اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدWavy-roughness effect to thermal explosion of materials with power-law thermal absorptivity in microannuli
262
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We obtain the approximate solutions for the steady temperature profiles of materials with a temperature-dependent thermal absorptivity inside a microannulus with wavy-rough surfaces considering a quasilinear partial differential equation by the boundary perturbation approach. We found the critical Frank-Kamanestkii parameter will depend on the small amplitude wavy-roughness.
قيم البحث
اقرأ أيضاً
We report on experimental investigation of thermal contact resistance of the noncuring graphene thermal interface materials with the surfaces characterized by different degree of roughness. It is found that the thermal contact resistance depends on t
he graphene loading non-monotonically, achieving its minimum at the loading fraction of ~15 wt.%. Increasing the surface roughness by ~1 micrometer results in approximately the factor of x2 increase in the thermal contact resistance for this graphene loading. The obtained dependences of the thermal conductivity, thermal contact resistance, and the total thermal resistance of the thermal interface material layer on the graphene loading and surface roughness indicate the need for optimization of the loading fraction for specific materials and roughness of the connecting surfaces. Our results are important for developing graphene technologies for thermal management of high-power-density electronics.
Various unusual behaviors of artificial materials are governed by their topological properties, among which the edge state at the boundary of a photonic or phononic lattice has been captivated as a popular notion. However, this remarkable bulk-bounda
ry correspondence and the related phenomena are missing in thermal materials. One reason is that heat diffusion is described in a non-Hermitian framework because of its dissipative nature. The other is that the relevant temperature field is mostly composed of modes that extend over wide ranges, making it difficult to be rendered within the tight-binding theory as commonly employed in wave physics. Here, we overcome the above challenges and perform systematic studies on heat diffusion in thermal lattices. Based on a continuum model, we introduce a state vector to link the Zak phase with the existence of the edge state, and thereby analytically prove the thermal bulk-boundary correspondence. We experimentally demonstrate the predicted edge states with a topologically protected and localized heat dissipation capacity. Our finding sets up a solid foundation to explore the topology in novel heat transfer manipulations.
We present a systematic investigation of the effects of roughness geometry on turbulent Rayleigh-Benard convection (RBC) over rough plates with pyramid-shaped and periodically distributed roughness elements. Using a parameter $lambda$ defined as the
height of a roughness element over its base width, the heat transport, the flow dynamics and local temperatures are measured for the Rayleigh number range $7.50times 10^{7} leq Raleq 1.31times 10^{11}$, and the Prandtl number $Pr$ from 3.57 to 23.34 at four values of $lambda$. It is found that the heat transport scaling, i.e. $Nusim Ra^{alpha}$ where $Nu$ is the Nusselt number, may be classified into three regimes. In Regime I, the system is in a dynamically smooth state. The heat transport scaling is the same as that in a smooth cell. In Regimes II and III, the heat transport enhances. When $lambda$ is increased from 0.5 to 4.0, $alpha$ increases from 0.36 to 0.59 in Regime II, and it increases from 0.30 to 0.50 in Regime III. The experiment demonstrates the heat transport scaling in turbulent RBC can be manipulated using $lambda$. Previous studies suggest that the transition from Regime I to Regime II, occurs when the thermal boundary layer (BL) thickness becomes smaller than the roughness height $h$. Direct measurements of the viscous BL in the present study suggest that the transition from Regime II to Regime III is likely a result of the viscous BL thickness becoming smaller $h$. The scaling exponent of the Reynolds number $Re$ vs. $Ra$ changes from 0.471 to 0.551 when $lambda$ is increased from 0.5 to 4.0. It is also found that increasing $lambda$ increases the clustering of thermal plumes which effectively increases the plumes lifetime that are ultimately responsible for the enhanced heat transport.
We investigate thermal rectification in a bulk material with a pyramid shape to elucidate shape dependence of the thermal rectification, and find that rectifying coefficient R is 1.35 for this shape, which is smaller than R=1.43 for a rectangular sha
pe. This result is fully duplicated by our numerical calculation based on Fouriers law. We also apply this calculation to a given shape, and show a possible way to increase R depending on the shape.
We show that the presumed wavy roughness distributed along the wall of different nanopores (radius : a around 3.5 nm for Vycor or a silica glass; around 245 nm for porous gold) will induce larger volume flow rates of solid helium (of which there is a
minimum) which might explain reported experimental differences of the supersolid fractions observed so far.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
