اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCurrent-perpendicular-to-plane giant magnetoresistance of a spin valve using Co2MnSi Heusler alloy electrodes
130
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report the current-perpendicular-to-plane giant magnetoresistance of a spin valve with Co2MnSi (CMS) Heusler alloy ferromagnetic electrodes. A multilayer stack of Cr/Ag/Cr/CMS/Cu/CMS/Fe25Co75/Ir28Mn72/Ru was deposited on a MgO (001) single crystal substrate. The bottom CMS layer was epitaxially grown on the Cr/Ag/Cr buffer layers and was ordered to the L21 structure after annealing at 673 K. The upper CMS layer was found to grow epitaxially on the Cu spacer layer despite the large lattice mismatch between Cu and CMS. The highest MR ratios of 8.6% and 30.7% for CPP-GMR were recorded at room temperature and 6 K, respectively. The high spin polarization of the epitaxial CMS layers is the most likely origin of the high MR ratio.
قيم البحث
اقرأ أيضاً
Half Metal Magnets are of great interest in the field of spintronics because of their potential full spin-polarization at the Fermi level and low magnetization damping. The high Curie temperature and predicted 0.7eV minority spin gap make the Heusler
alloy Co2MnSi very promising for applications.We investigated the half-metallic magnetic character of this alloy using spin-resolved photoemission, ab initio calculation and ferromagnetic resonance. At the surface of Co2MnSi, a gap in the minority spin channel is observed, leading to 100% spin polarization. However, this gap is 0.3 eV below the Fermi level and a minority spin state is observed at the Fermi level. We show that a minority spin gap at the Fermi energy can nevertheless be recovered either by changing the stoichiometry of the alloy or by covering the surface by Mn, MnSi or MgO. This results in extremely small damping coefficients reaching values as low as 7x 10-4.
We report the evolution of magnetic moment as well as magnetic anisotropy with crystalline order in Co$_2$MnSi thin films grown on $(100)$ MgO by pulsed laser deposition. The films become more ordered as the annealing temperature ($T_A$) increases fr
om 400 to 600 $^0$C. The extent of emph{L}$2_1$ ordering in the films annealed at 600 $^0$C is $approx 96%$. The static magnetization measurements by vibrating sample magnetometry shows a maximum moment of 4.95 $mu_B$ per formula unit with low coercivity ($H_C$ $approx$ 65 Oe) in the films annealed at 600 $^0$C. A rigorous analysis of the azimuthal and polar angle dependent ferromagnetic resonance (FMR) measured at several temperatures allows determination of various anisotropy fields relevant to our system as a function of $T_A$. Finally, we have evaluated the exchange stiffness constant down to 100 K using spin wave modes in FMR spectra. We have also estimated the exchange energies as well as stiffness constant by varying the lattice parameter emph{ab-initio} using the Korringa-Kohn-Rostoker method.
The charge and spin diffusion equations taking into account spin-flip and spin-transfer torque were numerically solved using a finite element method in complex non-collinear geometry with strongly inhomogeneous current flow. As an illustration, spin-
dependent transport through a non-magnetic nanoconstriction separating two magnetic layers was investigated. Unexpected results such as vortices of spin-currents in the vicinity of the nanoconstriction were obtained. The angular variations of magnetoresistance and spin-transfer torque are strongly influenced by the structure geometry.
HRTEM, nano-beam electronic diffraction, energy dispersive X-rays scanning spectroscopy, Vibrating Sample Magnetometry (VSM) and FerroMagnetic Resonance (FMR) techniques are used in view of comparing (static and dynamic) magnetic and structural prope
rties of Co2MnGe (13 nm)/Al2O3 (3 nm)/Co (13 nm) tunnel magnetic junctions (TMJ), deposited on various single crystalline substrates (a-plane sapphire, MgO(100) and Si(111)). They allow for providing a correlation between these magnetic properties and the fine structure investigated at atomic scale. The Al2O3 tunnel barrier is always amorphous and contains a large concentration of Co atoms, which, however, is significantly reduced when using a sapphire substrate. The Co layer is polycrystalline and shows larger grains for films grown on a sapphire substrate. The VSM investigation reveals in-plane anisotropy only for samples grown on a sapphire substrate. The FMR spectra of the TMJs are compared to the obtained ones with a single Co and Co2MnGe films of identical thickness deposited on a sapphire substrate. As expected, two distinct modes are detected in the TMJs while only one mode is observed in each single film. For the TMJ grown on a sapphire substrate the FMR behavior does not significantly differ from the superposition of the individual spectra of the single films, allowing for concluding that the exchange coupling between the two magnetic layers is too small to give rise to observable shifts. For TMJs grown on a Si or on a MgO substrate the resonance spectra reveal one mode which is nearly identical to the obtained one in the single Co film, while the other observed resonance shows a considerably smaller intensity and cannot be described using the magnetic parameters appropriate to the single Co2MnGe film.
We demonstrate room-temperature stabilization of dipolar magnetic skyrmions with diameters in the range of $100$ nm in a single ultrathin layer of the Heusler alloy Co$_2$FeAl (CFA) under moderate magnetic fields. Current-induced skyrmion dynamics in
microwires is studied with a scanning Nitrogen-Vacancy magnetometer operating in the photoluminescence quenching mode. We first demonstrate skyrmion nucleation by spin-orbit torque and show that its efficiency can be significantly improved using tilted magnetic fields, an effect which is not specific to Heusler alloys and could be advantageous for future skyrmion-based devices. We then show that current-induced skyrmion motion remains limited by strong pinning effects, even though CFA is a magnetic material with a low magnetic damping parameter.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
