اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدExtreme resistance of super-hydrophobic surfaces to impalement: reversible electrowetting related to the impacting/bouncing drop test
244
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The paper reports on the comparison of the wetting properties of super-hydrophobic silicon nanowires (NWs), using drop impact impalement and electrowetting (EW) experiments. A correlation between the resistance to impalement on both EW and drop impact is shown. From the results, it is evident that when increasing the length and density of NWs: (i) the thresholds for drop impact and EW irreversibility increase (ii) the contact-angle hysteresis after impalement decreases. This suggests that the structure of the NWs network could allow for partial impalement, hence preserving the reversibility, and that EW acts the same way as an external pressure. The most robust of our surfaces show a threshold to impalement higher than 35 kPa, while most of the super-hydrophobic surfaces tested so far have impalement threshold smaller than 10 kPa.
قيم البحث
اقرأ أيضاً
When a solid projectile is dropped onto a dense non-Brownian-particle suspension, the action of an extremely large resistance force on the projectile results in its drastic deceleration, followed by a rebound. In this study, we perform a set of simpl
e experiments of dropping a solid-projectile impact onto a dense potato-starch suspension. From the kinematic data of the projectile motion, the restitution coefficient and timescale of the rebound are measured. By assuming linear viscoelasticity, the effective transient elasticity and viscosity can be estimated. We additionally estimate the Stokes viscosity on a longer timescale by measuring the slow sinking time of the projectile. The estimated elastic modulus and viscosity are consistent with separately measured previous results. In addition, the effect of mechanical vibration on the viscoelasticity is examined. As a result, we find that the viscoelasticity of the impacted dense suspension is not significantly affected by the mechanical vibration.
The impact of liquid drops on solid surfaces is ubiquitous in nature, and of practical importance in many industrial processes. A drop hitting a flat surface retains a circular symmetry throughout the impact process. Here we show that a drop impingin
g on Echevaria leaves exhibits asymmetric bouncing dynamics with distinct spreading and retraction along two perpendicular directions. This is a direct consequence of the cylindrical leaves which have a convex/concave architecture of size comparable to the drop. Systematic experimental investigations on mimetic surfaces and lattice Boltzmann simulations reveal that this novel phenomenon results from an asymmetric momentum and mass distribution that allows for preferential fluid pumping around the drop rim. The asymmetry of the bouncing leads to ~40% reduction in contact time.
Recent experiments by Kavousanakis et al., Langmuir, 2018 [1], showed that reversible electrowetting on superhydrophobic surfaces can be achieved by using a thick solid dielectric layer (e.g. tens of micrometers). It has also been shown, through equi
librium (static) computations, that when the dielectric layer is thick enough the electrostatic pressure is smoothly distributed along the droplet surface, thus the irreversible Cassie to Wenzel wetting transitions can be prevented. In the present work we perform more realistic, dynamic simulations of the electrostatically-induced spreading on superhydrophobic surfaces. To this end, we employ an efficient numerical scheme which enables us to fully take into account the topography of the solid substrate. We investigate in detail the role of the various characteristics of the substrate (i.e. the dielectric thickness, geometry and material wettability) and present relevant flow maps for the resulting wetting states. Through our dynamic simulations, we identify the conditions under which it is possible to achieve reversible electrowetting. We have found that not only the collapse (Cassie-Baxter to Wenzel) transitions but also the contact angle hysteresis of the substrate significantly affects the reversibility.
A fluid droplet located on a super-hydrophobic surface makes contact with the surface only at small isolated regions, and is mostly in contact with the surrounding air. As a result, a fluid in motion near such a surface experiences very low friction,
and super-hydrophobic surfaces display strong drag-reduction in the laminar regime. Here we consider theoretically a super-hydrophobic surface composed of circular posts (so called fakir geometry) located on a planar rectangular lattice. Using a superposition of point forces with suitably spatially-dependent strength, we derive the effective surface slip length for a planar shear flow on such a fakir surface as the solution to an infinite series of linear equations. In the asymptotic limit of small surface coverage by the posts, the series can be interpreted as Riemann sums, and the slip length can be obtained analytically. For posts on a square lattice, our analytical results are in excellent quantitative agreement with previous numerical computations.
Liquid water can become metastable with respect to its vapor in hydrophobic confinement. The resulting dewetting transitions are often impeded by large kinetic barriers. According to macroscopic theory, such barriers arise from the free energy requir
ed to nucleate a critical vapor tube that spans the region between two hydrophobic surfaces - tubes with smaller radii collapse, whereas larger ones grow to dry the entire confined region. Using extensive molecular simulations of water between two nanoscopic hydrophobic surfaces, in conjunction with advanced sampling techniques, here we show that for inter-surface separations that thermodynamically favor dewetting, the barrier to dewetting does not correspond to the formation of a (classical) critical vapor tube. Instead, it corresponds to an abrupt transition from an isolated cavity adjacent to one of the confining surfaces to a gap-spanning vapor tube that is already larger than the critical vapor tube anticipated by macroscopic theory. Correspondingly, the barrier to dewetting is also smaller than the classical expectation. We show that the peculiar nature of water density fluctuations adjacent to extended hydrophobic surfaces - namely, the enhanced likelihood of observing low-density fluctuations relative to Gaussian statistics - facilitates this non-classical behavior. By stabilizing isolated cavities relative to vapor tubes, enhanced water density fluctuations thus stabilize novel pathways, which circumvent the classical barriers and offer diminished resistance to dewetting. Our results thus suggest a key role for fluctuations in speeding up the kinetics of numerous phenomena ranging from Cassie-Wenzel transitions on superhydrophobic surfaces, to hydrophobically-driven biomolecular folding and assembly.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
