اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDisordered jammed packings of frictionless spheres
152
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
At low volume fraction, disordered arrangements of frictionless spheres are found in un--jammed states unable to support applied stresses, while at high volume fraction they are found in jammed states with mechanical strength. Here we show, focusing on the hard sphere zero pressure limit, that the transition between un-jammed and jammed states does not occur at a single value of the volume fraction, but in a whole volume fraction range. This result is obtained via the direct numerical construction of disordered jammed states with a volume fraction varying between two limits, $0.636$ and $0.646$. We identify these limits with the random loose packing volume fraction $rl$ and the random close packing volume fraction $rc$ of frictionless spheres, respectively.
قيم البحث
اقرأ أيضاً
We perform computational studies of repulsive, frictionless disks to investigate the development of stress anisotropy in mechanically stable (MS) packings. We focus on two protocols for generating MS packings: 1) isotropic compression and 2) applied
simple or pure shear strain $gamma$ at fixed packing fraction $phi$. MS packings of frictionless disks occur as geometric families (i.e. parabolic segments with positive curvature) in the $phi$-$gamma$ plane. MS packings from protocol 1 populate parabolic segments with both signs of the slope, $dphi/dgamma >0$ and $dphi/dgamma <0$. In contrast, MS packings from protocol 2 populate segments with $dphi/dgamma <0$ only. For both simple and pure shear, we derive a relationship between the stress anisotropy and dilatancy $dphi/dgamma$ obeyed by MS packings along geometrical families. We show that for MS packings prepared using isotropic compression, the stress anisotropy distribution is Gaussian centered at zero with a standard deviation that decreases with increasing system size. For shear jammed MS packings, the stress anisotropy distribution is a convolution of Weibull distributions that depend on strain, which has a nonzero average and standard deviation in the large-system limit. We also develop a framework to calculate the stress anisotropy distribution for packings generated via protocol 2 in terms of the stress anisotropy distribution for packings generated via protocol 1. These results emphasize that for repulsive frictionless disks, different packing-generation protocols give rise to different MS packing probabilities, which lead to differences in macroscopic properties of MS packings.
We present simulation results on the properties of packings of frictionless spherocylindrical particles. Starting from a random distribution of particles in space, a packing is produced by minimizing the potential energy of inter-particle contacts un
til a force-equilibrated state is reached. For different particle aspect ratios $alpha=10ldots 40$, we calculate contacts $z$, pressure as well as bulk and shear modulus. Most important is the fraction $f_0$ of spherocylinders with contacts at both ends as it governs the jamming threshold $z_c(f_0)=8+2f_0$. These results highlight the important role of the axial sliding degree of freedom of a spherocylinder, which is a zero-energy mode but only if no end-contacts are present.
By calculating the linear response of packings of soft frictionless discs to quasistatic external perturbations, we investigate the critical scaling behavior of their elastic properties and non-affine deformations as a function of the distance to jam
ming. Averaged over an ensemble of similar packings, these systems are well described by elasticity, while in single packings we determine a diverging length scale $ell^*$ up to which the response of the system is dominated by the local packing disorder. This length scale, which we observe directly, diverges as $1/Delta z$, where $Delta z$ is the difference between contact number and its isostatic value, and appears to scale identically to the length scale which had been introduced earlier in the interpretation of the spectrum of vibrational modes. It governs the crossover from isostatic behavior at the small scale to continuum behavior at the large scale; indeed we identify this length scale with the coarse graining length needed to obtain a smooth stress field. We characterize the non-affine displacements of the particles using the emph{displacement angle distribution}, a local measure for the amount of relative sliding, and analyze the connection between local relative displacements and the elastic moduli.
Contact breaking and Hertzian interactions between grains can both give rise to nonlinear vibrational response of static granular packings. We perform molecular dynamics simulations at constant energy in 2D of frictionless bidisperse disks that inter
act via Hertzian spring potentials as a function of energy and measure directly the vibrational response from the Fourier transform of the velocity autocorrelation function. We compare the measured vibrational response of static packings near jamming onset to that obtained from the eigenvalues of the dynamical matrix to determine the temperature above which the linear response breaks down. We compare packings that interact via single-sided (purely repulsive) and double-sided Hertzian spring interactions to disentangle the effects of the shape of the potential from contact breaking. Our studies show that while Hertzian interactions lead to weak nonlinearities in the vibrational behavior (e.g. the generation of harmonics of the eigenfrequencies of the dynamical matrix), the vibrational response of static packings with Hertzian contact interactions is dominated by contact breaking as found for systems with repulsive linear spring interactions.
We focus on the response of mechanically stable (MS) packings of frictionless, bidisperse disks to thermal fluctuations, with the aim of quantifying how nonlinearities affect system properties at finite temperature. Packings of disks with purely repu
lsive contact interactions possess two main types of nonlinearities, one from the form of the interaction potential and one from the breaking (or forming) of interparticle contacts. To identify the temperature regime at which the contact-breaking nonlinearities begin to contribute, we first calculated the minimum temperatures $T_{cb}$ required to break a single contact in the MS packing for both single and multiple eigenmode perturbations of the $T=0$ MS packing. We then studied deviations in the constant volume specific heat $C_V$ and deviations of the average disk positions $Delta r$ from their $T=0$ values in the temperature regime $T_{cb} < T < T_{r}$, where $T_r$ is the temperature beyond which the system samples the basin of a new MS packing. We find that the deviation in the specific heat per particle $Delta {overline C}_V^0/{overline C}_V^0$ relative to the zero temperature value ${overline C}_V^0$ can grow rapidly above $T_{cb}$, however, the deviation $Delta {overline C}_V^0/{overline C}_V^0$ decreases as $N^{-1}$ with increasing system size. To characterize the relative strength of contact-breaking versus form nonlinearities, we measured the ratio of the average position deviations $Delta r^{ss}/Delta r^{ds}$ for single- and double-sided linear and nonlinear spring interactions. We find that $Delta r^{ss}/Delta r^{ds} > 100$ for linear spring interactions and is independent of system size.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
