اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدModeling and Reproducibility of Suzaku HXD PIN/GSO Background
184
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Suzaku Hard X-ray Detector (HXD) achieved the lowest background level than any other previously or currently operational missions sensitive in the energy range of 10--600 keV, by utilizing PIN photodiodes and GSO scintillators mounted in the BGO active shields to reject particle background and Compton-scattered events as much as possible. Because it does not have imaging capability nor rocking mode for the background monitor, the sensitivity is limited by the reproducibility of the non X-ray background (NXB) model. We modeled the HXD NXB, which varies with time as well as other satellites with a low-earth orbit, by utilizing several parameters, including particle monitor counts and satellite orbital/attitude information. The model background is supplied as an event file in which the background events are generated by random numbers, and can be analyzed in the same way as the real data. The reproducibility of the NXB model depends on the event selection criteria (such as cut-off rigidity and energy band) and the integration time, and the 1sigma systematic error is estimated to be less than 3% (PIN 15--40 keV) and 1% (GSO 50--100 keV) for more than 10 ksec exposure.
قيم البحث
اقرأ أيضاً
Improvements of in-orbit calibration of GSO scintillators in the Hard X-ray Detector on board Suzaku are reported. To resolve an apparent change of the energy scale of GSO which appeared across the launch for unknown reasons, consistent and thorough
re-analyses of both pre-launch and in-orbit data have been performed. With laboratory experiments using spare hardware, the pulse height offset, corresponding to zero energy input, was found to change by ~0.5 of the full analog voltage scale, depending on the power supply. Furthermore, by carefully calculating all the light outputs of secondaries from activation lines used in the in-orbit gain determination, their energy deposits in GSO were found to be effectively lower, by several percent, than their nominal energies. Taking both these effects into account, the in-orbit data agrees with the on-ground measurements within ~5%, without employing the artificial correction introduced in the previous work (Kokubun et al. 2007). With this knowledge, we updated the data processing, the response, and the auxiliary files of GSO, and reproduced the HXD-PIN and HXD-GSO spectra of the Crab Nebula over 12-300 keV by a broken powerlaw with a break energy of ~110 keV.
The Hard X-ray Detector (HXD) on board Suzaku covers a wide energy range from 10 keV to 600 keV by combination of silicon PIN diodes and GSO scintillators. The HXD is designed to achieve an extremely low in-orbit back ground based on a combination of
new techniques, including the concept of well-type active shield counter. With an effective area of 142 cm^2 at 20 keV and 273 cm2 at 150 keV, the background level at the sea level reached ~1x10^{-5} cts s^{-1} cm^{-2} keV^{-1} at 30 keV for the PI N diodes, and ~2x10^{-5} cts s^{-1} cm^{-2} keV^{-1} at 100 keV, and ~7x10^{-6} cts s^{-1} cm^{-2} keV^{-1} at 200 keV for the phoswich counter. Tight active shielding of the HXD results in a large array of guard counters surrounding the main detector parts. These anti-coincidence counters, made of ~4 cm thick BGO crystals, have a large effective area for sub-MeV to MeV gamma-rays. They work as an excellent gamma-ray burst monitor with limited angular resolution (~5 degree). The on-board signal-processing system and the data transmitted to the ground are also described.
PolarLight is a gas pixel X-ray polarimeter mounted on a CubeSat, which was launched into a Sun-synchronous orbit in October 2018. We build a mass model of the whole CubeSat with the Geant4 toolkit to simulate the background induced by the cosmic X-r
ay background (CXB) and high energy charged particles in the orbit. The simulated energy spectra and morphologies of event images both suggest that the measured background with PolarLight is dominated by high energy electrons, with a minor contribution from protons and the CXB. The simulation reveals that, in the energy range of 2-8 keV, there are roughly 28% of the background events are caused by energy deposit from a secondary electron with an energy of a few keV, in a physical process identical to the detection of X-rays. Thus, this fraction of background cannot be discriminated from X-ray events. The background distribution is uneven on the detector plane, with an enhancement near the edges. The edge effect is because high energy electrons tend to produce long tracks, which are discarded by the readout electronics unless they have partial energy deposits near the edges. The internal background rate is expected to be around 6 x 10^-3 counts/s/cm2 in 2-8 keV if an effective particle discrimination algorithm can be applied. This indicates that the internal background should be negligible for future focusing X-ray polarimeters with a focal size in the order of mm.
We present a 3-dimensional (3D) numerical solver of the linearized compressible Euler equations (GALE -- Global Acoustic Linearized Euler), used to model acoustic oscillations throughout the solar interior. The governing equations are solved in conse
rvation form on a fully global spherical mesh ($0 le phi le 2pi$, $0 le theta le pi$, $0 le r le R_{odot}$) over a background state generated by the standard Solar Model S. We implement an efficient pseudo-spectral computational method to calculate the contribution of the compressible material derivative dyad to internal velocity perturbations, computing oscillations over arbitrary 3D background velocity fields. This model offers a foundation for a forward-modeling approach, using helioseismology techniques to explore various regimes of internal mass flows. We demonstrate the efficacy of the numerical method presented in this paper by reproducing observed solar power spectra, showing rotational splitting due to differential rotation, and applying local helioseismology techniques to measure travel times created by a simple model of single-cell meridional circulation.
We present a background model for dark matter searches using an array of NaI(Tl) crystals in the COSINE-100 experiment that is located in the Yangyang underground laboratory. The model includes background contributions from both internal and external
sources, including cosmogenic radionuclides and surface $^{210}$Pb contamination. To improve the model in the low energy region, with the threshold lowered to 1 keV, we used a depth profile of $^{210}$Pb contamination in the surface of the NaI(Tl) crystals determined in a comparison between measured and simulated spectra. We also considered the effect of the energy scale errors propagated from the statistical uncertainties and the nonlinear detector response at low energies. The 1.7 years COSINE-100 data taken between October 21, 2016 and July 18, 2018 were used for this analysis. The Geant4 toolkit version 10.4.2 was utilized throughout the Monte Carlo simulations for the possible internal and external origins. In particular, the version provides a non-Gaussian peak around 50 keV originating from beta decays of $^{210}$Pb in a good agreement with the measured background. This improved model estimates that the activities of $^{210}$Pb and $^{3}$H are the dominant sources of the backgrounds with an average level of 2.73$pm$0.14 counts/day/keV/kg in the energy region of 1-6 keV, using COSINE-100 data with a total exposure of 97.7 kg$cdot$years.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
