اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدWet Sand flows better than dry sand
71
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigated the yield stress and the apparent viscosity of sand with and without small amounts of liquid. By pushing the sand through a tube with an enforced Poiseuille like profile we minimize the effect of avalanches and shear localization. We find that the system starts to flow when a critical shear of the order of one particle diameter is exceeded. In contrast to common believe, we observe that the resistance against the flow of wet sand is much smaller than that of dry sand. For the dissipative flow we propose a non-equilibrium state equation for granular fluids.
قيم البحث
اقرأ أيضاً
Sand electrification is important for aeolian sediment transportation on terrestrial bodies with silicate sand as the main sediment composition. However, it has not been thoroughly studied for icy bodies such as Titan with organic sand as the main du
ne-forming material. We used the colloidal probe atomic force microscopy (AFM) technique to study triboelectric charging processes using Titan and Earth sand analogs. We found that it is easy to generate triboelectric charges between naphthalene (a simple aromatic hydrocarbon), polystyrene (an aromatic hydrocarbon polymer), and borosilicate glass (Earth silicate sand analog). Strong electrostatic forces can be measured after contact and/or tribocharging. In contrast, tholin, a complex organic material, does not generate any detectable electrostatic forces with contact or tribocharging within the detection limit of the instrument. If Titan sand behaves more like tholin, this indicates that the tribocharging capacity of Titan sand is much weaker than Earth silicate sand and much less than previously measured by Mendez-Harper et al., (2017), where only simple organics were used for Titan sand analogs. Thus, triboelectrification may not contribute to increasing interparticle forces between sand particles on Titan as much as on Earth. Interparticle forces generated by other electrostatic processes or other interparticle forces such as van der Waals and capillary cohesion forces could be the dominant interparticle forces that govern Titan sand formation and sediment transportation on the surface. Titan sand is also unlikely to produce large electrical discharge through tribocharging to affect future missions to Titans surface.
The stress-dilatancy relation is of critical importance for constitutive modelling of sand. A new fractional-order stress-dilatancy equation is analytically developed in this study, based on stress-fractional operators. An apparent linear response of
the stress-dilatancy behaviour of soil after sufficient shearing is obtained. As the fractional order varies, the derived stress-dilatancy curve and the associated phase transformation state stress ratio shift. But, unlike existing researches, no other specific parameters, except the fractional order, concerning such shift and the state-dependence are required. The developed stress-dilatancy equation is then incorporated into an existing constitutive model for validation. Test results of different sands are simulated and compared, where a good model performance is observed.
We report an experimental study of a binary sand bed under an oscillating water flow. The formation and evolution of ripples is observed. The appearance of a granular segregation is shown to strongly depend on the sand bed preparation. The initial wa
velength of the mixture is measured. In the final steady state, a segregation in volume is observed instead of a segregation at the surface as reported before. The correlation between this phenomenon and the fluid flow is emphasised. Finally, different ``exotic patterns and their geophysical implications are presented.
A two state sandpile model with preferential sand distribution is developed and studied numerically on scale free networks with power-law degree ($k$) distribution, {em i.e.}: $P_ksim k^{-alpha}$. In this model, upon toppling of a critical node sand
grains are given one to each of the neighbouring nodes with highest and lowest degrees instead of two randomly selected neighbouring nodes as in a stochastic sandpile model. The critical behaviour of the model is determined by characterizing various avalanche properties at the steady state varying the network structure from scale free to random, tuning $alpha$ from $2$ to $5$. The model exhibits mean field scaling on the random networks, $alpha>4$. However, in the scale free regime, $2<alpha<4$, the scaling behaviour of the model not only deviates from the mean-field scaling but also the exponents describing the scaling behaviour are found to decrease continuously as $alpha$ decreases. In this regime, the critical exponents of the present model are found to be different from those of the two state stochastic sandpile model on similar networks. The preferential sand distribution thus has non-trivial effects on the sandpile dynamics which leads the model to a new universality class.
We relate the breakdown of equations of states for the mechanical pressure of generic dry active systems to the lack of momentum conservation in such systems. We show how sources and sinks of momentum arise generically close to confining walls. These
typically depend on the interactions of the container with the particles, which makes the mechanical pressure a container-dependent quantity. We show that an equation of state is recovered if the dynamics of the orientation of active particles are decoupled from other degrees of freedom and lead to an apolar bulk steady-state. This is related to the fact that the mean steady-state active force density is the divergence of the flux of active impulse, an observable which measures the mean momentum particles will receive from the substrate in the future.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
