ترغب بنشر مسار تعليمي؟ اضغط هنا

Coherent Quantum Control to Arbitrary Accuracy using the Uhrig Sequence of Ideal or Finite-Width $pi$-Pulses

343   0   0.0 ( 0 )
 نشر من قبل Deepak Dhar
 تاريخ النشر 2008
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

This paper has been withdrawn by the authors owing to a mistake in the proof of the basic lemma.

قيم البحث

اقرأ أيضاً

Single photons are the natural link between the nodes of a quantum network: they coherently propagate and interact with many types of quantum bits including natural and artificial atoms. Ideally, one atom should deterministically control the state of a photon and vice-versa. The interaction between free space photons and an atom is however intrinsically weak and many efforts have been dedicated to develop an efficient interface. Recently, it was shown that the propagation of light can be controlled by an atomic resonance coupled to a cavity or a single mode waveguide. Here we demonstrate that the state of a single artificial atom in a cavity can be efficiently controlled by a few-photon pulse. We study a quantum dot optimally coupled to an electrically-controlled cavity device, acting as a near optimal one-dimensional atom. By monitoring the exciton population through resonant fluorescence, we demonstrate Rabi oscillations with a $pi$-pulse of only 3.8 photons on average. The probability to flip the exciton quantum bit with a single photon Fock state is calculated to reach 55% in the same device.
192 - Xi Cao , Bing Chu , Haijin Ding 2018
In experimental control of quantum systems, the precision is often hindered by imperfect applied electronics that distort control pulses delivered to target quantum devices. To mitigate such error, the deconvolution method is commonly used for compen sating the distortion via an identified convolutional model. However, its effectiveness is limited by model inaccuracies (e.g., imprecise parameters or unmodeled distortion dynamics). In this paper, we propose a learning-based scheme to eliminate the residual calibration error by repeatedly applying the deconvolution operations. The resulting iterative deconvolution method is shown to be able to correct both linear and nonlinear model errors to the highest precision allowed by available finite sampling rates. The calibration error induced by finite sampling rates is also analyzed, from which we propose that the inter-sampling error can be suppressed by actively introducing nonlinear components in the control electronics.
Based on a recently developed notion of physical realizability for quantum linear stochastic systems, we formulate a quantum LQG optimal control problem for quantum linear stochastic systems where the controller itself may also be a quantum system an d the plant output signal can be fully quantum. Such a control scheme is often referred to in the quantum control literature as coherent feedback control. It distinguishes the present work from previous works on the quantum LQG problem where measurement is performed on the plant and the measurement signals are used as input to a fully classical controller with no quantum degrees of freedom. The difference in our formulation is the presence of additional non-linear and linear constraints on the coefficients of the sought after controller, rendering the problem as a type of constrained controller design problem. Due to the presence of these constraints our problem is inherently computationally hard and this also distinguishes it in an important way from the standard LQG problem. We propose a numerical procedure for solving this problem based on an alternating projections algorithm and, as initial demonstration of the feasibility of this approach, we provide fully quantum controller design examples in which numerical solutions to the problem were successfully obtained. For comparison, we also consider the case of classical linear controllers that use direct or indirect measurements, and show that there exists a fully quantum linear controller which offers an improvement in performance over the classical ones.
Feedback control is an essential component of many modern technologies and provides a key capability for emergent quantum technologies. We extend existing approaches of direct feedback control in which the controller applies a function directly propo rtional to the output signal (P feedback), to strategies in which feedback determined by an integrated output signal (I feedback), and to strategies in which feedback consists of a combination of P and I terms. The latter quantum PI feedback constitutes the analog of the widely used proportional-integral feedback of classical control. All of these strategies are experimentally feasible and require no complex state estimation. We apply the resulting formalism to two canonical quantum feedback control problems, namely, generation of an entangled state of two remote qubits, and stabilization of a harmonic oscillator under thermal noise under conditions of arbitrary measurement efficiency. These two problems allow analysis of the relative benefits of P, I, and PI feedback control. We find that for the two-qubit remote entanglement generation the best strategy can be a combined PI strategy when the measurement efficiency is less than one. In contrast, for harmonic state stabilization we find that P feedback shows the best performance when actuation of both position and momentum feedback is possible, while when only actuation of position is available, I feedback consistently shows the best performance, although feedback delay is shown to improve the performance of a P strategy here.
The key to optical analogy to a multi-particle quantum system is the scalable property. Optical elds modulated with pseudorandom phase sequences is an interesting solution. By utilizing the properties of pseudorandom sequences, mixing multiple optica l elds are distinguished by using coherent detection and correlation analysis that are mature methods in optical communication. In this paper, we utilize the methods to investigate optical analogies to multi-particle quantum states. In order to demonstrate the feasibility, numerical simulations are carried out in the paper, which is helpful to the experimental verication in the future.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا