple oscillators places additional limits on the estimate precision, due to the diffusive noise each oscillator adds to the optomechanical signal. However, we show that the sensitivity of simultaneous multi-mode state retrodiction reaches the SQL for sufficiently well-resolved oscillators. Finally, an experimental demonstration of two-mode retrodiction is presented, which requires further accounting for technical fluctuations of the oscillator frequency.
A cavity optomechanical magnetometer is demonstrated where the magnetic field induced expansion of a magnetostrictive material is transduced onto the physical structure of a highly compliant optical microresonator. The resulting motion is read out op
tically with ultra-high sensitivity. Detecting the magnetostrictive deformation of Terfenol-D with a toroidal whispering gallery mode (TWGM) resonator a peak sensitivity of 400 nT/Hz^.5 was achieved with theoretical modelling predicting that sensitivities of up to 500 fT/Hz^.5 may be possible. This chip-based magnetometer combines high-sensitivity and large dynamic range with small size and room temperature operation.
Detections of gravitational waves (GW) in the frequency band 35 Hz to 500 Hz have led to the birth of GW astronomy. Expected signals above 500 Hz, such as the quasinormal modes of lower mass black holes and neutron star mergers signatures are current
ly not detectable due to increasing quantum shot noise at high frequencies. Squeezed vacuum injection has been shown to allow broadband sensitivity improvement, but this technique does not change the slope of the noise at high frequency. It has been shown that white light signal recycling using negative dispersion optomechanical filter cavities with strong optical dilution for thermal noise suppression can in principle allow broadband high frequency sensitivity improvement. Here we present detailed modelling of AlGaAs/GaAs optomechanical filters to identify the available parameter space in which such filters can achieve the low thermal noise required to allow useful sensitivity improvement at high frequency. Material losses, the resolved sideband condition and internal acoustic modes dictate the need for resonators substantially smaller than previously suggested. We identify suitable resonator dimensions and show that a 30 $mu$m scale cat-flap resonator combined with optical squeezing allows 8 fold improvement of strain sensitivity at 2 kHz compared with Advanced LIGO. This corresponds to a detection volume increase of a factor of 500 for sources in this frequency range.
A specially designed and produced edge filter with pronounced nonlinear effects is carefully characterized. The nonlinear effects are estimated at the intensities close to the laser-induced damage.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
