اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUltra-Thin Silver Films obtained by Sequential Quench-Anneal Processing
95
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have used the two-step growth technique, quench condensing followed by an anneal, to grow ultra thin films of silver on glass substrates. As has been seen with semiconductor substrates this process produces a metastable homogeneous covering of silver. By measuring the in situ resistance of the film during growth we are able to see that the low temperature growth onto substrates held at 100 Kelvin produces a precursor phase that is insulating until the film has been annealed. The transformation of the precursor phase into the final, metallic silver film occurs at a characteristic temperature near 150K where the sample reconstructs. This reconstruction is accompanied by a decrease in resistance of up to 10 orders of magnitude.
قيم البحث
اقرأ أيضاً
We report on the heteroepitaxial stabilization of YCrO3 ultra-thin films on LSAT (001) substrate. Using a combination of resonant X-ray absorption spectroscopy (XAS) and atomic multiplet cluster calculation, the electronic structure of YCrO3 thin fil
m was investigated. Polarization dependent Cr L3,2 edge XAS measurement reveal the presence of an anomalous orbital polarization uncharacteristic of a 3d3 electronic system. Atomic multiplet calculations demonstrate the critical importance of charge transfer energy, Coulomb correlation strength and hopping interaction in stabilizing this unusual orbital polarized state likely connected to the bulk multiferroicity.
The temperature dependence of peak widths in high resolution angle-resolved photoelectron spectroscopy from quantum well states in ultra thin Ag films on V(100) has been used to determine the electron-phonon coupling constant, lambda, for films of th
ickness 1-8 layers. A strong oscillatory variation in coupling strength is observed as a function of film thickness, peaking at a 2 layer film for which lambda~1. A simple theory incorporating interaction of the photo-hole with the thermal vibrations of the potential step at the adlayer-vacuum interface is shown to reproduce the main features of these results.
We report on the observation of metallic behavior in thin films of oxygen-deficient SrTiO$_3$ - down to 9 unit cells - when coherently strained on (001) SrTiO$_3$ or DyScO$_3$-buffered (001) SrTiO$_3$ substrates. These films have carrier concentratio
ns of up to 2$times10^{22}$ cm$^{-3}$ and mobilities of up to 19,000 cm$^2$/V-s at 2 K. There exists a non-conducting layer in our SrTiO$_{3-delta}$ films that is larger in films with lower carrier concentrations. This non-conducting layer can be attributed to a surface depletion layer due to a Fermi level pinning potential. The depletion width, transport, and structural properties are not greatly affected by the insertion of a DyScO$_3$ buffer between the SrTiO$_3$ film and SrTiO$_3$ substrate.
Control of thin film stoichiometry is of primary relevance to achieve desired functionality. Pulsed laser deposition ablating from binary-oxide targets (sequential deposition) can be applied to precisely control the film composition, offsetting the i
mportance of growth conditions on the film stoichiometry. In this work, we demonstrate that the cation stoichiometry of SrTiO$_3$ thin films can be finely tuned by sequential deposition from SrO and TiO$_2$ targets. Homoepitaxial SrTiO$_3$ films were deposited at different substrate temperatures and Ti/Sr pulse ratios, allowing the establishment of a growth window for stoichiometric SrTiO$_3$. The growth kinetics and nucleation processes were studied by reflection high-energy electron diffraction and atomic force microscopy, providing information about the growth mode and the degree of off-stoichiometry. At the optimal (stoichiometric) growth conditions, films exhibit atomically flat surfaces, whereas off-stoichiometry is accommodated by crystal defects, 3D islands and/or surface precipitates depending on the substrate temperature and the excess cation. This technique opens the way to precisely control stoichiometry and doping of oxide thin films.
We present a detailed low-energy muon spin rotation and x-ray magnetic circular dichroism (XMCD) investigation of the magnetic structure in ultra-thin tetragonal (T)-CuO films. The measured muon-spin polarization decay indicates an antiferromagnetic
(AFM) order with a transition temperature higher than 200K. The XMCD signal obtained around the Cu $L_{2,3}$ edges indicates the presence of pinned Cu$^{2+}$ moments that are parallel to the sample surface, and additionally, isotropic paramagnetic moments. The pinning of some of the Cu moments is caused by an AFM ordering consisting of moments that lie most likely in the plane of the film. Moreover, pinned moments show a larger orbital magnetic moment contribution with an approximate ratio of $m_{orb}/m_{spin} = 2$, indicating that these spins are located at sites with reduced symmetry. Some fractions of the pinned moments remain pinned from an AFM background even at 360K, indicating that $T_N >$ 360K. A simple model could explain qualitatively these experimental findings; however, it is in contrast to theoretical predictions, showing that the magnetic properties of ultra-thin T-CuO films differ from bulk expectations and is more complex.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
