ترغب بنشر مسار تعليمي؟ اضغط هنا

Thermal desorption characteristics of CO, O2 and CO2 on non-porous water, crystalline water and silicate surfaces at sub-monolayer and multilayer coverages

117   0   0.0 ( 0 )
 نشر من قبل Jennifer Noble
 تاريخ النشر 2011
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

The desorption characteristics of molecules on interstellar dust grains are important for modelling the behaviour of molecules in icy mantles and, critically, in describing the solid-gas interface. In this study, a series of laboratory experiments exploring the desorption of three small molecules from three astrophysically relevant surfaces are presented. The desorption of CO, O2 and CO2 at both sub-monolayer and multilayer coverages was investigated from non-porous water, crystalline water and silicate surfaces. Experimental data was modelled using the Polanyi-Wigner equation to produce a mathematical description of the desorption of each molecular species from each type of surface, uniquely describing both the monolayer and multilayer desorption in a single combined model. The implications of desorption behaviour over astrophysically relevant timescales are discussed.



قيم البحث

اقرأ أيضاً

The thermal desorption of ammonia (NH$_3$) from single crystal forsterite (010) has been investigated using temperature-programmed desorption. The effect of defects on the desorption process has been probed by the use of a rough cut forsterite surfac e prepared from the cleaved forsterite sample. Several approaches have been used to extract the desorption energy and pre-exponential factor describing the desorption kinetics. In the sub-monolayer coverage regime, the NH$_3$ desorption shows a broad distribution of desorption energies, indicating the presence of different adsorption sites, which results in an apparent coverage-dependent desorption energy. This distribution is sensitive to the surface roughness with the cut forsterite surface displaying a significantly broader distribution of desorption energies compared to the cleaved forsterite surface. The cut forsterite surface exhibits sites with desorption energies up to 62.5 kJ mol$^{-1} $ in comparison to a desorption energy of up to 58.0 kJ mol$^{-1} $ for the cleaved surface. Multilayer desorption is independent of the nature of the forsterite surface used, with a desorption energy of ($25.8pm0.9$) kJ mol$^{-1} $. On astrophysically relevant heating time-scales, the presence of a coverage dependent desorption energy distribution results in a lengthening of the NH$_3$ desorption time-scale by $5.9times 10^4$ yr compared to that expected for a single desorption energy. In addition, the presence of a larger number of high-energy adsorption sites on the rougher cut forsterite surface leads to a further lengthening of ca. 7000 yr.
Solid O2 has been proposed as a possible reservoir for oxygen in dense clouds through freeze-out processes. The aim of this work is to characterize quantitatively the physical processes that are involved in the desorption kinetics of CO-O2 ices by in terpreting laboratory temperature programmed desorption (TPD) data. This information is used to simulate the behavior of CO-O2 ices under astrophysical conditions. The TPD spectra have been recorded under ultra high vacuum conditions for pure, layered and mixed morphologies for different thicknesses, temperatures and mixing ratios. An empirical kinetic model is used to interpret the results and to provide input parameters for astrophysical models. Binding energies are determined for different ice morphologies. Independent of the ice morphology, the desorption of O2 is found to follow 0th-order kinetics. Binding energies and temperature-dependent sticking probabilities for CO-CO, O2-O2 and CO-O2 are determined. O2 is slightly less volatile than CO, with binding energies of 912+-15 versus 858+-15 K for pure ices. In mixed and layered ices, CO does not co-desorb with O2 but its binding energies are slightly increased compared with pure ice whereas those for O2 are slightly decreased. Lower limits to the sticking probabilities of CO and O2 are 0.9 and 0.85, respectively, at temperatures below 20K. The balance between accretion and desorption is studied for O2 and CO in astrophysically relevant scenarios. Only minor differences are found between the two species, i.e., both desorb between 16 and 18K in typical environments around young stars. Thus, clouds with significant abundances of gaseous CO are unlikely to have large amounts of solid O2.
We investigate the relationship between the main acceleration phase of coronal mass ejections (CMEs) and the particle acceleration in the associated flares as evidenced in RHESSI non-thermal X-rays for a set of 37 impulsive flare-CME events. CME peak velocity and peak acceleration yield distinct correlations with various parameters characterizing the flare-accelerated electron spectra. The highest correlation coefficient is obtained for the relation of the CME peak velocity and the total energy in accelerated electrons (c = 0.85), supporting the idea that the acceleration of the CME and the particle acceleration in the associated flare draw their energy from a common source, probably magnetic reconnection in the current sheet behind the erupting structure. In general, the CME peak velocity shows somewhat higher correlations with the non-thermal flare parameters than the CME peak acceleration, except for the spectral index of the accelerated electron spectrum which yields a higher correlation with the CME peak acceleration (c = -0.6), indicating that the hardness of the flare-accelerated electron spectrum is tightly coupled to the impulsive acceleration process of the rising CME structure. We also obtained high correlations between the CME initiation height $h_0$ and the non-thermal flare parameters, with the highest correlation of $h_0$ to the spectral index of flare-accelerated electrons (c = 0.8). This means that CMEs erupting at low coronal heights, i.e. in regions of stronger magnetic fields, are accompanied with flares which are more efficient to accelerate electrons to high energies. In the majority of events (80%), the non-thermal flare emission starts after the CME acceleration (6 min), giving a current sheet length at the onset of magnetic reconnection of 21 pm 7 Mm. The flare HXR peaks are well synchronized with the peak of the CME acceleration profile.
The amount of water vapor in the terrestrial atmosphere is highly variable both spatially and temporally. In the tropics it sometimes constitutes 4-5% of the atmosphere. At the same time collisional broadening of spectral lines by water vapor is much larger than that by nitrogen and oxygen. Therefore, in order to accurately characterize and model spectra of the atmospheres with significant amounts of water vapor, the line-shape parameters for spectral lines broadened by water vapor are required. In this work, the line-broadening coefficients (and their temperature dependence exponents) due to the pressure of water vapor for lines of CO2, N2O, CO, CH4, O2, NH3, and H2S from both experimental and theoretical studies were collected and carefully reviewed. A set of semi-empirical models based on these collected data was created and then used to estimate water broadening and its temperature dependence for all transitions of selected molecules in the HITRAN2016 database.
Mid-IR water lines from protoplanetary disks around T Tauri stars have a detection rate of 50%. Models have identified multiple physical properties of disks such as dust-to-gas mass ratio, dust size power law distribution, disk gas mass, disk inner r adius, and disk scale height as potential explanation for the current detection rate. We search for a connection between mid-IR water line fluxes and the strength of the 10~$mu$m silicate feature. We analyse observed water line fluxes from three blends and compute the 10~$mu$m silicate feature strength from Spitzer spectra. We use a series of published models, exploring disk dust and gas properties, and the effects of different stars. The models also show that the increasing stellar luminosity enhance simultaneously the strength of this dust feature and the water lines fluxes. No correlation is found between the observed mid-IR water lines and the 10~$mu$m silicate. Our sample shows the same difference in the peak strength between amorphous and crystalline silicates that was noted in earlier studies, but our models do not support this intrinsic difference in silicate peak strength. Individual properties of our model series are not able to reproduce the most extreme observations, suggesting that more complex dust properties are required. A parametrized settling prescription is able to boost the peak strength by a factor 2 for the standard model. Water line fluxes are unrelated to the composition of the dust. The pronounced regular trends seen in the model results are washed out in the data due to the larger diversity in stellar and disk properties compared to our model series. The disks with with weaker mid-IR water line fluxes are depleted in gas or enhanced in dust in the inner 10~au. In the case of gas depleted disks, settling produces very strong 10~$mu$m silicate features, with strong peak strength.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا