اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh-Frequency Microstrip Cross Resonators for Circular Polarization EPR Spectroscopy
159
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this article we discuss the design and implementation of a novel microstrip resonator which allows for the absolute control of the microwaves polarization degree for frequencies up to 30 GHz. The sensor is composed of two half-wavelength microstrip line resonators, designed to match the 50 Ohms impedance of the lines on a high dielectric constant GaAs substrate. The line resonators cross each other perpendicularly through their centers, forming a cross. Microstrip feed lines are coupled through small gaps to three arms of the cross to connect the resonator to the excitation ports. The control of the relative magnitude and phase between the two microwave stimuli at the input ports of each line allows for tuning the degree and type of polarization of the microwave excitation at the center of the cross resonator. The third (output) port is used to measure the transmitted signal, which is crucial to work at low temperatures, where reflections along lengthy coaxial lines mask the signal reflected by the resonator. EPR spectra recorded at low temperature in an S= 5/2 molecular magnet system show that 82%-fidelity circular polarization of the microwaves is achieved over the central area of the resonator.
قيم البحث
اقرأ أيضاً
We have studied damping in polycrystalline Al nanomechanical resonators by measuring the temperature dependence of their resonance frequency and quality factor over a temperature range of 0.1 - 4 K. Two regimes are clearly distinguished with a crosso
ver temperature of 1 K. Below 1 K we observe a logarithmic temperature dependence of the frequency and linear dependence of damping that cannot be explained by the existing standard models. We attribute these phenomena to the effect of the two-level systems characterized by the unexpectedly long (at least two orders of magnitude longer) relaxation times and discuss possible microscopic models for such systems. We conclude that the dynamics of the two-level systems is dominated by their interaction with one-dimensional phonon modes of the resonators.
Aluminum nitride (AlN) has been widely used in microeletromechanical resonators for its excellent electromechanical properties. Here we demonstrate the use of AlN as an optomechanical material that simultaneously offer low optical and mechanical loss
. Integrated AlN microring resonators in the shape of suspended rings exhibit high optical quality factor (Q) with loaded Q up to 125,000. Optomechanical transduction of the Brownian motion of a GHz contour mode yields a displacement sensitivity of 6.2times10^(-18)m/Hz^(1/2) in ambient air.
We consider a quantum-mechanical system, finite or extended, initially in its ground-state, exposed to a time-dependent potential pulse, with a slowly varying envelope and a carrier frequency $omega_0$. By working out a rigorous solution of the time-
dependent Schrodinger equation in the high-$omega_0$ limit, we show that the linear response is completely suppressed after the switch-off of the pulse. We show, at the same time, that to the lowest order in $omega_0^{-1}$, observables are given in terms of the linear density response function $chi(rv,rv,omega)$, despite the problems nonlinearity. We propose a new spectroscopic technique based on these findings, which we name the Nonlinear High-Frequency Pulsed Spectroscopy (NLHFPS). An analysis of the jellium slab and sphere models reveals very high surface sensitivity of NLHFPS, which produces a richer excitation spectrum than accessible within the linear-response regime. Combining the advantages of the extraordinary surface sensitivity, the absence of constraints by the conventional dipole selection rules, and the ease of theoretical interpretation by means of the linear response time-dependent density functional theory, NLHFPS has the potential to evolve into a powerful characterization method in nanoscience and nanotechnology.
Stochastic switching between the two bistable states of a strongly driven mechanical resonator enables detection of weak signals based on probability distributions, in a manner that mimics biological systems. However, conventional silicon resonators
at the microscale require a large amount of fluctuation power to achieve a switching rate in the order of a few Hertz. Here, we employ graphene membrane resonators of atomic thickness to achieve a stochastic switching rate of 7.8 kHz, which is 200 times faster than current state-of-the-art. The (effective) temperature of the fluctuations is approximately 400 K, which is 3000 times lower than the state-of-the-art. This shows that these membranes are potentially useful to transduce weak signals in the audible frequency domain. Furthermore, we perform numerical simulations to understand the transition dynamics of the resonator and derive simple analytical expressions to investigate the relevant scaling parameters that allow high-frequency, low-temperature stochastic switching to be achieved in mechanical resonators.
A high-frequency (95 GHz) EPR study is reported on single crystals of the planar tetranuclear complex Fe4(OCH3)6(dpm)6 (where Hdpm = dipivaloylmethane), which has been previously shown to present typical single-molecule magnet behaviour. The spectra,
all originating from the S = 5 ground state, possess quasi-axial symmetry along the normal to the plane defined by the four Fe(III) ions. The measured spectra are shown to belong to three different structural variations of the compound, resulting from disorder in the ligands around two of the Fe(III) ions. Accurate values could be obtained for the second- and fourth-order crystal field parameters related to the parallel EPR-spectra, while the other parameters could be determined only for the dominant species. The separation between individual lines is decreasing and vanishing with increasing temperature. This effect is attributed to the contribution of fast relaxing excited states, whose population is varying with temperature.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
