اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDynamic interfaces in an organic thin film
170
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Low-dimensional boundaries between phases and domains in organic thin films are important in charge transport and recombination. Here, fluctuations of interfacial boundaries in an organic thin film, acridine-9-carboxylic acid (ACA) on Ag(111), have been visualized in real time, and measured quantitatively, using Scanning Tunneling Microscopy. The boundaries fluctuate via molecular exchange with exchange time constants of 10-30 ms at room temperature, yielding length mode fluctuations that should yield characteristic f-1/2 signatures for frequencies less than ~100 Hz. Although ACA has highly anisotropic intermolecular interactions, it forms islands that are compact in shape with crystallographically distinct boundaries that have essentially identical thermodynamic and kinetic properties . The physical basis of the modified symmetry is shown to arise from significantly different substrate interactions induced by alternating orientations of successive molecules in the condensed phase. Incorporating this additional set of interactions in a lattice gas model leads to effective multi-component behavior, as in the Blume-Emery-Griffiths (BEG) model, and can straightforwardly reproduce the experimentally observed isotropic behavior. The general multi-component description allows the domain shapes and boundary fluctuations to be tuned from isotropic to highly anisotropic in terms of the balance between intermolecular interactions and molecule-substrate interactions. Key words: Organic thin film, fluctuations, STM, molecular interactions, diffusion kinetics, phase coexistence
قيم البحث
اقرأ أيضاً
Order-disorder processes fundamentally determine the structure and properties of many important oxide systems for energy and computing applications. While these processes have been intensively studied in bulk materials, they are less investigated and
understood for nanostructured oxides in highly non-equilibrium conditions. These systems can now be realized through a range of deposition techniques and probed at exceptional spatial and chemical resolution, leading to a greater focus on interface dynamics. Here we survey a selection of recent studies of order-disorder behavior at thin film oxide interfaces, with a particular emphasis on the emergence of order during synthesis and disorder in extreme irradiation environments. We summarize key trends and identify directions for future study in this growing research area.
Silicene, a new two-dimensional (2D) material has attracted intense research because of the ubiquitous use of silicon in modern technology. However, producing free-standing silicene has proved to be a huge challenge. Until now, silicene could be synt
hesized only on metal surfaces where it naturally forms strong interactions with the metal substrate that modify its electronic properties. Here, we report the first experimental evidence of silicene sheet on an insulating NaCl thin film. This work represents a major breakthrough; for the study of the intrinsic properties of silicene, and by extension to other 2D materials that have so far only been grown on metal surfaces.
The effect of the AlOx barrier thickness on magnetic and morphological properties of Ta/Co/(AlOx)/Alq3/Si hybrid structures was systematically studied by means of atomic force microscopy, SQUID magnetometry and nuclear magnetic resonance (NMR). All u
sed techniques pointed out that the barrier thickness of 2 nm is required to obtain a magnetically good cobalt layer on top of Alq3. 59Co NMR measurements revealed that the AlOx barrier gives rise to the formation of an interface layer with defective cobalt favouring growth of bulk cobalt with good magnetic properties.
Rare earth nickelates RENiO3 which attract interest due to their sharp metal-insulator phase transition, are instable in bulk form due to the necessity of an important oxygen pressure to stabilize Ni in its 3+ state of oxidation. Here, we report the
stabilization of rare earth nickelates in [(SmNiO3)t/(NdNiO3)t]n thin film multilayers, t being the thickness of layers alternated n times. Both bilayers and multilayers have been deposited by Metal-Organic Chemical Vapour Deposition. The multilayer structure and the presence of the metastable phases SmNiO3 and NdNiO3 are evidenced from by X-ray and Raman scattering. Electric measurements of a bilayer structure further support the structural quality of the embedded rare earth nickelate layers.
Despite the imperative importance in solar-cell efficiency, the intriguing phenomena at the interface between perovskite solar-cell and adjacent carrier transfer layers are hardly uncovered. Here we show that PbI$_2$/AI-terminated lead-iodide-perovsk
ite (APbI$_3$; A=Cs$^+$/ methylammonium(MA)) interfaced with the charge transport medium of graphene or TiO2 exhibits the sizable/robust Rashba-Dresselhaus (RD) effect using density-functional-theory and ab initio molecular dynamics (AIMD) simulations above cubic-phase temperature. At the PbI$_2$-terminated graphene/CsPbI3(001) interface, ferroelectric distortion towards graphene facilitates an inversion breaking field. At the MAI-terminated TiO$_2$/MAPbI$_3$(001) interface, the enrooted alignment of MA$^+$ towards TiO$_2$ by short-strong hydrogen-bonding and the concomitant PbI$_3$ distortion preserve the RD interactions even above 330 K. The robust RD effect at the interface even at high temperatures, unlike in bulk, changes the direct-type band to the indirect to suppress recombination of electron and hole, thereby letting these accumulated carriers overcome the potential barrier between perovskite and charge transfer materials, which promotes the solar-cell efficiency.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
