اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe beam energy calibration system for the BEPC-II collider
110
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This document contains a proposal of the BEPC-II collider beam energy calibration system (IHEP, Beijing). The system is based on Compton backscattering of carbon dioxide laser radiation, producing a beam of high energy photons. Their energy spectrum is then accurately measured by HPGe detector. The high-energy spectrum edge will allow to determine the average electron or positron beam energy with relative accuracy about 3x10^-5.
قيم البحث
اقرأ أيضاً
The beam energy measurement system (BEMS) for the upgraded Beijing electron-positron collider BEPC-II is described. The system is based on measuring the energies of Compton back-scattered photons. The relative systematic uncertainty of the electron a
nd positron beam energy determination is estimated as 2 cdot 10^{-5}. The relative uncertainty of the beams energy spread is about 6 %.
We investigate the prospects of the search for a nonzero $tau$ EDM form factor $d_tau(s)$ in $tau$ pair production by $e^+ e^-$ collisions at BEPC-II collider energies. We compute the expectation values and covariances of simple and optimal $CP$-od
d observables for $tau$-pair production at $sqrt{s}=4.18$ GeV and $4.95$ GeV with subsequent decays of $tau^pm$ into major leptonic or semihadronic modes. For the $tau$ decays to two pions and three charged pions we take the full kinematic information of the hadronic system into account. Applying cuts and using realistic assumptions on the eventually attainable integrated luminosities at these energies, ${cal L}(4.18) = 3times 10^4~{rm pb}^{-1}$ and ${cal L}(4.95) = 10^4~{rm pb}^{-1}$, respectively, we find the following. By taking into account purely semihadronic and semihadronic-leptonic $tau^+tau^-$ decays one can achieve with optimal $CP$-odd observables the 1 s.d. sensitivities $delta {rm Re} d_tau = 4.5times 10^{-18}$ ecm ($5.3times 10^{-18}$ ecm) and $delta {rm Im} d_tau = 2.2 times 10^{-18}$ ecm ($2.7times 10^{-18}$ ecm) at $sqrt{s}=4.18$ GeV ($4.95$ GeV).
The beam energy measurement system for the VEPP-2000 electron-positron collider is described. The method of Compton backscattering of $CO$ laser photons on the electron beam is used. The relative systematic uncertainty of the beam energy determinatio
n is estimated as 6cdot10^{-5}. It was obtained through comparison of the results of the beam energy measurements using the Compton backscattering and resonance depolarization methods.
A beam optics scheme has been designed for the Future Circular Collider-e+e- (FCC-ee). The main characteristics of the design are: beam energy 45 to 175 GeV, 100 km circumference with two interaction points (IPs) per ring, horizontal crossing angle o
f 30 mrad at the IP and the crab-waist scheme [1] with local chromaticity correction. The crab-waist scheme is implemented within the local chromaticity correction system without additional sextupoles, by reducing the strength of one of the two sextupoles for vertical chromatic correction at each side of the IP. So-called tapering of the magnets is applied, which scales all fields of the magnets according to the local beam energy to compensate for the effect of synchrotron radiation (SR) loss along the ring. An asymmetric layout near the interaction region reduces the critical energy of SR photons on the incoming side of the IP to values below 100 keV, while matching the geometry to the beam line of the FCC proton collider (FCC-hh) [2] as closely as possible. Sufficient transverse/longitudinal dynamic aperture (DA) has been obtained, including major dynamical effects, to assure an adequate beam lifetime in the presence of beamstrahlung and top-up injection. In particular, a momentum acceptance larger than +/-2% has been obtained, which is better than the momentum acceptance of typical collider rings by about a factor of 2. The effects of the detector solenoids including their compensation elements are taken into account as well as synchrotron radiation in all magnets. The optics presented in this paper is a step toward a full conceptual design for the collider. A number of issues have been identified for further study.
253 -
L. I. Shekhtman
, V. I. Telnov (Institute of Nuclear Physics andn Novosibirsk State Univ.
, Novosibirsk
2014
Photon beams at photon colliders are very narrow, powerful (10--15 MW) and cannot be spread by fast magnets (because photons are neutral). No material can withstand such energy density. For the ILC-based photon collider, we suggest using a 150 m long
, pressurized (P ~ 4 atm) argon gas target in front of a water absorber which solves the overheating and mechanical stress problems. The neutron background at the interaction point is estimated and additionally suppressed using a 20 m long hydrogen gas target in front of the argon.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
