اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFlux dependent MeV self-ion- induced effects on Au nanostructures: Dramatic mass transport and nano-silicide formation
308
0
0.0
(
0
)
تأليف
J. Ghatak
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report a direct observation of dramatic mass transport due to 1.5 MeV Au2+ ion impact on isolated Au nanostructures of an average size 7.6 nm and a height 6.9 nm that are deposited on Si (111) substrate under high flux (3.2x10^10 to 6.3x10^12 ions cm-2 s-1) conditions. The mass transport from nanostructures found to extend up to a distance of about 60 nm into the substrate, much beyond their size. This forward mass transport is compared with the recoil implantation profiles using SRIM simulation. The observed anomalies with theory and simulations are discussed. At a given energy, the incident flux plays a major role in mass transport and its re-distribution. The mass transport is explained on the basis of thermal effects and creation of rapid diffusion paths at nano-scale regime during the course of ion irradiation. The unusual mass transport is found to be associated with the formation of gold silicide nanoalloys at sub-surfaces. The complexity of the ion-nanostructure interaction process has been discussed with a direct observation of melting (in the form of spherical fragments on the surface) phenomena. The transmission electron microscopy, scanning transmission electron microscopy and Rutherford backscattering spectroscopy methods have been used.
قيم البحث
اقرأ أيضاً
We discuss four important aspects of 1.5 MeV Au2+ ion-induced flux dependent sputtering from gold nanostrcutures (of an average size 7.6 nm and height 6.9 nm) that are deposited on silicon substrates: (a) Au sputtering yield at the ion flux of 6.3x10
^12 ions cm-2 s-1 is found to be 312 atoms/ion which is about five times the sputtering yield reported earlier under identical irradiation conditions at a lower beam flux of 10^9 ions cm-2 s-1, (b) the sputtered yield increases with increasing flux at lower fluence and reduces at higher fluence (1.0x10^15 ions cm-2) for nanostructured thin films while the sputtering yield increases with increasing flux and fluence for thick films (27.5 nm Au deposited on Si) (c) Size distribution of sputtered particles has been found to vary with the incident beam flux showing a bimodal distribution at higher flux and (d) the decay exponent obtained from the size distributions of sputtered particles showed an inverse power law dependence ranging from 1.5 to 2.5 as a function of incident beam flux. The exponent values have been compared with existing theoretical models to understand the underlying mechanism. The role of wafer temperature associated with the beam flux has been invoked for a qualitative understanding of the sputtering results in both the nanostructured thin films and thick films.
The self-polarization of PbZr0.52Ti0.48O3 thin film is switched by changing film thickness through the competition between the strain relaxation-induced flexoelectric fields and the interfacial effects. Without an applied electric field, this reversa
l of self-polarization is exploited to control the magnetic properties of La0.67Sr0.33MnO3 by the competition/cooperation between the charge-mediated and the strain-mediated effects. Scanning transmission electron microscopy, polarized near edge x-ray absorption spectroscopy, and half-integer diffraction measurements are employed to decode this intrinsic magnetoelectric effects in La0.67Sr0.33MnO3/PbZr0.52Ti0.48O3 heterostructures. With PbZr0.52Ti0.48O3 films < 48 nm, the self-polarization-driven carrier density modulation around La0.67Sr0.33MnO3/PbZr0.52Ti0.48O3 interface and the strain-mediated Mn 3d orbital occupancy work together to enhance magnetism of 14 unit cells La0.67Sr0.33MnO3 film; with PbZr0.52Ti0.48O3 layers > 48 nm, the strain-induced the change of bond length/angle of MnO6 accompanied with a modified spin configuration are responsible for the decrease in Curie temperature and magnetization of 14 unit cells La0.67Sr0.33MnO3 film.
Site-controlled quantum dots formed during the deposition of (Al)GaAs layers by metalorganic vapor-phase epitaxy on GaAs(111)B substrates patterned with inverted pyramids result in geometric and compositional self-ordering along the vertical axis of
the template. We describe a theoretical scheme that reproduces the experimentally-observed time-dependent behavior of this process, including the evolution of the recess and the increase of Ga incorporation along the base of the template to stationary values determined by alloy composition and other growth parameters. Our work clarifies the interplay between kinetics and geometry for the development of self-ordered nanostructures on patterned surfaces, which is essential for the reliable on-demand design of confined systems for applications to quantum optics.
We report formation of self organized InP nano dots using 3 keV Ar+ ion sputtering, at $15^circ$ incidence from surface normal, on InP(111) surface. Morphology and optical properties of the sputtered surface, as a function of sputtering time, have be
en investigated by Scanning Probe Microscopy and Raman Scattering techniques. Uniform patterns of nano dots are observed for different durations of sputtering. The sizes and the heights of these nano dots vary between 10 to 100 nm and 20 to 40 nm, respectively. With increasing of sputtering time, t, the size and height of these nano dots increases up to a certain sputtering time $t_c$. However beyond $t_c$, the dots break down into smaller nanostructures, and as a result, the size and height of these nanostructures decrease. The uniformity and regularity of these structures are also lost for sputtering beyond $t_c$. The crossover behavior is also observed in the rms surface roughness. Raman investigations of InP nano dots reveal optical phonon softening due to phonon confinement in the surface nano dots.
Irradiation effects in Ni-17Mo-7Cr alloy, which is an newly developed structural material for molten salt reactor (MSR), have been systematically investigated by using 3MeV Au ions at different fluences, corresponding to dpa number (displacement per
atom) of 1~ 30. GIXRD measurement indicates that the microstrain of the irradiated samples increased from 0.14% to 0.22% as dpa increased from 1 to 30. In the meanwhile, nanoindentation results reveal the Ni-17Mo-7Cr alloy underwent radiation-induced hardening first and then softening at dpa of 30. The swelling rate of Ni-17Mo-7Cr alloy was found around 1.3% at 30 dpa, which means only 0.04% per dpa. Besides, Raman spectra shows that carbon segregation appeared after Au ions irradiation. Our results are very helpful for understanding irradiation damages in Nickel-base alloys, especially for those in purpose of being used in future MSR nuclear energy system.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
