اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSimulation Study of Sulfonate Cluster Swelling in Ionomers
96
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have performed simulations to study how increasing humidity affects the structure of Nafion-like ionomers under conditions of low sulfonate concentration and low humidity. At the onset of membrane hydration, the clusters split into smaller parts. These subsequently swell, but then maintain constant the number of sulfonates per cluster. We find that the distribution of water in low-sulfonate membranes depends strongly on the sulfonate concentration. For a relatively low sulfonate concentration, nearly all the side-chain terminal groups are within cluster formations, and the average water loading per cluster matches the water content of membrane. However, for a relatively higher sulfonate concentration the water-to-sulfonate ratio becomes non-uniform. The clusters become wetter, while the inter-cluster bridges become drier. We note the formation of unusual shells of water-rich material that surround the sulfonate clusters.
قيم البحث
اقرأ أيضاً
Solid polymer electrolytes are considered a promising alternative to traditional liquid electrolytes in energy storage applications because of their good mechanical properties, and excellent thermal and chemical stability. A gap, however, still exist
s in understanding ion transport mechanisms and improving ion transport in solid polymer electrolytes. Therefore, it is crucial to bridge composition--structure and structure--property relationships. Here we demonstrate that size asymmetry, $lambda$, represented by the ratio of counterion to charged monomer size, plays a key role in both the nanostructure and in the ionic dynamics. More specifically, when the nanostructure is modified by the external electric field such that the mobility cannot be described by linear response theory, two situations arise. The ionic mobility increases as $lambda$ decreases (small counterions) in the weak electrostatics (high dielectric constant) regime. Whereas in systems with strong electrostatic interactions, ionomers with higher size symmetry ($lambda approx 1$) display higher ionic mobility. Moreover, ion transport is found to be dominated by the hopping of the ions and not by moving ionic clusters (also known as vehicular charge transport). These results serve as a guide for designing ion-containing polymers for ion transport related applications.
Direct modeling of porous materials under shock is a complex issue. We investigate such a system via the newly developed material-point method. The effects of shock strength and porosity size are the main concerns. For the same porosity, the effects
of mean-void-size are checked. It is found that, local turbulence mixing and volume dissipation are two important mechanisms for transformation of kinetic energy to heat. When the porosity is very small, the shocked portion may arrive at a dynamical steady state; the voids in the downstream portion reflect back rarefactive waves and result in slight oscillations of mean density and pressure; for the same value of porosity, a larger mean-void-size makes a higher mean temperature. When the porosity becomes large, hydrodynamic quantities vary with time during the whole shock-loading procedure: after the initial stage, the mean density and pressure decrease, but the temperature increases with a higher rate. The distributions of local density, pressure, temperature and particle-velocity are generally non-Gaussian and vary with time. The changing rates depend on the porosity value, mean-void-size and shock strength. The stronger the loaded shock, the stronger the porosity effects. This work provides a supplement to experiments for the very quick procedures and reveals more fundamental mechanisms in energy and momentum transportation.
Electrolytes as nanostructured materials are very attractive for batteries or other types of electronic devices. (PEO)8ZnCl2 polymer electrolytes and nanocomposites (PEO)8ZnCl2/TiO2 were prepared from PEO and ZnCl2 and with addition of TiO2 nanograin
s. The influence of TiO2 nanograins was studied by small-angle X-ray scattering (SAXS) simultaneously recorded with wide-angle X-ray scattering (WAXS) and differential scanning calorimetry (DSC) at the synchrotron ELETTRA. It was shown by previous impedance spectroscopy (IS) that the room temperature conductivity of nanocomposite polymer electrolyte increased more than two times above 65oC, relative to pure composites of PEO and salts. The SAXS/DSC measurements yielded insight into the temperature-dependent changes of the grains of the electrolyte as well as to differences due to different heating and cooling rates. The crystal structure and temperatures of melting and crystallization of the nanosize grains was revealed by the simultaneous WAXS measurements.
Oriented block copolymers exhibit a buckling instability when submitted to a tensile test perpendicular to the lamellae direction. In this paper we study this behavior using a coarse grained molecular dynamics simulation approach. Coarse grained mode
ls of lamellar copolymers with alternate glassy rubbery layers are generated using the Radical Like Polymerization method, and their mechanical response is studied. For large enough systems, uniaxial tensile tests perpendicular to the direction of the lamellae reveal the occurrence of the buckling instability at low strain. The results that emerge from molecular simulation are compared to an elastic theory of the buckling instability introduced by Read and coworkers. At high strain rates, significant differences are observed between elastic theory and simulation results for the buckling strain and the buckling wavelength. We explain this difference by the strain rate dependence of the mechanical response. A simple model that takes into account the influence of the strain rate in the mechanical response is presented to rationalize the results at low and moderate strain rates. At very high strain rates, cavitation takes place in the rubbery phase of the sample and limits the validity of the approach.
From soft polymeric gels to hardened cement paste, amorphous solids under constant load exhibit a pronounced time-dependent deformation called creep. The microscopic mechanism of such a phenomenon is poorly understood and constitutes a significant ch
allenge in densely packed and chemically reactive granular systems. Both features are prominently present in hydrating cement pastes composed of calcium silicate hydrate (C-S-H) nanoparticles, whose packing density increases as a function of time, while cements hydration is taking place. Performing nano-indentation tests and porosity measurements on a large collection of samples at various hydration degrees, we show that the creep response of hydrating cement paste is mainly controlled by the inter-particle distance, and results from slippage between (C-S-H) nanoparticles. Our findings, which pave the way for the design of concrete with improved creep resistance, provide a unique insight into the microscopic mechanism underpinning the creep response in aging granular materials.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
