اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPrecise Wavefront Correction with an Unbalanced Nulling Interferometer for Exo-Planet Imaging Coronagraphs
107
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Very high dynamical range coronagraphs targeting direct exo-planet detection (10^9 - 10^10 contrast) at small angular separation (few lambda/D units) usually require an input wavefront quality on the order of ten thousandths of wavelength RMS. We propose a novel method based on a pre-optics setup that behaves partly as a low-efficiency coronagraph, and partly as a high-sensitivity wavefront aberration compensator (phase and amplitude). The combination of the two effects results in a highly accurate corrected wavefront. First, an (intensity-) unbalanced nulling interferometer (UNI) performs a rejection of part of the wavefront electric field. Then the recombined output wavefront has its input aberrations magnified. Because of the unbalanced recombination scheme, aberrations can be free of phase singular points (zeros) and can therefore be compensated by a downstream phase and amplitude correction (PAC) adaptive optics system, using two deformable mirrors. In the image plane, the central stars peak intensity and the noise level of its speckled halo are reduced by the UNI-PAC combination: the output-corrected wavefront aberrations can be interpreted as an improved compensation of the initial (eventually already corrected) incident wavefront aberrations. The important conclusion is that not all the elements in the optical setup using UNI-PAC need to reach the lambda/10000 rms surface error quality.
قيم البحث
اقرأ أيضاً
Following the tracks of Malbet, Yu, & Shao (1995} on dark hole algorithms, we present analytical methods to measure and correct the speckle noise behind an ideal coronagraph. We show that, in a low aberration regime, wavefront sensing can be accompli
shed with only three images, the next image being fully corrected (no iterative process needed). The only hardware required is the coronagraph deformable mirror and an imaging detector in the focal plane, thus there are no non-common path errors to correct. Our first method, speckle field nulling, is a fast FFT-based algorithm requiring the deformable mirror influence functions to have identical shapes. Our second method, speckle energy minimization is more general and based on matrix inversion. Numerical simulations show that these methods can improve the contrast by several orders of magnitude.
Direct imaging of exo-Earths and search for life is one of the most exciting and challenging objectives for future space observatories. Segmented apertures in space will be required to reach the needed large diameters beyond the capabilities of curre
nt or planned launch vehicles. These apertures present additional challenges for high-contrast coronagraphy, not only in terms of static phasing but also in terms of their stability. The Pair-based Analytical model for Segmented Telescope Imaging from Space (PASTIS) was developed to model the effects of segment-level optical aberrations on the final image contrast. In this paper, we extend the original PASTIS propagation model from a purely analytical to a semi-analytical method, in which we substitute the use of analytical images with numerically simulated images. The inversion of this model yields a set of orthonormal modes that can be used to determine segment-level wavefront tolerances. We present results in the case of segment-level piston error applied to the baseline coronagraph design of LUVOIR A, with minimum and maximum wavefront error constraint between 56 pm and 290 pm per segment. The analysis is readily generalizable to other segment-level aberrations modes, and can also be expanded to establish stability tolerances for these missions.
Two-photon interference of multimode two-photon pairs produced by an optical parametric oscillator has been observed for the first time with an unbalanced interferometer. The time correlation between the multimode two photons has a multi-peaked struc
ture. This property of the multimode two-photon state induces two-photon interference depending on delay time. The nonclassicality of this interference is also discussed.
The very large telescope (VLT) interferometer (VLTI) in its current operating state is equipped with high-order adaptive optics (MACAO) working in the visible spectrum. A low-order near-infrared wavefront sensor (IRIS) is available to measure non-com
mon path tilt aberrations downstream the high-order deformable mirror. For the next generation of VLTI instrumentation, in particular for the designated GRAVITY instrument, we have examined various designs of a four channel high-order near-infrared wavefront sensor. Particular objectives of our study were the specification of the near-infrared detector in combination with a standard wavefront sensing system. In this paper we present the preliminary design of a Shack-Hartmann wavefront sensor operating in the near-infrared wavelength range, which is capable of measuring the wavefronts of four telescopes simultaneously. We further present results of our design study, which aimed at providing a first instrumental concept for GRAVITY.
One of the long-term goals of exoplanet science is the (atmospheric) characterization of a large sample (>100) of terrestrial planets to assess their potential habitability and overall diversity. Hence, it is crucial to quantitatively evaluate and co
mpare the scientific return of various mission concepts. Here we discuss the exoplanet yield of a space-based mid-infrared (MIR) nulling interferometer. We use Monte-Carlo simulations, based on the observed planet population statistics from the Kepler mission, to quantify the number and properties of detectable exoplanets (incl. potentially habitable planets) and we compare the results to those for a large aperture optical/NIR space telescope. We investigate how changes in the underlying technical assumptions (sensitivity and spatial resolution) impact the results and discuss scientific aspects that influence the choice for the wavelength coverage and spectral resolution. Finally, we discuss the advantages of detecting exoplanets at MIR wavelengths, summarize the current status of some key technologies, and describe what is needed in terms of further technology development to pave the road for a space-based MIR nulling interferometer for exoplanet science.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
