اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدStudies of self-organized Nanostructures on InP(111) surfaces after low energy Ar+ ion irradiation
123
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report formation of self organized InP nano dots using 3 keV Ar+ ion sputtering, at $15^circ$ incidence from surface normal, on InP(111) surface. Morphology and optical properties of the sputtered surface, as a function of sputtering time, have been investigated by Scanning Probe Microscopy and Raman Scattering techniques. Uniform patterns of nano dots are observed for different durations of sputtering. The sizes and the heights of these nano dots vary between 10 to 100 nm and 20 to 40 nm, respectively. With increasing of sputtering time, t, the size and height of these nano dots increases up to a certain sputtering time $t_c$. However beyond $t_c$, the dots break down into smaller nanostructures, and as a result, the size and height of these nanostructures decrease. The uniformity and regularity of these structures are also lost for sputtering beyond $t_c$. The crossover behavior is also observed in the rms surface roughness. Raman investigations of InP nano dots reveal optical phonon softening due to phonon confinement in the surface nano dots.
قيم البحث
اقرأ أيضاً
Regular arrays of InP nano pillars have been fabricated by low energy Electron Cyclotron Resonance (ECR) Ar+ ion irradiation on InP(111) surface. Several scanning electron microscopy (SEM) images have been utilized to invetsigate the width, height, a
nd orientation of these nano pillars on InP(111) surfaces. The average width and length of these nano-pillars are about 50 nm and 500 nm, respectively. The standing angle with respect to the surface of the nano-pillars depend on the incidence angle of the Ar ion irradiation during the fabrication process. Interestingly, the growth direction of the nano pillars are along the reflection direction of the ion beam and the standing angles are nearly same as the ion incidence angle with the surface normal. This nano-pillas are easily transferred from the InP surface to double sided carbon tape without any damage. High Resolution Transmission Electron Microscopy (HRTEM) study of single nano-pillar reveals that this nano-pillar are almost crystalline in nature except 2-4 nm amorphous layer on the outer surface. The transmission electron microscopy combined with energy-dispersive x-ray spectroscopy (TEM-EDS) analysis of these nano pillars exhibit that the ratio of In and P is little higher compared to the bulk InP.
We have studied the surface modifications as well as the surface roughness of the InP(111) surfaces after 1.5 MeV Sb ion implantations. Scanning Probe Microscope (SPM) has been utilized to investigate the ion implanted InP(111) surfaces. We observe t
he formation of nanoscale defect structures on the InP surface. The density, height and size of the nanostructures have been investigated here as a function of ion fluence. The rms surface roughness, of the ion implanted InP surfaces, demonstrates two varied behaviors as a function of Sb ion fluence. Initially, the roughness increases with increasing fluence. However, after a critical fluence the roughness decreases with increasing fluence. We have further applied the technique of Raman scattering to investigate the implantation induced modifications and disorder in InP. Raman Scattering results demonstrate that at the critical fluence, where the decrease in surface roughness occurs, InP lattice becomes amorphous.
Coherent grazing-incidence small-angle X-ray scattering is used to investigate the average kinetics and the fluctuation dynamics during self-organized nanopatterning of silicon by Ar$^+$ bombardment at 65$^{circ}$ polar angle. At early times, the sur
face behavior can be understood within the framework of linear theory. The transition away from the linear theory behavior is observed in the dynamics through the intensity correlation function. It quickly evolves to exhibit stretched exponential decay on short length scales and compressed exponential decay on length scales corresponding the dominant structural length scale - the ripple wavelength. The correlation times also peak strongly at the ripple length scale. This behavior has notable similarities but also significant differences with the phenomenon of de Gennes narrowing. Overall, this dynamics behavior is found to be consistent with simulations of a nonlinear growth model.
Site-controlled quantum dots formed during the deposition of (Al)GaAs layers by metalorganic vapor-phase epitaxy on GaAs(111)B substrates patterned with inverted pyramids result in geometric and compositional self-ordering along the vertical axis of
the template. We describe a theoretical scheme that reproduces the experimentally-observed time-dependent behavior of this process, including the evolution of the recess and the increase of Ga incorporation along the base of the template to stationary values determined by alloy composition and other growth parameters. Our work clarifies the interplay between kinetics and geometry for the development of self-ordered nanostructures on patterned surfaces, which is essential for the reliable on-demand design of confined systems for applications to quantum optics.
We have studied the modification in the Surface morphology of the Si(100) surfaces after 1.5 MeV Sb implantation. Scanning Probe Microscopy has been utilized to investigate the ion implanted surfaces. We observe the formation of nano-sized defect fea
tures on the Si surfaces for various fluences. These nanostructures are elliptical in shape and inflate in sizefor higher fluences. Furthermore, these nanostructures undergo a shape transition from an elliptical shape to a circular-like at a high fluence. We will also discuss the modification in surface roughness as a function of Sb fluence.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
